scholarly journals Effect of Rare Earth Elements on Stability and Sintering Resistance of Tetragonal Zirconia for Advanced Thermal Barrier Coatings

Crystals ◽  
2021 ◽  
Vol 11 (3) ◽  
pp. 287
Author(s):  
Hao Yi ◽  
Junwei Che ◽  
Gongying Liang ◽  
Xiangyang Liu

The effect of dopant species on the sintering resistance of zirconia-based ceramics remains a huge challenge in terms of both experiment and theory. As one of the most popular materials for high-temperature protective coatings, it is still urgent to obtain rare earth-doped ZrO2 with high sintering resistance and good phase stability. Here, the sintering resistance and phase stability of rare earth oxides (La2O3, Nd2O3, Gd2O3, and Y2O3)-stabilized zirconia (ZrO2) were thoroughly studied by theoretical and experimental methods. According to experimental data, ZrO2 doped with rare earth ions with larger radii (La3+, Nd3+, and Gd3+) exhibited improved sintering resistance at reduced tetragonal phase stability. Molecular dynamics simulation results revealed that rare earth ions with larger ionic radii are prone to segregation at grain boundaries, which can more effectively reduce the grain boundary energy in the materials under consideration. Therefore, the proposed approach involving doping of NdO1.5 (~1 mol%) and YO1.5 (YbO1.5, 6 mol%) in ZrO2 is considered to be a promising route for the effective preparation of sinter-resistant ZrO2-based ceramics for refractory and thermal barrier materials.

2008 ◽  
Vol 388 ◽  
pp. 269-272 ◽  
Author(s):  
Takashi Oyama ◽  
Nobuyuki Wada ◽  
Yukio Sakabe

Atomistic mechanisms that restrain diffusion of oxygen vacancies in BaTiO3 doped with rare earth ions as donors were analyzed using molecular dynamics simulation. It was confirmed that formation of cation vacancies and reduction of lattice volume are sources of resistance for the diffusion. The cation vacancies trap the oxygen vacancies at the nearby O2- sites by an attractive force associated with Coulombic interaction. In contrast, the rare earth ions repel the oxygen vacancies, which migrate via O2- sites, and accelerate the diffusion. This is one of the factors that determine the restraint behavior of the diffusion, which depends on the type of rare earth ion in BaTiO3-based materials.


Author(s):  
N. M. P. Low ◽  
L. E. Brosselard

There has been considerable interest over the past several years in materials capable of converting infrared radiation to visible light by means of sequential excitation in two or more steps. Several rare-earth trifluorides (LaF3, YF3, GdF3, and LuF3) containing a small amount of other trivalent rare-earth ions (Yb3+ and Er3+, or Ho3+, or Tm3+) have been found to exhibit such phenomenon. The methods of preparation of these rare-earth fluorides in the crystalline solid form generally involve a co-precipitation process and a subsequent solid state reaction at elevated temperatures. This investigation was undertaken to examine the morphological features of both the precipitated and the thermally treated fluoride powders by both transmission and scanning electron microscopy.Rare-earth oxides of stoichiometric composition were dissolved in nitric acid and the mixed rare-earth fluoride was then coprecipitated out as fine granules by the addition of excess hydrofluoric acid. The precipitated rare-earth fluorides were washed with water, separated from the aqueous solution, and oven-dried.


2020 ◽  
Vol 10 (2) ◽  
pp. 152-156 ◽  
Author(s):  
Muhammad Hanif bin Zahari ◽  
Beh Hoe Guan ◽  
Lee Kean Chuan ◽  
Afiq Azri bin Zainudin

Background: Rare earth materials are known for its salient electrical insulation properties with high values of electrical resistivity. It is expected that the substitution of rare earth ions into spinel ferrites could significantly alter its magnetic properties. In this work, the effect of the addition of Samarium ions on the structural, morphological and magnetic properties of Ni0.5Zn0.5SmxFe2-xO4 (x=0.00, 0.02, 0.04, 0.06, 0.08, 0.10) synthesized using sol-gel auto combustion technique was investigated. Methods: A series of Samarium-substituted Ni-Zn ferrite nanoparticles (Ni0.5Zn0.5SmxFe2-xO4 where x=0.00, 0.02, 0.04, 0.06, 0.08, 0.10) were synthesized by sol-gel auto-combustion technique. Structural, morphological and magnetic properties of the samples were examined through X-Ray Diffraction (XRD), Field-Emission Scanning Electron Microscope (FESEM) and Vibrating Sample Magnetometer (VSM) measurements. Results: XRD patterns revealed single-phased samples with spinel cubic structure up to x= 0.04. The average crystallite size of the samples varied in the range of 41.8 – 85.6 nm. The prepared samples exhibited agglomerated particles with larger grain size observed in Sm-substituted Ni-Zn ferrite as compared to the unsubstituted sample. The prepared samples exhibited typical soft magnetic behavior as evidenced by the small coercivity field. The magnetic saturation, Ms values decreased as the Sm3+ concentration increases. Conclusion: The substituted Ni-Zn ferrites form agglomerated particles inching towards more uniform microstructure with each increase in Sm3+ substitution. The saturation magnetization of substituted samples decreases with the increase of samarium ion concentration. The decrease in saturation magnetization can be explained based on weak super exchange interaction between A and B sites. The difference in magnetic properties between the samples despite the slight difference in Sm3+ concentrations suggests that the properties of the NiZnFe2O4 can be ‘tuned’, depending on the present need, through the substitution of Fe3+ with rare earth ions.


Materials ◽  
2021 ◽  
Vol 14 (13) ◽  
pp. 3717
Author(s):  
Jae-Young Jung ◽  
Soung-Soo Yi ◽  
Dong-Hyun Hwang ◽  
Chang-Sik Son

The precursor prepared by co-precipitation method was sintered at various temperatures to synthesize crystalline manganese tungstate (MnWO4). Sintered MnWO4 showed the best crystallinity at a sintering temperature of 800 °C. Rare earth ion (Dysprosium; Dy3+) was added when preparing the precursor to enhance the magnetic and luminescent properties of crystalline MnWO4 based on these sintering temperature conditions. As the amount of rare earth ions was changed, the magnetic and luminescent characteristics were enhanced; however, after 0.1 mol.%, the luminescent characteristics decreased due to the concentration quenching phenomenon. In addition, a composite was prepared by mixing MnWO4 powder, with enhanced magnetism and luminescence properties due to the addition of dysprosium, with epoxy. To one of the two prepared composites a magnetic field was applied to induce alignment of the MnWO4 particles. Aligned particles showed stronger luminescence than the composite sample prepared with unsorted particles. As a result of this, it was suggested that it can be used as phosphor and a photosensitizer by utilizing the magnetic and luminescent properties of the synthesized MnWO4 powder with the addition of rare earth ions.


2021 ◽  
Author(s):  
Huajun Yang ◽  
Fang Peng ◽  
Danielle E. Schier ◽  
Stipe A. Markotic ◽  
Xiang Zhao ◽  
...  

Sign in / Sign up

Export Citation Format

Share Document