Sampling Designs and Estimators for Monitoring Vehicle Characteristics Under Limited Inspection Capacity

1997 ◽  
Vol 1581 (1) ◽  
pp. 72-81
Author(s):  
J. G. Kinateder ◽  
N. J. McMillan ◽  
J. E. Orban ◽  
B. O. Skarpness ◽  
D. Wells
Keyword(s):  
Metropolitan Area ◽  
Road Network ◽  
Sampling Design ◽  
Accurate Estimate ◽  
Statistical Problem ◽  
Motor Vehicles ◽  
Limited Resources ◽  
The Road ◽  
Efficient Sampling ◽  
On The Road

Estimating characteristics of motor vehicles and their occupants based on sampling a small portion of vehicles on the road is inherently a statistical problem. The problem has two components: construction of an efficient sampling design and application of an appropriate estimator to collected data. Constructing the sampling design should involve optimal utilization of limited resources to maximize information collected. The selected estimator should provide the most precise and accurate estimate of the characteristic of interest. Four sampling designs and two estimators for determining the proportion of vehicles with a particular characteristic are compared. A simulation example comparing these designs and estimators is provided. The illustration is based on a hypothetical road network typical of the primary transportation system in a metropolitan area of 500,000 to 1 million persons. Some suggestions for choosing appropriate sampling designs and estimators for other vehicle categorization problems are provided.

scholarly journals Understanding Air Pollution from Induced Traffic during and after the Construction of a New Highway: Case Study of Highway 25 in Montreal

2017 ◽  
Vol 2017 ◽  
pp. 1-14 ◽  
Author(s):  
Md. Shohel Reza Amin ◽  
Umma Tamima ◽  
Luis Amador Jimenez
Keyword(s):  
Air Pollution ◽  
Metropolitan Area ◽  
Road Network ◽  
Traffic Density ◽  
Air Contaminants ◽  
Construction Period ◽  
Close Vicinity ◽  
The Road ◽  
On The Road

This study demonstrates through a case study that detailed analyses, even after the construction of a project, are feasible using current technologies and available data. A case study of highway 25 is used to illustrate the method and verify the levels of air contaminants from additionally induced traffic during and after the construction of highway. Natural traffic growth was removed from the effect of observed gas emissions by comparing observed levels on other further locations in the same metropolitan area. This study estimates air pollution from the additional traffic during and after the construction of A-25 extension project. NO2 levels were spatially interpolated during peak and off-peak hour traffic and traffic density simulated on the road network for four scenarios. Comparing the four scenarios, it was found that levels of NO2 concentrations were reduced at neighbor areas due to less traffic during the construction period. Levels of NO2 after the construction were higher than those in 2008. The simulated traffic density for four scenarios revealed that traffic density was significantly increased on both arterial and access roads within the close vicinity of the extension project during and after its construction.

scholarly journals Politics, industry, and tourism: The conceptual construction of the blue highway

2020 ◽  
pp. 002252662097950
Author(s):  
Fredrik Bertilsson
Keyword(s):  
Road Network ◽  
Power Plants ◽  
Community Building ◽  
Atlantic Coast ◽  
Political Agenda ◽  
The Road ◽  
Conceptual Construction ◽  
On The Road ◽  
Post War

This article contributes to the research on the expansion of the Swedish post-war road network by illuminating the role of tourism in addition to political and industrial agendas. Specifically, it examines the “conceptual construction” of the Blue Highway, which currently stretches from the Atlantic Coast of Norway, traverses through Sweden and Finland, and enters into Russia. The focus is on Swedish governmental reports and national press between the 1950s and the 1970s. The article identifies three overlapping meanings attached to the Blue Highway: a political agenda of improving the relationships between the Nordic countries, industrial interests, and tourism. Political ambitions of Nordic community building were clearly pronounced at the onset of the project. Industrial actors depended on the road for the building of power plants and dams. The road became gradually more connected with the view of tourism as the motor of regional development.

scholarly journals THE PENETRATION OF ENGINEERING BY ECONOMICS: McFADDEN AND THE TRANSFORMATION OF ROAD DEMAND ESTIMATION

2021 ◽  
Vol 43 (2) ◽  
pp. 262-278
Author(s):  
Ariane Dupont-Kieffer ◽  
Sylvie Rivot ◽  
Jean-Loup Madre
Keyword(s):  
Road Network ◽  
Road Construction ◽  
Demand Estimation ◽  
Demand Modeling ◽  
The Road ◽  
Collective Decisions ◽  
The Face ◽  
Decision Making Processes ◽  
On The Road ◽  
The 1960S

The golden age of road demand modeling began in the 1950s and flourished in the 1960s in the face of major road construction needs. These macro models, as well as the econometrics and the data to be processed, were provided mainly by engineers. A division of tasks can be observed between the engineers in charge of estimating the flows within the network and the transport economists in charge of managing these flows once they are on the road network. Yet the inability to explain their decision-making processes and individual drives gave some room to economists to introduce economic analysis, so as to better understand individual or collective decisions between transport alternatives. Economists, in particular Daniel McFadden, began to offer methods to improve the measure of utility linked to transport and to inform the engineering approach. This paper explores the challenges to the boundaries between economics and engineering in road demand analysis.

scholarly journals Measures to optimize traffic and the environment. Calculations of environmental safety on a given section of the Rostov-on-Don road network

2020 ◽  
pp. 68-77
Author(s):  
R. S. Durov ◽  
◽  
E. V. Varnakova ◽  
K. O. Kobzev ◽  
◽  
...  
Keyword(s):  
Road Network ◽  
Road Transport ◽  
Environmental Safety ◽  
Environmental Indicators ◽  
Nox Emissions ◽  
The Road ◽  
Before And After ◽  
Reduce Emissions ◽  
On The Road ◽  
State Of The Environment

Introduction. One of the most pressing socio-economic problems is the state of the environment, which affects the living conditions of many people. The article deals with the problem areas of the intersection of 20-ya Liniya street – Sholokhov Avenue in Rostov-on-Don. Problem Statement. The purpose of this paper is to improve environmental safety at the intersection of 20-ya Liniya street – Sholokhov Avenue in Rostov-on-Don by reducing emissions from road transport through the proposed measures to reorganize traffic on this section of the road network. Theoretical Part. The article provides an assessment of environmental and road safety on the road network section before applying the proposed measures. The measures are listed and justified that would help improve the conditions for road transport at the selected intersection and reduce emissions from road transport, which would improve environmental safety. The calculation of environmental indicators was made after the proposed measures to reduce NOx emissions by cars. Conclusion. The article analyzes the environmental indicators before and after the events, and then compares them. Based on the analysis and calculations, it is determined how much the proposed measures to optimize traffic will help reduce NOx emissions by cars.

scholarly journals ARDUINO based accident prevention and auto intimation system

2020 ◽  
Vol 17 (3) ◽  
pp. 1275
Author(s):  
Palanisamy R ◽  
PLS Sai Kumar ◽  
Mekala Paavan Kiran ◽  
Ashutosh Mahto ◽  
Md. Irfan ◽  
...  
Keyword(s):  
Collision Avoidance ◽  
Black Box ◽  
Climatic Conditions ◽  
The Other ◽  
Motor Vehicles ◽  
The Road ◽  
Ir Sensors ◽  
Collision Mitigation ◽  
Collision Avoidance System ◽  
On The Road

<p>Often modern cars have a collision avoidance system built into them known as Pre-Crash System, or Collision Mitigation System in order to reduce the collision. But majority of vehicles on the road, especially heavy motor vehicles lack in such a system. In this paper, the implementation of the Collision Avoidance System is to reduce the risks of collisions at the hairpin bend on a Hilly track, Ghats, or other Zero visibility turns. The proposed system contains a set of IR sensors, LEDs, etc. It uses four IR sensors, which are placed on either side of the hairpin bend. The sensors are mutually exclusive and are connected to LEDs through wires. Based on the output of sensors, the LEDs will glow and start alerting the other vehicle approaching from the other end, Hence the drivers will decrease their speeds which would help in preventing collision. The LEDs will help the drivers in detecting the position of  the vehicles on either side of the bend. During climatic conditions like fog, snow, etc, the visibility of the drivers would decrease due to which they will not be able to see the LEDs, Hence, a collision may take place. To bring help as soon as possible to the injured, we have also made a proposed system which would alert the nearby hospitals that an accident has taken place. We have used Arduino UNO, GSM sim module and these will be kept inside a black box which will be inside the, car safe from breakage during the accident.<strong></strong></p>

scholarly journals Two-Layer Routing for High-Voltage Powerline Inspection by Cooperated Ground Vehicle and Drone

2019 ◽  
Author(s):  
Yao Liu ◽  
Jianmai Shi ◽  
Zhong Liu ◽  
Jincai Huang ◽  
Tianren Zhou
Keyword(s):  
High Voltage ◽  
Road Network ◽  
Inspection System ◽  
Large Area ◽  
Technical Improvement ◽  
Routing Problem ◽  
Ground Vehicle ◽  
The Road ◽  
Battery Capacity ◽  
On The Road

A novel high-voltage powerline inspection system is investigated, which consists of the cooperated ground vehicle and drone. The ground vehicle acts as a mobile platform that can launch and recycle the drone, while the drone can fly over the powerline for inspection within limited endurance. This inspection system enables the drone to inspect powerline networks in a very large area. Both vehicle&rsquo; route in the road network and drone&rsquo;s routes along the powerline network have to be optimized for improving the inspection efficiency, which generates a new two-layer point-arc routing problem. Two constructive heuristics are designed based on &ldquo;Cluster First, Rank Second&rdquo; and &ldquo;Rank First, Split Second&rdquo;. Then local search strategies are developed to further improve the quality of the solution. To test the performance of the proposed algorithms, practical cases with different-scale are designed based on the road network and powerline network of Ji&rsquo;an, China. Sensitivity analysis on the parameters related with the drone&rsquo;s inspection speed and battery capacity is conducted. Computational results indicate that technical improvement on the inspection sensor is more important for the cooperated ground vehicle and drone system.

scholarly journals Analysis of Traffic Evolution on Road Networks of a Roundabout

2020 ◽  
Vol 2020 ◽  
pp. 1-18
Author(s):  
Tolesa Hundesa Muleta ◽  
Legesse Lemecha Obsu
Keyword(s):  
Traffic Congestion ◽  
Road Network ◽  
Road Networks ◽  
Point Of View ◽  
Traffic Dynamics ◽  
Demand And Supply ◽  
The Road ◽  
On The Road ◽  
Detailed Mathematical Analysis ◽  
Control Traffic

In this paper, the analyses of traffic evolution on the road network of a roundabout having three entrances and three exiting legs are conducted from macroscopic point of view. The road networks of roundabouts are modeled as a merging and diverging types 1×2 and 2×1 junctions. To study traffic evolution at junction, two cases have been considered, namely, demand and supply limited cases. In each case, detailed mathematical analysis and numerical tests have been presented. The analysis in the case of demand limited showed that rarefaction wave fills the portion of the road network in time. In the contrary, in supply limited case, traffic congestion occurs at merging junctions and shock wave propagating back results in reducing the performance of a roundabout to control traffic dynamics. Also, we illustrate density and flux profiles versus space discretization at different time steps via numerical simulation with the help of Godunov scheme.

Determining Passenger Car Equivalent for Motorcycle at Mid-Block of Sesetan Road

2015 ◽  
Vol 776 ◽  
pp. 95-100
Author(s):  
I. Gusti Raka Purbanto
Keyword(s):  
Motor Vehicles ◽  
Heavy Vehicles ◽  
Highway Capacity ◽  
Passenger Car ◽  
Highway Capacity Manual ◽  
The Road ◽  
Traffic Conditions ◽  
Mode Share ◽  
Passenger Car Equivalent ◽  
On The Road

Motorcycle dominates traffic in Bali, particularly in urban roads, which occupy more than 85% of mode share. The three types of vehicles, i.e. motorcycles, heavy and light vehicles share the roadways together. Under mixed traffic conditions, motorcycle may be travelling in between and alongside two consecutive motor vehicles. Considering such a situation, passenger car equivalent values should be examined thoroughly. This study aims to determine passenger car equivalent (PCEs) of motorcycle at mid-block of Sesetan Road. Three approaches are used to examine the PCEs values. This study found that the PCE of motorcycles are in a range between 0.2 and 0.4. This values are about the same to the existing PCE of the Indonesian Highway Capacity Manual (1997). This study also pointed out that motorcyclists and car drivers may behave differently to the existence of motorcycles. Car drivers are more aware than motorcyclists on the existence of motorcycle on the road. Further, more samples are required to obtain comprehensive results. In addition, the presence of heavy vehicles need to be considered for future study.

Sign in / Sign up

Export Citation Format

Share Document