Numerical analysis of correlation between fibre orientation and eddy current testing signals of carbon-fibre reinforced polymer composites

2012 ◽  
Vol 39 (1-4) ◽  
pp. 251-259 ◽  
Author(s):  
Jun Cheng ◽  
Jinhao Qiu ◽  
Toshiyuki Takagi ◽  
Tetsuya Uchimoto ◽  
Ning Hu
Keyword(s):  
Numerical Analysis ◽  
Carbon Fibre ◽  
Polymer Composites ◽  
Eddy Current ◽  
Fibre Orientation ◽  
Eddy Current Testing ◽  
Current Testing ◽  
Reinforced Polymer ◽  
Carbon Fibre Reinforced Polymer ◽  
Fibre Reinforced Polymer

scholarly journals Sequential Laser–Mechanical Drilling of Thick Carbon Fibre Reinforced Polymer Composites (CFRP) for Industrial Applications

Polymers ◽  
2021 ◽  
Vol 13 (13) ◽  
pp. 2136
Author(s):  
Sharizal Ahmad Sobri ◽  
Robert Heinemann ◽  
David Whitehead
Keyword(s):  
Carbon Fibre ◽  
Polymer Composites ◽  
Weight Ratio ◽  
High Strength ◽  
Industrial Applications ◽  
Fibre Laser ◽  
Reinforced Polymer ◽  
Carbon Fibre Reinforced Polymer ◽  
Fibre Reinforced Polymer ◽  
Thrust And Torque

Carbon fibre reinforced polymer composites (CFRPs) can be costly to manufacture, but they are typically used anywhere a high strength-to-weight ratio and a high steadiness (rigidity) are needed in many industrial applications, particularly in aerospace. Drilling composites with a laser tends to be a feasible method since one of the composite phases is often in the form of a polymer, and polymers in general have a very high absorption coefficient for infrared radiation. The feasibility of sequential laser–mechanical drilling for a thick CFRP is discussed in this article. A 1 kW fibre laser was chosen as a pre-drilling instrument (or initial stage), and mechanical drilling was the final step. The sequential drilling method dropped the overall thrust and torque by an average of 61%, which greatly increased the productivity and reduced the mechanical stress on the cutting tool while also increasing the lifespan of the bit. The sequential drilling (i.e., laser 8 mm and mechanical 8 mm) for both drill bits (i.e., 2- and 3-flute uncoated tungsten carbide) and the laser pre-drilling techniques has demonstrated the highest delamination factor (SFDSR) ratios. A new laser–mechanical sequence drilling technique is thus established, assessed, and tested when thick CFRP composites are drilled.

Sign in / Sign up

Export Citation Format

Share Document