scholarly journals Identification of Critical Problems in Biochemical Methane Potential (BMP) Tests From Methane Production Curves

2019 ◽  
Vol 7 ◽  
Author(s):  
Konrad Koch ◽  
Sasha D. Hafner ◽  
Sören Weinrich ◽  
Sergi Astals
Keyword(s):  
Methane Production ◽  
Biochemical Methane Potential ◽  
Critical Problems ◽  
Methane Potential

Assessing the role of biochemical methane potential tests in determining anaerobic degradability rate and extent

2011 ◽  
Vol 64 (4) ◽  
pp. 880-886 ◽  
Author(s):  
P. D. Jensen ◽  
H. Ge ◽  
D. J. Batstone
Keyword(s):  
Parameter Estimation ◽  
Methane Production ◽  
Estimation Method ◽  
Test Method ◽  
Continuous Systems ◽  
Batch Test ◽  
Biochemical Methane Potential ◽  
First Order ◽  
Methane Potential ◽  
The Impact

The biodegradability and bioavailability of hydrolysis-limited substrates under anaerobic (and aerobic) conditions can be represented by two key parameters – degradability (fd), or the percentage that can be effectively be destroyed during digestion, and first order hydrolysis coefficient (khyd), or the speed at which material breaks down. Biochemical methane potential (BMP) testing uses a batch test (in triplicate), and by fitting against a first order model, can fit both parameters in the same test. BMP testing is now being widely used for anaerobic process feasibility and design purposes, and standardisation efforts are ongoing. In this paper, we address a number of key issues relating to the test method and its analysis. This includes proposal of a new fitting and parameter estimation method, evaluation of the impact of inoculum to substrate ratio on fitted parameters, and comparison to performance in continuous systems. The new parameter estimation technique provides an estimate of parameter uncertainty and correlation, and is clearly more suitable than model transformation and linear regression. An inoculum volume ratio of at least 50% (2:1 on VS basis) was required on a cellulose substrate to use methane production as primary indicator, as found by comparing methane production and solubilisation of cellulose. Finally, on a typical material, waste activated sludge, the batch test was slightly conservative in terms of degradability and rate, indicating a bias in the BMP test. The test is a cost-effective and capable method to evaluate potential substrates, but it should be noted that it is generally conservative, especially if sub-optimal inoculum is used.

scholarly journals Impact of Attrition Ball-Mill on Characteristics and Biochemical Methane Potential of Food Waste

Energies ◽  
2021 ◽  
Vol 14 (8) ◽  
pp. 2085
Author(s):  
Yang Mo Gu ◽  
Seon Young Park ◽  
Ji Yeon Park ◽  
Byoung-In Sang ◽  
Byoung Seong Jeon ◽  
...  
Keyword(s):  
Particle Size ◽  
Anaerobic Digestion ◽  
Food Waste ◽  
Methane Production ◽  
Ball Mill ◽  
Volatile Fatty Acids ◽  
Milling Time ◽  
Biochemical Methane Potential ◽  
Methane Potential ◽  
The Impact

The impact of attrition ball-mill pretreatment on food waste particle size, soluble chemical oxygen demand (SCOD), biochemical methane potential, and microbial community during anaerobic digestion was investigated based on milling speed and time. The uniformity of particle size improved with increasing milling speed and time. The SCOD of the pretreated samples increased to 4%, 7%, and 17% at the speeds of 150, 225, and 300 rpm, respectively, compared to the control. Milling time did not significantly change the SCOD. The cumulative methane productions of 430, 440, and 490 mL/g-VS were observed at the speeds of 150, 225, and 300 rpm, respectively, while the untreated sample exhibited the cumulative methane production of 390 mL/g-VS. Extended milling time did not improve methane production much. When the milling times of 10, 20, and 30 min were applied with the milling speed fixed at 300 rpm, the methane productions of 490, 510, and 500 mL/g-VS were observed respectively. Ball-mill pretreatment also increased the total volatile fatty acids. During the anaerobic digestion (AD) of ball-mill treated food waste, acetoclastic methanogens predominated, with a relative abundance of 48–49%. Interestingly, hydrogenotrophic methanogens were 1.6 times higher in the pretreated samples than those in the control. These results showed the potential of attrition ball milling as a food waste pretreatment for improving methane production.

scholarly journals Potencial bioquímico de metano de águas residuárias da ultrafiltração no processamento da acerola (Malpighia emarginata) verde

2020 ◽  
Vol 41 (2) ◽  
pp. 135
Author(s):  
Andreza Carla Lopes Andre ◽  
Miriam Cleide Cavalcante de Amorim ◽  
Kessia Caroline Dantas da Silva ◽  
Paula Tereza Souza e Silva
Keyword(s):  
Methane Production ◽  
Food Industry ◽  
Pilot Scale ◽  
Organic Load ◽  
Anaerobic Sludge ◽  
Biochemical Methane Potential ◽  
Decay Rate Constant ◽  
Malpighia Emarginata ◽  
Load Removal ◽  
Methane Potential

Ultrafiltration clarifies fruit juices, in the food industry, but generates retentive, recalcitrant wastewater, which, by its organic nature, may present a potential for biodegradation and methane production. This study aimed to evaluate the biochemical methane potential (BMP) in wastewater from the processing of unripe green acerola, obtaining the mass balance and the speed of organic load removal in COD terms. The BMP assays followed the German Guidelines VDI 4630, by applying three COD loads per liter of reactor vial (0,86 g CDOAplied L-1R, 1,5 g CDOAplied L-1R e 2,0 g CDOAplied L-1R), , in batches, inoculated with the anaerobic sludge from reactors treating domestic sewage, at 30 0C. The pH, COD, and methane production were evaluated every 48 hours. The biodegradability and the decay rate constant of the COD (Kd) were determined, thus obtaining the methanized COD, the COD for the formation of new cells, and the COD present in the wastewater, in the form of volatile acids. The best BMP was 0.100 L CH4 g -1 CDORemoved, the percentages of methanization were above 62 %, and the highest Kd occurred for the lowest load applied. The anaerobic digestion of the wastewater proved viable for in full-scale, with its application being suggested at a pilot scale.  

scholarly journals Influence of conditioning agents and enzymic hydrolysis on the biochemical methane potential of sewage sludge

2013 ◽  
Vol 68 (7) ◽  
pp. 1622-1632 ◽  
Author(s):  
Elena Marañón ◽  
Luis Negral ◽  
Yolanda Fernández-Nava ◽  
Leonor Castrillón
Keyword(s):  
Sewage Sludge ◽  
Methane Production ◽  
Wastewater Treatment Plants ◽  
Solid Phase ◽  
Enzymic Hydrolysis ◽  
Biochemical Methane Potential ◽  
General Improvement ◽  
Methane Potential ◽  
Pre Treatment ◽  
Cationic Polyelectrolytes

Biochemical methane potential (BMP) tests have been carried out on sewage sludge from two wastewater treatment plants to assess the effect of additives (FeCl3 and two cationic polyelectrolytes) used in sludge dewatering. BMP tests were also carried out on the concentrated solid phase from the enzymic hydrolysis pre-treatment (42 °C, 48 h). FeCl3 had no significant effect on specific methane production, obtaining 242–246 LCH4/kgVSo. The effect of the combination of polyelectrolyte and FeCl3 depended on the polyelectrolyte and the sludge, but generally led to an increase in specific methane production (25–40%). When enzymic hydrolysis was applied as a pre-treatment, specific methane production increased from 6.8% in the sludge containing FeCl3 to 20% in the sludge without FeCl3, although the increases were not statistically significant. In terms of LCH4/kgVSrem, a general improvement was achieved both by means of additives and by enzymic hydrolysis. However, this improvement was only significant in the case of sludge which had undergone previous enzymic hydrolysis (62%) and in the untreated sludge containing a polyelectrolyte and FeCl3 (24%). Cationic polyelectrolytes inhibited solid–liquid separation during enzymic hydrolysis and, although the presence of only FeCl3 did not affect this separation, a significant decrease (32%) in LCH4/kgVSrem was observed.

scholarly journals Assessment of the biochemical methane potential of mono- and co-digested dairy farm wastes

2019 ◽  
Vol 38 (1) ◽  
pp. 88-99 ◽  
Author(s):  
Mohamad Adghim ◽  
Mohamed Abdallah ◽  
Suhair Saad ◽  
Abdallah Shanableh ◽  
Majid Sartaj
Keyword(s):  
Methane Production ◽  
Dairy Farm ◽  
Gompertz Model ◽  
Maximum Error ◽  
Methane Yield ◽  
Cow Manure ◽  
Biochemical Methane Potential ◽  
Volatile Solids ◽  
Waste Milk ◽  
Methane Potential

This study aimed to evaluate the methane potential of mono- and co-digested dairy farm wastes. The tested substrates included manure from lactating, dry, and young cows, as well as waste milk and feed waste. The highest methane yield was achieved from the lactating cow manure, which produced an average of 412 L of CH4 kg−1 volatile solids, followed by young and dry cow manures (332 and 273 L of CH4 kg−1 volatile solids, respectively). Feed and milk yielded an average of 325 and 212 L of CH4 kg−1 volatile solids, respectively. Co-digesting the manures from lactating and young cows with feed improved methane production by 7%. However, co-digesting the dry cow manure with feed achieved only 85% of the calculated methane yield. Co-digesting manure and milk at a ratio of 70:30 enhanced the methane potential from lactating, dry, and young cow manures by 19, 30, and 37%, respectively. Moreover, co-digesting lactating, dry, and young cow manures with milk at a ratio of 30:70 enhanced the methane yield by 60, 30, and 88%, respectively. The cumulative methane production of all samples was accurately described using the Gompertz model with a maximum error of 10%. Carbohydrates contributed the most to methane potential, while proteins and lipids were limiting.

Relationship of Substrate and Inoculum on Biochemical Methane Potential for Grass and Pig Manure Co-Digestion

2012 ◽  
Vol 512-515 ◽  
pp. 444-448 ◽  
Author(s):  
Sumeth Dechrugsa ◽  
Sumate Chaiprapat
Keyword(s):  
Methane Production ◽  
Methane Yield ◽  
Pig Manure ◽  
Biochemical Methane Potential ◽  
Production Potential ◽  
Methane Potential ◽  
Methane Production Rate ◽  
Substrate Ratio ◽  
Relationship Of ◽  
Careful Investigation

The effects of substrate mix ratio and inoculum/substrate ratio (ISR) on biochemical methane potential of para-grass (PG) and pig manure (PM) were investigated in batch test that maintained temperature at 35±1 oC and continuously shaked at 120 rpm. Cumulative methane production data at different mix ratios and ISRs were evaluated and fitted with Gompertz equation to derive methane production potential (mL) and maximum methane production rate (mL/d). The maximum and average methane yields at each respective ISR of 1, 2, 3, and 4 were [413.0, 315.5], [539.7, 455.6], [590.3, 472.5], and [593.1, 473.5] mL/gVSadded. Relationship of ISR and PG mix ratio to specific methane yield were expressed in quadratic regression model. The generated response surface showed that methane yield was elevated at higher ISR and higher PG mix ratio. This suggests a careful investigation at different ISR and substrate mix ratios should be performed in order to develop a realistic biochemical methane potential of anaerobic co-digestion.

Sign in / Sign up

Export Citation Format

Share Document