scholarly journals A New Polarization-Reconfigurable Antenna for 5G Applications

Electronics ◽  
2018 ◽  
Vol 7 (11) ◽  
pp. 293 ◽  
Author(s):  
Yasir Al-Yasir ◽  
Abdulkareem Abdullah ◽  
Naser Ojaroudi Parchin ◽  
Raed Abd-Alhameed ◽  
James Noras

This paper presented a new circular polarization reconfigurable antenna for 5G wireless communications. The antenna, containing a semicircular slot, was compact in size and had a good axial ratio and frequency response. Two PIN diode switches controlled the reconfiguration for both the right-hand and left-hand circular polarization. Reconfigurable orthogonal polarizations were achieved by changing the states of the two PIN diode switches, and the reflection coefficient |S11| was maintained, which is a strong benefit of this design. The proposed polarization-reconfigurable antenna was modeled using the Computer Simulation Technology (CST) software. It had a 3.4 GHz resonance frequency in both states of reconfiguration, with a good axial ratio below 1.8 dB, and good gain of 4.8 dBic for both modes of operation. The proposed microstrip antenna was fabricated on an FR-4 substrate with a loss tangent of 0.02, and relative dielectric constant of 4.3. The radiating layer had a maximum size of 18.3 × 18.3 mm2, with 50 Ω coaxial probe feeding.

2017 ◽  
Vol 9 (8) ◽  
pp. 1695-1703
Author(s):  
Haixiong Li ◽  
Yunlong Gong ◽  
Jiakai Zhang ◽  
Jun Ding ◽  
Chenjiang Guo

In this paper, a coplanar waveguide (CPW)-fed dual-band uniplanar tri-polarization reconfigurable antenna based on the PIN diode switch is proposed. The proposed antenna can be reconfigured between the linear polarization (LP) and the circular polarization (CP) mode, including both the right-handed circular polarization and left-handed circular polarization simultaneously within the dual operating bands. The central frequencies of the bands are 2.63 and 4.42 GHz, respectively, and the overlapped operating bandwidth is 17.8 and 3.40%. The proposed reconfigurable antenna is a closed-slot antenna fed by the CPW transmission line and the reconfigurable mechanism is to regulate the T-shaped driven stub through switching the PIN diodes on and off. The scattering parameters, axial ratio, radiation pattern, gain, and the radiation efficiency of the proposed antenna are all investigated in the following. The optimized antenna has been fabricated to experimental test, the simulated and the measured results agree well with each other. The lower frequency band of the proposed antenna covers the 2.40 GHz WLAN specification and the upper band can be used for the 5 G communication (4.40–4.50 GHz); therefore it is suitable to be applied in the mobile wireless communication.


Author(s):  
Alaa Imran AL-Muttairi ◽  
Malik Jasim Farhan

In this paper, a novel low cost, single-feed, and circular polarization reconfigurable antenna is designed and fabricated for future mid-band 5G applications. An innovative technique is used in this approach, which combines three techniques, namely: polygon U-slot, switchable vertical or horizontal slots, and shorting posts. The proposed antenna can alter its polarization sense between RHCP and LHCP with the ability to adjust the axial ratio position with respect to frequency along the impedance bandwidth of the antenna. The antenna is built on RT/duroid 5880 substrate with a maximum size of (31*31*3.15) .Two real diodes are integrated across the slot to change polarization sense. CST commercial software is used to simulate the antenna, and then it is fabricated and measured practically. Good agreements between the two results are achieved. However, The antenna has impedance bandwidth starting from 3.4995GHz to 3.73GHz with overlapped axial ratio bandwidth of 2.1% for both operation senses. Also, the antenna has good gain, and it has one resonant frequency at 3.6GHz for both operating states.


2016 ◽  
Vol 9 (4) ◽  
pp. 843-850 ◽  
Author(s):  
Dinesh Kumar Singh ◽  
Binod Kumar Kanaujia ◽  
Santanu Dwari ◽  
Ganga Prasad Pandey ◽  
Sandeep Kumar

The design and measurement of reconfigurable circularly polarized capacitive fed microstrip antenna are presented. Small isosceles right angle triangular sections are removed from diagonally opposite corners for the generation of circular polarization (CP) of axial ratio bandwidth of 11.1%. Horizontal slits of different lengths are inserted at the edges of the truncated patch to provide the dual-band CP and by switching PIN diodes across the slits ON and OFF, reconfigurable circularly polarized antenna is realized. The antenna shows dual-band behavior with reconfigurable CP. In order to enhance the operation bandwidth of the antenna, an inclined slot was embedded on the patch along with PIN diodes across the horizontal slits. This proposed antenna gave an impedance bandwidth of 66.61% (ON state) ranging from 4.42 to 8.80 GHz and 68.42% (OFF state) ranging from 4.12 to 8.91 GHz and exhibits dual-frequency CP with PIN diode in OFF state and single-frequency CP with PIN diode in ON state with good axial ratio bandwidth. The axial ratio bandwidth of 4.42, 2.35, and 2.72% is obtained from the antenna. The antenna has a similar radiation pattern in all the three different CP bands and almost constant gain within the bands of CP operation.


Author(s):  
Muhammad Fauzan Edy Purnomo ◽  
Vita Kusumasari ◽  
Rudy Yuwono ◽  
Rahmadwati Rahmadwati ◽  
Rakhmad Romadhoni ◽  
...  

<span>In this paper, we acquire the configuration of the left-hand circular polarization (LHCP) array four patches stack triangular truncated microstrip antenna. This construction use the basic corporate feed microstrip-line with modified lossless T-junction power divider on radiating patch for circularly polarized-synthetic aperture radar (CP-SAR) sensor embedded on unmanned aerial vehicle (UAV) with compact, small, and simple configuration. The design of circular polarization (CP) is realized by truncating the whole three tips and adjusting the parameters of antenna at the target frequency, <em>f </em>= 5.2 GHz. The results of characteristic performance and <em>S</em>-parameter for the LHCP array four patches stack antenna at the target frequency show successively about 9.74 dBic of gain, 2.89 dB of axial ratio (<em>Ar</em>), and </span><span>-</span><span>10.91 dB of S-parameter. Moreover, the impedance bandwidth and the 3 dB-<em>Ar</em> bandwidth of this antenna are around 410 MHz (7.89%) and 100 MHz (1.92%), respectively.</span>


2019 ◽  
Vol 2019 ◽  
pp. 1-7
Author(s):  
Mingyu Sun ◽  
Zhe Zhang ◽  
Kang An ◽  
Xianghui Wang ◽  
Yuezhi Jiang ◽  
...  

A novel circular polarization (CP) reconfigurable microstrip antenna is presented. The CP reconfigurable antenna is divided into three layers, composed of an annular radiating patch, ring slot, and reconfigurable orthogonal network (RON). The designed antenna is fed by dual vertical branches at the output port of the RON. By adjusting the bias voltage of the PIN switch loaded on the reconfigurable orthogonal network, the output phase can be changed, which means that the polarization direction of CP antenna is switchable. Simulation results show that the proposed feeding network provides constant phase difference and lower insertion loss for both states in the operating frequency band, thereby achieving good match and axial ratio characteristics either LHCP or RHCP state. Measured results show that the proposed antenna exhibits operational bandwidth of 1.2% with axial ratio below 3 dB and return loss above 10 dB in both polarized states. Good agreement between simulated and measured results is obtained.


2018 ◽  
Vol 7 (4) ◽  
pp. 103-108 ◽  
Author(s):  
M. Saravanan ◽  
M. J. S. Rangachar

In this paper, a single fed polarization reconfigurable antenna is proposed. The antenna consists of a radiating patch incorporated with a diagonal-shaped slot at its center. Four p-i-n diodes are used for polarization reconfiguration. The p-i-n diodes are placed in diagonal slot region. The proposed antenna is designed to operate in three states – linear polarization (LP), left-hand circular polarization (LHCP) and right-hand circular polarization (RHCP) by biasing corresponding p-i-n diodes. The antenna gives measured peak gain of 6.2 dBi for LP state and 5.82 dBic for both RHCP and LHCP states. It also achieves 3-dB axial ratio bandwidth of 5.95% for both RHCP and LHCP configurations. The antenna finds application in areas of modern wireless communication.


2016 ◽  
Vol 2016 ◽  
pp. 1-7 ◽  
Author(s):  
Yun Zhou ◽  
Shaojun Fang ◽  
Hongmei Liu ◽  
Shiqiang Fu

A novel polarization-reconfigurable conical helical antenna based on the liquid metal is presented. The antenna is implemented by using truncated structure, variable pitch angle, a matching stub, and a mechanical autorotation device. The experimental results show that a good agreement between simulations and measurements is obtained. The gain of the antenna achieves higher than 8 dBi in the work band (1525–1660.5 MHz), and the 3 dB axial ratio (AR) bandwidth reaches 410 MHz. The polarization mode of the antenna can be switched between right-hand and left-hand circular polarization.


2018 ◽  
Author(s):  
Yohandri

A circularly polarized microstrip antenna for bi-static SAR onboard UAV has been investigated. The both senseof the circular polarization left-hand circularly polarized (LHCP) and right-hand circularly polarized (RHCP) arecan be achieved on experimental and simulation. The 2x2 sub array antenna operated in 1.176 (L-band) withnovel proximity synchronous feed method has been designed, fabricated, and evaluated to show the characteristic of the antenna. The measured result give the axial ratio bandwidth (&lt;3dB) of about 28 MHz (2%), whichconsistent with the simulated result of about 27 MHz (2%). These results satisfy the specification for our BiSARsystem installed onboard UAV.


Frequenz ◽  
2019 ◽  
Vol 73 (5-6) ◽  
pp. 153-159
Author(s):  
Zhuo Mu ◽  
Shen-Yun Wang ◽  
Wen-Ying Meng

Abstract This paper reports a novel polarization-reconfigurable antenna array based on the theory of mode combination (MC), which can electronically alter its polarization states between left-hand circular polarization (LCP) mode, right-hand circular polarization (RCP) mode, and two combined linear polarization (LP) modes. The array element is adopted as the L-probes fed circularly-polarized antenna reported by Luk et al. [1]. To verify the concept, a prototype of 2×2 antenna array is manufactured and tested. By properly exciting the feeding probes, four polarization modes can be switchable. Measurement results show that the proposed antenna has an overlapped −10 dB impedance bandwidth around 34 % for both CP modes and LP(2) mode, and an overlapped 3 dB axial-ratio bandwidth around 22.0 % of the CP modes. The average realized gains are around 12.4 dB for CP modes and LP(1) mode, which remain stable in the axial-ratio bandwidth.


2021 ◽  
Vol 10 (1) ◽  
pp. 200-207
Author(s):  
Muhammad Fauzan Edy Purnomo ◽  
Vita Kusumasari ◽  
Rusmi Ambarwati ◽  
Sigit Kusmaryanto ◽  
Sholeh Hadi Pramono ◽  
...  

In this paper, we obtain the basic configuration of the left-hand circular polarization (LHCP) array two patches stack triangular truncated microstrip antenna. This construction use the basic corporate feed microstrip-line with modified lossless T-junction power divider on radiating patch for circularly polarized-synthetic aperture radar (CP-SAR) sensor embedded on airspace with compact, small, and simple configuration. The design of Circular Polarization (CP) is realized by truncating the whole three tips and adjusting the parameters of antenna at the resonant frequency, f=5.2 GHz. The results of characteristic performance and S-parameter for the LHCP array two patches stack antenna at the resonant frequency show successively about 7.24 dBic of gain, 1.99 dB of axial ratio (Ar), and -11.43 dB of S-parameter. Moreover, the impedance bandwidth and the 3 dB-Ar bandwidth of this antenna are around 560 MHz (10.77%) and 50 MHz (0.96%), respectively.


Sign in / Sign up

Export Citation Format

Share Document