scholarly journals Impact of detector-element active-area shape and fill factor on super-resolution

2015 ◽  
Vol 3 ◽  
Author(s):  
Russell C. Hardie ◽  
Douglas R. Droege ◽  
Alexander J. Dapore ◽  
Mark E. Greiner
Keyword(s):  
Fill Factor ◽  
Super Resolution ◽  
Active Area ◽  
Detector Element

scholarly journals Two-Dimensional Digital Beam Steering Based on Liquid Crystal Phase Gratings

2021 ◽  
Vol 11 (8) ◽  
pp. 3632
Author(s):  
Mario García de Blas ◽  
Morten Andreas Geday ◽  
Jose Manuel Otón ◽  
Xabier Quintana Arregui
Keyword(s):  
Liquid Crystal ◽  
Indium Tin Oxide ◽  
Fill Factor ◽  
Pulse Width Modulation ◽  
Beam Steering ◽  
Active Area ◽  
Steering Angle ◽  
Direct Laser ◽  
Efficiency Map ◽  
Incoming Light

Electrically tunable phase gratings are able to steer an incoming light beam without employing movable parts. Here, we present the design and implementation of a 2D beam steering device by cascading two orthogonal 1D liquid crystal (LC) based phase gratings, each having an array of 72 rectangular individually controlled pixels and driven by a custom 12-bit Pulse-Width Modulation (PWM) electrical driver. High-resolution structures in glass wafers coated with transparent Indium-Tin Oxide (ITO) have been prepared using Direct Laser Writing (DLW) techniques. With DLW, a high number of pixels can easily be drawn with an interpixel space of less than 3 μm, leading to devices with a high fill factor. The active area of the cascaded device is 1.1 × 1.1 mm2. We present a 72 × 72 point efficiency map corresponding to a maximum diagonal steering angle of 1.65°. Special attention has been paid to make the device compatible with space application by avoiding electronics in the active area.

Super-Resolution Microscopy in Studying the Structure and Function of the Cell Nucleus

Acta Naturae ◽  
2017 ◽  
Vol 9 (4) ◽  
pp. 42-51
Author(s):  
S. S. Ryabichko ◽  
◽  
A. N. Ibragimov ◽  
L. A. Lebedeva ◽  
E. N. Kozlov ◽  
...  
Keyword(s):  
Cell Nucleus ◽  
Super Resolution ◽  
Structure And Function ◽  
And Function ◽  
Super Resolution Microscopy

Microcrystalline (Si,Ge):H Solar Cells

2003 ◽  
Vol 762 ◽  
Author(s):  
Jianhua Zhu ◽  
Vikram L. Dalal
Keyword(s):  
Solar Cells ◽  
Buffer Layer ◽  
Quantum Efficiency ◽  
Fill Factor ◽  
Open Circuit Voltage ◽  
Defect Density ◽  
Cell Structure ◽  
Open Circuit ◽  
Base Layer ◽  
Ecr Plasma

AbstractWe report on the growth and properties of microcrystalline Si:H and (Si,Ge):H solar cells on stainless steel substrates. The solar cells were grown using a remote, low pressure ECR plasma system. In order to crystallize (Si,Ge), much higher hydrogen dilution (∼40:1) had to be used compared to the case for mc-Si:H, where a dilution of 10:1 was adequate for crystallization. The solar cell structure was of the p+nn+ type, with light entering the p+ layer. It was found that it was advantageous to use a thin a-Si:H buffer layer at the back of the cells in order to reduce shunt density and improve the performance of the cells. A graded gap buffer layer was used at the p+n interface so as to improve the open-circuit voltage and fill factor. The open circuit voltage and fill factor decreased as the Ge content increased. Quantum efficiency measurements indicated that the device was indeed microcrystalline and followed the absorption characteristics of crystalline ( Si,Ge). As the Ge content increased, quantum efficiency in the infrared increased. X-ray measurements of films indicated grain sizes of ∼ 10nm. EDAX measurements were used to measure the Ge content in the films and devices. Capacitance measurements at low frequencies ( ~100 Hz and 1 kHz) indicated that the base layer was indeed behaving as a crystalline material, with classical C(V) curves. The defect density varied between 1x1016 to 2x1017/cm3, with higher defects indicated as the Ge concentration increased.

Kinetics of Light-Induced Effects in Mixed-Phase Hydrogenated Silicon Solar Cells

2003 ◽  
Vol 762 ◽  
Author(s):  
Guozhen Yuea ◽  
Baojie Yan ◽  
Jeffrey Yang ◽  
Kenneth Lord ◽  
Subhendu Guha
Keyword(s):  
Solar Cells ◽  
Fill Factor ◽  
Equivalent Circuit Model ◽  
Open Circuit ◽  
Mixed Phase ◽  
Silicon Solar Cells ◽  
Initial Increase ◽  
Soaking Time ◽  
Hydrogenated Silicon ◽  
Kinetics Of

AbstractWe have observed a significant light-induced increase in the open-circuit voltage (Voc) of mixed-phase hydrogenated silicon solar cells. In this study, we investigate the kinetics of the light-induced effects. The results show that the cells with different initial Voc have different kinetic behavior. For the cells with a low initial Voc (less than 0.8 V), the increase in Voc is slow and does not saturate for light-soaking time of up to 16 hours. For the cells with medium initial Voc (0.8 ∼ 0.95 V), the Voc increases rapidly and then saturates. Cells with high initial Voc (0.95 ∼ 0.98 V) show an initial increase in Voc, followed bya Voc decrease. All light-soaked cells exhibit a degradation in fill factor. The temperature dependence of the kinetics shows that light soaking at high temperatures causes Voc increase to saturate faster than at low temperatures. The observed results can be explained by our recently proposed two-diode equivalent-circuit model for mixed-phase solar cells.

Sign in / Sign up

Export Citation Format

Share Document