scholarly journals Experimental Investigation of Organic Rankine Cycle (ORC) for Low Temperature Geothermal Fluid: Effect of Pump Rotation and R-134 Working Fluid in Scroll-Expander

2021 ◽  
Vol 118 (5) ◽  
pp. 1565-1576
Author(s):  
Nugroho Agung Pambudi ◽  
Santiko Wibowo ◽  
Ranto ◽  
Lip Huat Saw
Keyword(s):  
Experimental Investigation ◽  
Low Temperature ◽  
Organic Rankine Cycle ◽  
Rankine Cycle ◽  
Working Fluid ◽  
Geothermal Fluid ◽  
Scroll Expander

Hybrid Solar-Geothermal Power Generation to Increase the Energy Production From a Binary Geothermal Plant

2011 ◽  
Author(s):  
Giovanni Manente ◽  
Randall Field ◽  
Ronald DiPippo ◽  
Jefferson W. Tester ◽  
Marco Paci ◽  
...  
Keyword(s):  
Power Plant ◽  
Power Output ◽  
Energy Production ◽  
Organic Rankine Cycle ◽  
Rankine Cycle ◽  
Working Fluid ◽  
Solar Thermal Energy ◽  
Geothermal Fluid ◽  
Industrial Grade ◽  
Design Values

This article examines how hybridization using solar thermal energy can increase the power output of a geothermal binary power plant that is operating on geothermal fluid conditions that fall short of design values in temperature and flow rate. The power cycle consists of a subcritical organic Rankine cycle using industrial grade isobutane as the working fluid. Each of the power plant units includes two expanders, a vaporizer, a preheater and air-cooled condensers. Aspen Plus was used to model the plant; the model was validated and adjusted by comparing its predictions to data collected during the first year of operation. The model was then run to determine the best strategy for distributing the available geothermal fluid between the two units to optimize the plant for the existing degraded geofluid conditions. Two solar-geothermal hybrid designs were evaluated to assess their ability to increase the power output and the annual energy production relative to the geothermal-only case.

Exergoeconomic comparison and optimization of organic Rankine cycle, trilateral Rankine cycle and transcritical carbon dioxide cycle for heat recovery of low-temperature geothermal water

2019 ◽  
Vol 233 (8) ◽  
pp. 1068-1084 ◽  
Author(s):  
Afsaneh Noroozian ◽  
Abbas Naeimi ◽  
Mokhtar Bidi ◽  
Mohammad Hossein Ahmadi
Keyword(s):  
Sensitivity Analysis ◽  
Low Temperature ◽  
Heat Source ◽  
Organic Rankine Cycle ◽  
Rankine Cycle ◽  
Working Fluid ◽  
Cost Ratio ◽  
Exergetic Efficiency ◽  
Geothermal Heat ◽  
Product Cost

Depleting fossil fuel resources and the horrible environmental impacts due to burning fossil fuels emphasize the importance of using renewable energy resources such as geothermal and solar energies. This paper compares performance of CO2 transcritical cycle, organic Rankine cycle, and trilateral Rankine cycle using a low-temperature geothermal heat source. Thermodynamic analysis, exergetic analysis, economic analysis, and exergoeconomic analysis are applied for each of the aforementioned cycles. In addition, a sensitivity analysis is performed on the system, and the effects of geothermal heat source temperature, evaporator pinch point temperature, and turbine inlet pressure on the cycle's performance are evaluated. Finally, the systems are optimized in order to minimize product cost ratio and maximize exergetic efficiency by using the genetic algorithm. Results indicate that the maximum thermal efficiency is approximately 13.03% which belongs to organic Rankine cycle with R123 as working fluid. CO2 cycle has the maximum exergetic efficiency, equals to 46.13%. The minimum product cost ratio refers to the organic Rankine cycle with R245fa as working fluid. Moreover, sensitivity analysis shows that increasing geothermal heat source temperature results in higher output power, product cost ratio, and exergy destruction ratio in all cycles.

Performance Investigation of Solar Organic Rankine Cycle Systems With and Without Regeneration and With Zeotropic Working Fluid Mixtures for Use in Micro-Cogeneration

2020 ◽  
Author(s):  
Wahiba Yaïci ◽  
Evgueniy Entchev ◽  
Pouyan Talebizadeh Sardari
Keyword(s):  
Low Temperature ◽  
Heat Source ◽  
High Efficiency ◽  
Organic Rankine Cycle ◽  
Rankine Cycle ◽  
Industrial Wastes ◽  
Working Fluid ◽  
Condensation Temperature ◽  
Thermodynamic Performance ◽  
Cycle Efficiency

Abstract Globally there are several viable sources of renewable, low-temperature heat (below 130°C) particularly solar energy, geothermal energy, and energy generated from industrial wastes. Increased exploitation of these low-temperature options has the definite potential of reducing fossil fuel consumption with its attendant very harmful greenhouse gas emissions. Researchers have universally identified the organic Rankine cycle (ORC) as a practicable and promising system to generate electrical power from renewable sources based on its beneficial use of volatile organic fluids as working fluids (WFs). In recent times, researchers have also shown a preference for/an inclination towards deployment of zeotropic mixtures as ORC WFs because of their capacity to improve thermodynamic performance of ORC systems, a feat enabled by better matches of the temperature profiles of the WF and the heat source/sink. This paper demonstrates both the technical feasibility and the notable advantages of using zeotropic mixtures as WFs through a simulation study of an ORC system. The study examines the thermodynamic performance of ORC systems using zeotropic WF mixtures to generate electricity driven by low-temperature solar heat source for building applications. A thermodynamic model is developed with an ORC system both with and excluding a regenerator. Five zeotropic mixtures with varying compositions of R245fa/propane, R245fa/hexane, R245fa/heptane, pentane/hexane and isopentane/hexane are evaluated and compared to identify the best combinations of WF mixtures that can yield high efficiency in their system cycles. The study also investigates the effects of the volumetric flow ratio, and evaporation and condensation temperature glides on the ORC’s thermodynamic performance. Following a detailed analysis of each mixture, R245fa/propane is selected for parametric study to examine the effects of operating parameters on the system’s efficiency and sustainability index. For zeotropic mixtures, results showed that there is an optimal composition range within which binary mixtures are inclined to perform more efficiently than the component pure fluids. In addition, a significant increase in cycle efficiency can be achieved with a regenerative ORC, with cycle efficiency ranging between 3.1–9.8% and 8.6–17.4% for ORC both without and with regeneration, respectively. Results also showed that exploiting zeotropic mixtures could enlarge the limitation experienced in selecting WFs for low-temperature solar organic Rankine cycles.

Simulation of Solar Organic Rankine Cycle System Using Turbocharger with Cycle Tempo and Environmentally Friendly Fluid

2013 ◽  
Vol 388 ◽  
pp. 13-17 ◽  
Author(s):  
Ruli Nutranta ◽  
Idrus Al Hamid ◽  
Nasruddin ◽  
B. Harinaldi
Keyword(s):  
Low Temperature ◽  
Mechanical Energy ◽  
Organic Rankine Cycle ◽  
Electrical Energy ◽  
Rankine Cycle ◽  
Working Fluid ◽  
Cycle System ◽  
Geothermal Wells ◽  
Temperature And Pressure ◽  
Cycle Temperature

Organic Rankine cycle (ORC) is a modified rankine cycle with working fluids, of organic material (Refrigerant). Refrigerant pentane has low boiling point, therefore ORC can be used in power plant which uses low temperature resources, such as solar thermal exhausted gases and geothermal wells. Organic Rankine Cycle (ORC) is used to convert heat energy into mechanical energy or electricity generated by a low temperature of the hot sun. The working fluid used is HCR12, HCR22, HCR134a and Pentane. Simulations performed with an organic Rankine cycle temperature and pressure with cycle tempo program. By programming the simulation cycle tempo and got the result on the maximum power a turbine to the conditions of the working fluid Pentane to the input turbine T = 700C and pressure = 2 bar can generate 2.07 kW. Turbocharger is one of the alternatives in the energy conversion of the energy of motion into electrical energy. Turbocharger rotation will be used to turn a generator and converts the energy of motion into electrical energy.

Experimental Verification of a Combined Power and Cooling Thermodynamic Cycle

Solar Energy ◽  
2004 ◽  
Author(s):  
Chris Martin ◽  
D. Yogi Goswami
Keyword(s):  
Experimental Investigation ◽  
Low Temperature ◽  
Thermodynamic Cycle ◽  
Rankine Cycle ◽  
Working Fluid ◽  
Heat Sources ◽  
Sensible Heat ◽  
Exhaust Temperature ◽  
Future Work ◽  
Isentropic Efficiency

A novel combined power-cooling thermodynamic cycle, for use with low-temperature, sensible heat sources, is under experimental investigation. In this power-cooling cycle, absorption condensation is used to regenerate the working fluid. This allows the expander exhaust temperature to drop significantly below the temperature at which absorption is taking place. This is an obvious departure from pure working fluid, Rankine cycle operation and is the source of cooling. Expander exhaust temperatures are controlled by the cycle parameters of expander exit pressure (absorption pressure), expander isentropic efficiency, and the vapor properties (temperature, pressure, and concentration) at expander inlet. Experiments have been performed that show the power-cooling concept to be valid by measuring the expander exit-absorber temperature difference and they highlight the direction for future work.

Sign in / Sign up

Export Citation Format

Share Document