scholarly journals A New Virtual Synchronous Generator Design Based on the SMES System for Frequency Stability of Low-Inertia Power Grids

Energies ◽  
2020 ◽  
Vol 13 (21) ◽  
pp. 5641
Author(s):  
Gaber Magdy ◽  
Abualkasim Bakeer ◽  
Morsy Nour ◽  
Eduard Petlenkov

In light of the challenges of integrating more renewable energy sources (RESs) into the utility grid, the virtual synchronous generator (VSG) will become an indispensable configuration of modern power systems. RESs are gradually replacing the conventional synchronous generators that are responsible for supplying the utility grid with the inertia damping properties, thus renewable power grids are more vulnerable to disruption than traditional power grids. Therefore, the VSG is presented to mimic the behavior of a real synchronous generator in the power grid through the virtual rotor concept (i.e., which emulates the properties of inertia and damping) and virtual primary and secondary controls (i.e., which emulate the conventional frequency control loops). However, inadequate imitation of the inertia power owing to the low and short-term power of the energy storage systems (ESSs) may cause system instability and fail dramatically. To overcome this issue, this paper proposes a VSG based on superconducting magnetic energy storage (SMES) technology to emulate the needed inertia power in a short time and thus stabilizing the system frequency at different disturbances. The proposed VSG based on SMES is applied to improve the frequency stability of a real hybrid power grid, Egyptian Power System (EPS), with high renewables penetration levels, nonlinearities, and uncertainties. The performance superiority of the proposed VSG-based SMES is validated by comparing it with the traditional VSG approach based on battery ESSs. The simulation results demonstrated that the proposed VSG based on the SMES system could significantly promote ultra-low-inertia renewable power systems for several contingencies.

2017 ◽  
Vol 65 (5) ◽  
pp. 579-588
Author(s):  
A. Domino ◽  
K. Zymmer ◽  
M. Parchomiuk

Abstract The paper presents different solutions applicable in power converter systems for connecting power grids with energy storage systems such as superconducting magnetic energy storage (SMES), supercapacitor energy storage (SES) or chemical batteries. Those systems are characterized by bidirectional current flow between energy storage and power grid. Two-level converters (AC-DC and DC-AC converters) dedicated for low power energy storage compatible with 3×400 V-type power grids are proposed. High power systems are connected with 3×6 kV-type power grids via transformers that adjust voltage to the particular energy storage or directly, based on multilevel power converters (AC-DC and DC-AC) or dual active bridge (DAB) systems. Solutions ensuring power grid compatibility with several energy storage systems of the same electrical parameters as well as of different voltage-current characteristics are also proposed. Selected simulation results illustrating operation of two system topologies of 200 kW power for two-level converter and neutral point clamped (NPC) three-level converter are presented.


Energies ◽  
2020 ◽  
Vol 13 (9) ◽  
pp. 2222 ◽  
Author(s):  
Wojciech Kosman ◽  
Andrzej Rusin

The paper presents technical solutions for a power grid that undergoes the elimination of a significant number of coal-based power generating units. The purpose of the solutions is to adapt the existing machines with sufficient lifespans to the new operating conditions. In particular these include steam turbines. The steam turbines’ cycles may be extended with energy storage systems based on a molten salt. This allows to increase the flexibility of the power generating units while maintaining the largest possible efficiency of the power generation. The solutions presented here allow to connect the steam turbines cycles to renewable energy sources and reduce the overall number of the units that create the fundamental layer of the power grid. The analysis of the solutions involves numerical modeling. The paper describes the assumptions and the results of the modeling for chosen cases of the modernization. The researched considered a number of options that differed in the investment costs and the resulting performance.


2021 ◽  
Vol 20 (4) ◽  
pp. 118-126
Author(s):  
Md. Kamrul Islam ◽  
Mohammad Abdul Mannan ◽  
Md. Rifat Hazari

Due to the extensive integration of renewable energy sources (RESs), i.e., photovoltaic (PV) system, the future power system is developing into an inverter-based system from a dominated alternator-based power system. This massive penetration of inverter-based PV system reduced the system inertia and damping characteristics of the power grid, impacting the fault ride-through (FRT) capability and causes frequency instability. Modern grid codes require that PV systems should work in the same way as conventional power plants and assist the system during transient state. However, most of the conventional inverter control mechanisms failed to fulfill the requirements of grid codes, especially when the penetration ratio of the PV system is close to the conventional unit. Therefore, this paper proposes a virtual synchronous generator (VSG) control mechanism of PV system inverter to augment FRT competency and frequency stability. The proposed VSG control system mimics the behavior of conventional power plants. To observe and evaluate the proposed controller behavior, simulation analyses were executed in the PSCAD/EMTDC software for both proposed and conventional controllers. The simulation results clearly indicate that the proposed VSG control system has sufficient damping characteristics to ensure FRT capability and frequency stability.       


2021 ◽  
Author(s):  
Guilherme Penha da Silva Júnior ◽  
Thiago Figueiredo do Nascimento ◽  
Luciano Sales Barros

The high integration of distributed generation (DG) system based on renewable energy sources (RES) in the power system requires changes regarding the control mode of these sources with some urgency. Such changes seek to maintain the stability of the power systems. Thus, there is a demand for using control techniques on DGs/RESs that can mitigate the disturbances caused by low inertia and the lack of control over the dispatched powers. As a solution, one can use virtual synchronous generator (VSG) techniques making the voltage  source inverter (VSI) control behave similarly to the traditional synchronous generator (SG). This paper presents a literature review and performance tests for the main VSG topologies used in DGs/RESs: ISE, VSYNC, VISMA and Synchronverter. The implementation of VSG in the DGs/RESs has made possible increase inertia in the grid and, additionally regulate the active and reactive powers separately and bidirectionally. So, it has been possible to meet power system requirements; being able to operation both grid-connected or island-mode, which is ideal for microgrids. The results obtained confirm the literature reports. It was observed that the Synchronverter topology presented advantages over the other VSG topologies.


Electronics ◽  
2021 ◽  
Vol 10 (2) ◽  
pp. 115
Author(s):  
Nasser Hosseinzadeh ◽  
Asma Aziz ◽  
Apel Mahmud ◽  
Ameen Gargoom ◽  
Mahbub Rabbani

The main purpose of developing microgrids (MGs) is to facilitate the integration of renewable energy sources (RESs) into the power grid. RESs are normally connected to the grid via power electronic inverters. As various types of RESs are increasingly being connected to the electrical power grid, power systems of the near future will have more inverter-based generators (IBGs) instead of synchronous machines. Since IBGs have significant differences in their characteristics compared to synchronous generators (SGs), particularly concerning their inertia and capability to provide reactive power, their impacts on the system dynamics are different compared to SGs. In particular, system stability analysis will require new approaches. As such, research is currently being conducted on the stability of power systems with the inclusion of IBGs. This review article is intended to be a preface to the Special Issue on Voltage Stability of Microgrids in Power Systems. It presents a comprehensive review of the literature on voltage stability of power systems with a relatively high percentage of IBGs in the generation mix of the system. As the research is developing rapidly in this field, it is understood that by the time that this article is published, and further in the future, there will be many more new developments in this area. Certainly, other articles in this special issue will highlight some other important aspects of the voltage stability of microgrids.


Author(s):  
Omar J Guerra ◽  
Joshua Eichman ◽  
Paul Denholm

Achieving 100% carbon-free or renewable power systems can be facilitated by the deployment of energy storage technologies at all timescales, including short-duration, long-duration, and seasonal scales; however, most current literature...


Energies ◽  
2021 ◽  
Vol 14 (12) ◽  
pp. 3680
Author(s):  
Lasantha Meegahapola ◽  
Siqi Bu

Power network operators are rapidly incorporating wind power generation into their power grids to meet the widely accepted carbon neutrality targets and facilitate the transition from conventional fossil-fuel energy sources to the clean and low-carbon renewable energy sources [...]


2021 ◽  
Author(s):  
THIAGO FIGUEIREDO DO NASCIMENTO ◽  
ANDRES ORTIZ SALAZAR

The integration of distributed generation (DG) systems based on renewable energy sources (RES) by using power converters is an emerging technology in modern power systems. Among the control strategies applied to this new configuration, the virtual synchronous generator (VSG) approach has proven to be an attractive solution due providing suitable dynamic performance. Thus, this paper presents a dynamic analysis of gridtied converters controlled by using VSG concept. This analysis is based on a dynamic model that describes the DG power flow transient characteristics. Based on this model, the grid impedance parameters variation effects on the VSG controllers dynamic performance are discussed. Simulation results are presented to evaluate the effectiveness of the theoretical analysis performed.


Sign in / Sign up

Export Citation Format

Share Document