scholarly journals Pod Maturity in the Shelling Process

2017 ◽  
Vol 44 (1) ◽  
pp. 26-34 ◽  
Author(s):  
E.T. Carter ◽  
D.L. Rowland ◽  
B.L. Tillman ◽  
J.E. Erickson ◽  
T.L. Grey ◽  
...  

ABSTRACT Determining an optimum harvest maturity for indeterminate crops such as peanut is critical because it directly affects yield and grade. Historically, the assumption has been that growers will harvest at optimum maturity due to the positive impact on these two characteristics. However, the increased acreage under management by a single farmer may cause growers to harvest prior to optimum maturity. The impact of peanut maturity on seed quality may not be fully understood by producers, where immature seed may have reduced emergence and vigor. Research was conducted to quantify the maturity of seed peanuts received by the Florida Foundation Seed Producers, Inc. (FFSP) at various stages of the shelling process: samples received from the field; after the in-shell samples were cleaned; after in-shell pre-sizing into two size classes; and after separation of in-shell samples at the gravity deck. Samples collected at each stage were pressure-washed to remove the exocarp and then separated into yellow and brown/black color classes based on the maturity board. Pods within each color class were counted, dried, weighed, and graded. Maturity at each sheller stage was assessed for three peanut cultivars. For the field stage, across all cultivars, 56% of pods were in the mature, or brown/black color class. This was well below the level of 70-80% in the brown/black class purported to be the maturity level that optimizes yield and grade. Cleaning had a minor impact on maturity percentages (average percent mature was 64% across all cultivars after passing through the mechanical cleaning process); however, in the pre-shelling sizing process where pods are sorted into “lead” and “small” baskets representing large and small pods, respectively, the maturity percentage was improved to 75% in the large pods and declined to 45% in the small pods. These results indicate that: 1) maturity levels of cultivars harvested in the field may not be optimal; and 2) that improvements could be made in maturity percentages by modifying the shelling process to separate the larger pods which are more likely to be mature than the smaller pods. These results also suggest that seed peanut lots are unlikely to be composed entirely of mature pods, that large numbers of immature pods could make it through the shelling process and that immature seed are planted by farmers. This could explain some cases of suboptimal plant stands in peanut.

2009 ◽  
Vol 58 (1-6) ◽  
pp. 145-152 ◽  
Author(s):  
H. Ozawa ◽  
J. Watanabe ◽  
H. Chen ◽  
K. Isoda ◽  
A. Watanabe

Abstract To clarify the relationship between the impact of phenological and/or artificial factors on seed quality, we measured the numbers of strobili on nematode-resistant Pinus densiflora clones grown in an immature and relatively small scale (700 m2) seed orchard. In addition, we established the clonal identities of all ramets, identified the paternal parent of the seeds, and assessed the resistance of seedlings to nematode infection. We also clarified the quantitative differences of strobili among clones; one clone produced 86.4% and 70.8% of all male strobili and female strobili, respectively. However, given that the total contamination ratio of the orchard was 82.0%, immigrant pollen had a larger impact on the success of actual crossing than phenology. Seedlings with a resistant maternal parent were resistant, even when their paternal parent was from outside the orchard. Two unselected clones were also planted in the seed orchard, one of which was not resistant and was associated with a maternal contribution of 34.7% of all seed stock. These findings suggest that, despite having a large impact on the crossing, immigrant pollen has a minor impact on seed resistance. Conversely, unselected and nonresistant clones have a marked impact on seed resistance. We concluded that artificial factors have larger impact on the seed quality than phenological factors in this orchard and the seeds will be of sufficient quality for supplying the market once nonresistant clones have been removed from the orchard.


2020 ◽  
Author(s):  
Lamya Gaber ◽  
Aziza I. Hussein ◽  
Mohammed Moness

The impact of the recent exponential increase in complexity of digital VLSI circuits has heavily affected verification methodologies. Many advances toward verification and debugging techniques of digital VLSI circuits have relied on Computer Aided Design (CAD). Existing techniques are highly dependent on specialized test patterns with specific numbers increased by the rising complexity of VLSI circuits. A second problem arises in the form of large sizes of injecting circuits for correction and large number of SAT solver calls with a negative impact on the resultant running time. Three goals arise: first, diminishing dependence on a given test pattern by incrementally generating compact test patterns corresponding to design errors during the rectification process. Second, to reduce the size of in-circuit mutation circuit for error-fixing process. Finally, distribution of test patterns can be performed in parallel with a positive impact on digital VLSI circuits with large numbers of inputs and outputs. The experimental results illustrate that the proposed incremental correction algorithm can fix design bugs of type gate replacements in several digital VLSI circuits from ISCAS'85 with high speed and full accuracy. The speed of proposed Auto-correction mechanism outperforms the latest existing methods around 4.8x using ISCAS'85 benchmarks. The parallel distribution of test patterns on digital VLSI circuits during generating new compact test patterns achieves speed around 1.2x compared to latest methods.


2018 ◽  
Vol 33 (3) ◽  
pp. 496-502 ◽  
Author(s):  
Mika Vähä-Nissi ◽  
Timo Lappalainen ◽  
Kristian Salminen

Abstract Some paper and paperboard grades require strength also when rewetted. The purpose of this study was to investigate the impact of web forming method, different foaming agents, polyamideamine-epichlorohydrin (PAE) wet strength resin, and retention aids on the strength development of hand sheets. Only a slight, if any, improvement in dry tensile strength due to PAE resin was observed. PAE improved the wet strength of the water-laid sheets, and the retention systems had a minor but positive impact. Although wet strength was lower at given PAE addition levels, the trend was similar with the sheets foam-laid with an anionic foaming agent, except at high PAE levels. With the non-ionic surfactant the maximum level of wet strength was reached already at a low PAE addition level and use of retention aids decreased wet strength. Such differences between the water- and foam-laid sheets are most likely due to the chemical interactions between PAE, foaming agents, and other additives.


1997 ◽  
Vol 128 (2) ◽  
pp. 181-188
Author(s):  
H. S. POONI ◽  
R. FOSTER ◽  
B. ZHAO

Many biological experiments and almost all quantitative genetic studies draw conclusions from differences between families. Such differences are caused as much by heritable as by non-heritable sources. This paper investigates the impact of seed quality on the expression of quantitative variability among 20 highly inbred lines of Nicotiana rustica using ten seed categories representing different pollination times, seed sizes, seed positions in the capsule and seed maturity. Analysis of variance revealed that while the mean performance of the inbred lines remained more or less the same across all the seed categories, their individual performances differed widely, showing a highly significant interaction between lines and seed categories. This interaction accounted for up to 12% of the total variation and was largely attributable to late pollinations and immature seed. Seed categories were also the main source of heterogeneity among the within-line variances, but only immature seed lowered the correlation between the inbred means. In general, seed quality affected the developmental characters much less than the traits measured at or after flowering, and the expression of genetic variation was not critically affected by seed size or position. Immature seed, on the other hand, generated the highest level of unreliability in the comparative performance of lines and such seeds should therefore not be used in quantitative genetic experiments under any circumstances. Further implications of seed quality effects on the interpretation of genetic components are discussed in detail.


VASA ◽  
2019 ◽  
Vol 48 (3) ◽  
pp. 262-269 ◽  
Author(s):  
Christian-Alexander Behrendt ◽  
Tilo Kölbel ◽  
Thea Schwaneberg ◽  
Holger Diener ◽  
Ralf Hohnhold ◽  
...  

Abstract. Background: Worldwide prevalence of peripheral artery disease (PAD) is increasing and peripheral vascular intervention (PVI) has become the primary invasive treatment. There is evidence that multidisciplinary team decision-making (MTD) has an impact on in-hospital outcomes. This study aims to depict practice patterns and time changes regarding MTD of different medical specialties. Methods: This is a retrospective cross-sectional study design. 20,748 invasive, percutaneous PVI of PAD conducted in the metropolitan area of Hamburg (Germany) were consecutively collected between January 2004 and December 2014. Results: MTD prior to PVI was associated with lower odds of early unsuccessful termination of the procedures (Odds Ratio 0.662, p < 0.001). The proportion of MTD decreased over the study period (30.9 % until 2009 vs. 16.6 % from 2010, p < 0.001) while rates of critical limb-threatening ischemia (34.5 % vs. 42.1 %), patients´ age (70 vs. 72 years), PVI below-the-knee (BTK) (13.2 % vs. 22.4 %), and rates of severe TASC C/D lesions BTK (43.2 % vs. 54.2 %) increased (all p < 0.001). Utilization of MTD was different between medical specialties with lowest frequency in procedures performed by internists when compared to other medical specialties (7.1 % vs. 25.7 %, p < 0.001). Conclusions: MTD prior to PVI is associated with technical success of the procedure. Nonetheless, rates of MTD prior to PVI are decreasing during the study period. Future studies should address the impact of multidisciplinary vascular teams on long-term outcomes.


2020 ◽  
pp. 23-40
Author(s):  
I. V. Prilepskiy

Based on cross-country panel regressions, the paper analyzes the impact of external currency exposures on monetary policy, exchange rate regime and capital controls. It is determined that positive net external position (which, e.g., is the case for Russia) is associated with a higher degree of monetary policy autonomy, i.e. the national key interest rate is less responsive to Fed/ECB policy and exchange rate fluctuations. Therefore, the risks of cross-country synchronization of financial cycles are reduced, while central banks are able to place a larger emphasis on their price stability mandates. Significant positive impact of net external currency exposure on exchange rate flexibility and financial account liberalization is only found in the context of static models. This is probably due to the two-way links between incentives for external assets/liabilities accumulation and these macroeconomic policy tools.


2019 ◽  
pp. 109-123
Author(s):  
I. E. Limonov ◽  
M. V. Nesena

The purpose of this study is to evaluate the impact of public investment programs on the socio-economic development of territories. As a case, the federal target programs for the development of regions and investment programs of the financial development institution — Vnesheconombank, designed to solve the problems of regional development are considered. The impact of the public interventions were evaluated by the “difference in differences” method using Bayesian modeling. The results of the evaluation suggest the positive impact of federal target programs on the total factor productivity of regions and on innovation; and that regional investment programs of Vnesheconombank are improving the export activity. All of the investments considered are likely to have contributed to the reduction of unemployment, but their implementation has been accompanied by an increase in social inequality.


2018 ◽  
Vol 15 (1) ◽  
pp. 55-72
Author(s):  
Herlin Hamimi ◽  
Abdul Ghafar Ismail ◽  
Muhammad Hasbi Zaenal

Zakat is one of the five pillars of Islam which has a function of faith, social and economic functions. Muslims who can pay zakat are required to give at least 2.5 per cent of their wealth. The problem of poverty prevalent in disadvantaged regions because of the difficulty of access to information and communication led to a gap that is so high in wealth and resources. The instrument of zakat provides a paradigm in the achievement of equitable wealth distribution and healthy circulation. Zakat potentially offers a better life and improves the quality of human being. There is a human quality improvement not only in economic terms but also in spiritual terms such as improving religiousity. This study aims to examine the role of zakat to alleviate humanitarian issues in disadvantaged regions such as Sijunjung, one of zakat beneficiaries and impoverished areas in Indonesia. The researcher attempted a Cibest method to capture the impact of zakat beneficiaries before and after becoming a member of Zakat Community Development (ZCD) Program in material and spiritual value. The overall analysis shows that zakat has a positive impact on disadvantaged regions development and enhance the quality of life of the community. There is an improvement in the average of mustahik household incomes after becoming a member of ZCD Program. Cibest model demonstrates that material, spiritual, and absolute poverty index decreased by 10, 5, and 6 per cent. Meanwhile, the welfare index is increased by 21 per cent. These findings have significant implications for developing the quality of life in disadvantaged regions in Sijunjung. Therefore, zakat is one of the instruments to change the status of disadvantaged areas to be equivalent to other areas.


2015 ◽  
Vol 12 (3) ◽  
pp. 181-192 ◽  
Author(s):  
Pinar Yazgan ◽  
Deniz Eroglu Utku ◽  
Ibrahim Sirkeci

With the growing insurrections in Syria in 2011, an exodus in large numbers have emerged. The turmoil and violence have caused mass migration to destinations both within the region and beyond. The current "refugee crisis" has escalated sharply and its impact is widening from neighbouring countries toward Europe. Today, the Syrian crisis is the major cause for an increase in displacement and the resultant dire humanitarian situation in the region. Since the conflict shows no signs of abating in the near future, there is a constant increase in the number of Syrians fleeing their homes. However, questions on the future impact of the Syrian crisis on the scope and scale of this human mobility are still to be answered. As the impact of the Syrian crisis on host countries increases, so does the demand for the analyses of the needs for development and protection in these countries. In this special issue, we aim to bring together a number of studies examining and discussing human mobility in relation to the Syrian crisis.


2013 ◽  
Vol 12 (7) ◽  
pp. 451-459
Author(s):  
Ashraf Yehia El-Naggar ◽  
Mohamed A. Ebiad

Gasoline come primarily from petroleum cuts, it is the preferred liquid fuel in our lives. Two gasoline samples of octane numbers 91 and 95 from Saudi Arabia petrol stations were studied. This study was achieved at three different temperatures 20oC, 30oC and 50oC representing the change in temperatures of the different seasons of the year. Both the evaporated gases of light aromatic hydrocarbons (BTEX) of gasoline samples inside the tank were subjected to analyze qualitatively and quantitatively via capillary gas chromatography. The detailed hydrocarbon composition and the octane number of the studied gasoline samples were determined using detailed hydrocarbon analyzer. The idea of research is indicating the impact of light aromatic compounds in gasoline on the toxic effect of human and environment on the one hand, and on octane number of gasoline on the other hand. Although the value of octane number will be reduced but this will have a positive impact on the environment as a way to produce clean fuel.


Sign in / Sign up

Export Citation Format

Share Document