scholarly journals Experimental Study on Free Vibratory Behavior of Nonlinear Structure

2019 ◽  
Vol 63 (2) ◽  
pp. 91-99
Author(s):  
Denes Farago ◽  
Zoltan Dombovari

The basic behavior of free vibratory nonlinear system is investigated in this work. The main approach was to reveal the order of fitting necessary to properly approximate the actual behavior of a nonlinear mechanical system. Tests were performed in an experimental setup subjected to geometric hardening nonlinearities. The investigation showed that, it is essential to approximate the nonlinearity correctly. Low order approximation can result in large errors in the predicted amplitudes. The nonlinear static stiffness characteristics was measured and fit with polynomial describing function. The free vibratory response was deviated from the one calculated by cubic fitting. The presented higher order approximation of the amplitude-frequency parametric relation is revealed so that, in this particular example, seventh degree approximation is sufficiently closer to the experienced behavior. The analytical solution including the first and second order internal resonances were checked and compared with continuation results of the backbone curve.

Author(s):  
David Julian Gonzalez Maldonado ◽  
Peter Hagedorn ◽  
Thiago Ritto ◽  
Rubens Sampaio ◽  
Artem Karev

2019 ◽  
Vol 26 (7-8) ◽  
pp. 459-474
Author(s):  
Saeed Mahmoudkhani ◽  
Hodjat Soleymani Meymand

The performance of the cantilever beam autoparametric vibration absorber with a lumped mass attached at an arbitrary point on the beam span is investigated. The absorber would have a distinct feature that in addition to the two-to-one internal resonance, the one-to-three and one-to-five internal resonances would also occur between flexural modes of the beam by tuning the mass and position of the lumped mass. Special attention is paid on studying the effect of these resonances on increasing the effectiveness and extending the range of excitation amplitudes at which the autoparametric vibration absorber remains effective. The problem is formulated based on the third-order nonlinear Euler–Bernoulli beam theory, where the assumed-mode method is used for deriving the discretized equations of motion. The numerical continuation method is then applied to obtain the frequency response curves and detect the bifurcation points. The harmonic balance method is also employed for detecting the type of internal resonances between flexural modes by inspecting the frequency response curves corresponding to different harmonics of the response. Parametric studies on the performance of the absorber are conducted by varying the position and mass of the lumped mass, while the frequency ratio of the primary system to the first mode of the beam is kept equal to two. Results indicated that the one-to-five internal resonance is especially responsible for the considerable enhancement of the performance.


2019 ◽  
Vol 25 ◽  
pp. 1-6 ◽  
Author(s):  
Alexander Gorbenko ◽  
Guntis Strautmanis ◽  
Gennadiy Filimonikhin ◽  
Mareks Mezitis

2018 ◽  
Vol 19 (11) ◽  
pp. 691-698 ◽  
Author(s):  
G. L. Degtyarev ◽  
R. N. Faizutdinov ◽  
I. O. Spiridonov

In the paper multiobjective robust controller synthesis problem for nonlinear mechanical system described by Lagrange’s equations of the second kind is considered. Such tasks have numerous practical applications, for example in controller design of robotic systems and gyro-stabilized platforms. In practice, we often have to use uncertain mathematical plant models in controller design. Therefore, ensuring robustness in presence of parameters perturbations and unknown external disturbances is an important requirement for designed systems. Much of modern robust control theory is linear. When the actual system exhibits nonlinear behavior, nonlinearities are usually included in the uncertainty set of the plant. A disadvantage of this approach is that resulting controllers may be too conservative especially when nonlinearities are significant. The nonlinear H∞ optimal control theory developed on the basis of differential game theory is a natural extension of the linear robust control theory. Nonlinear theory methods ensure robust stability of designed control systems. However, to determine nonlinear H∞-control law, the partial differential equation have to be solved which is a rather complicated task. In addition, it is difficult to ensure robust performance of controlled processes when using this method. In this paper, methods of linear parameter-varying (LPV) systems are used to synthesize robust control law. It is shown, that Lagrange system may be adequately represented in the form of quasi-LPV model. From the computational point of view, the synthesis procedure is reduced to convex optimization techniques under constraints expressed in the form of linear matrix inequalities (LMIs). Measured parameters are incorporated in the control law, thus ensuring continuous adjustment of the controller parameters to the current plant dynamics and better performance of control processes in comparison with H∞-regulators. Furthermore, the use of the LMIs allows to take into account the transient performance requirements in the controller synthesis. Since the quasi-LPV system depends continuously on the parameter vector, the LMI system is infinite-dimensional. This infinitedimensional system is reduced to a finite set of LMIs by introducing a polytopic LPV representation. The example of multiobjective robust control synthesis for electro-optical device’s line of sight pointing and stabilization system suspended in two-axes inertially stabilized platform is given.


2017 ◽  
Vol 91 ◽  
pp. 36-57 ◽  
Author(s):  
Marcos Rabelo ◽  
Luciana Silva ◽  
Romes Borges ◽  
Rosane Gonçalves ◽  
Marcos Henrique

2009 ◽  
Vol 23 (23) ◽  
pp. 4779-4789
Author(s):  
S. S. GANJI ◽  
G. DOMAIRRY ◽  
A. G. DAVODI ◽  
H. BABAZADEH ◽  
S. H. SEYEDALIZADEH GANJI

The main objective of this paper is to apply the parameter expansion technique (a modified Lindstedt–Poincaré method) to calculate the first, second, and third-order approximations of motion of a nonlinear oscillator arising in rigid rod rocking back. The dynamics and frequency of motion of this nonlinear mechanical system are analyzed. A meticulous attention is carried out to the study of the introduced nonlinearity effects on the amplitudes of the oscillatory states and on the bifurcation structures. We examine the synchronization and the frequency of systems using both the strong and special method. Numerical simulations and computer's answers confirm and complement the results obtained by the analytical approach. The approach proposes a choice to overcome the difficulty of computing the periodic behavior of the oscillation problems in engineering. The solutions of this method are compared with the exact ones in order to validate the approach, and assess the accuracy of the solutions. In particular, APL-PM works well for the whole range of oscillation amplitudes and excellent agreement of the approximate frequency with the exact one has been demonstrated. The approximate period derived here is accurate and close to the exact solution. This method has a distinguished feature which makes it simple to use, and also it agrees with the exact solutions for various parameters.


Sign in / Sign up

Export Citation Format

Share Document