Influence of the dynamic crystallization conditions on the martensitic transformation in the Ti40.7Hf9.5Ni39.8Cu10shape memory alloy

2009 ◽  
Vol 100 (3) ◽  
pp. 356-358 ◽  
Author(s):  
Natalia Resnina ◽  
Sergey Belyaev ◽  
Alexander Shelyakov
Keyword(s):  
Martensitic Transformation ◽  
Dynamic Crystallization ◽  
Crystallization Conditions

In situ observation of the martensitic transformation in (Mg,Y)-PSZ

1986 ◽  
Vol 44 ◽  
pp. 500-501
Author(s):  
R-R. Lee
Keyword(s):  
Martensitic Transformation ◽  
High Strength ◽  
Nucleation And Growth ◽  
In Situ Observation ◽  
Considerable Potential ◽  
Transmission Electron ◽  
Structural Applications ◽  
Applied Stresses ◽  
Kinetics Of

Partially-stabilized ZrO2 (PSZ) ceramics have considerable potential for advanced structural applications because of their high strength and toughness. These properties derive from small tetragonal ZrO2 (t-ZrO2) precipitates in a cubic (c) ZrO2 matrix, which transform martensitically to monoclinic (m) symmetry under applied stresses. The kinetics of the martensitic transformation is believed to be nucleation controlled and the nucleation is always stress induced. In situ observation of the martensitic transformation using transmission electron microscopy provides considerable information about the nucleation and growth aspects of the transformation.

Evidence for ordered Fe3Ni

1987 ◽  
Vol 45 ◽  
pp. 216-217
Author(s):  
K.B. Reuter ◽  
D.B. Williams ◽  
J.I. Goldstein
Keyword(s):  
Experimental Data ◽  
Martensitic Transformation ◽  
Electron Diffraction ◽  
Room Temperature ◽  
Direct Evidence ◽  
Transformation Product ◽  
Iron Meteorites ◽  
X Ray ◽  
Ni Content ◽  
Temperature Transformation

In the Fe-Ni system, although ordered FeNi and ordered Ni3Fe are experimentally well established, direct evidence for ordered Fe3Ni is unconvincing. Little experimental data for Fe3Ni exists because diffusion is sluggish at temperatures below 400°C and because alloys containing less than 29 wt% Ni undergo a martensitic transformation at room temperature. Fe-Ni phases in iron meteorites were examined in this study because iron meteorites have cooled at slow rates of about 10°C/106 years, allowing phase transformations below 400°C to occur. One low temperature transformation product, called clear taenite 2 (CT2), was of particular interest because it contains less than 30 wtZ Ni and is not martensitic. Because CT2 is only a few microns in size, the structure and Ni content were determined through electron diffraction and x-ray microanalysis. A Philips EM400T operated at 120 kV, equipped with a Tracor Northern 2000 multichannel analyzer, was used.

Structure of a new orthorhombic phase in NiTi: Mn shape memory alloys

1990 ◽  
Vol 48 (4) ◽  
pp. 1000-1001
Author(s):  
Jenö Beyer ◽  
Lajos Tóth
Keyword(s):  
Martensitic Transformation ◽  
Structural Changes ◽  
High Vacuum ◽  
Intermetallic Phase ◽  
Orthorhombic Phase ◽  
Transformation Process ◽  
Analytical Electron ◽  
Analytical Electron Microscope ◽  
Crystallographic Structures ◽  
Ternary Additions

The structural changes during reversible martensitic transformation of near-equiatomic NiTi alloys can best be studied in TEM at around room temperature. Ternary additions like Mn offer this possibility by suppressing the Ms temperature below RT. Besides the stable intermetallic phases (Ti2Ni, TiNi, TiNi3) several metastable phases with various crystallographic structures (rhombohedral, hexagonal, monoclinic, cubic) have also been reported to precipitate due to suitable annealing procedures.TiNi:Mn samples with 0.9 and 1.3 at% Mn were arc melted in argon atmosphere and homogenized at 948 °C for 72 hours in high vacuum in an infrared furnace. After spark cutting slices of 0.2 mm, TEM specimens were prepared by electrochemical polishing with the twin-jet technique in methanol - perchloric acid electrolyte. The TEM study was carried out in a JEOL 200 CX analytical electron microscope.In this paper a new intermetallic phase is reported which has been observed in both samples by TEM during the martensitic transformation process.

Atomic Order and Martensitic Transformation in Cu-Al-Be Shape Memory Alloys

1995 ◽  
Vol 05 (C8) ◽  
pp. C8-973-C8-978
Author(s):  
M. Jurado ◽  
Ll. Mañosa ◽  
A. González-Comas ◽  
C. Stassis ◽  
A. Planes
Keyword(s):  
Martensitic Transformation ◽  
Shape Memory Alloys ◽  
Shape Memory ◽  
Atomic Order

Nature of thermal hysteresis of martensitic transformation in aged Cu-Mn-A1 alloy

2003 ◽  
Vol 112 ◽  
pp. 495-498
Author(s):  
V. V. Kokorin ◽  
L. E. Kozlova ◽  
A. N. Titenko
Keyword(s):  
Martensitic Transformation ◽  
Thermal Hysteresis

Study of the martensitic transformation on a Cr-Ni-Mo-Al-Ti steel for different thermomechanical paths

2001 ◽  
Vol 11 (PR4) ◽  
pp. Pr4-189-Pr4-196 ◽  
Author(s):  
F. Azzouz ◽  
G. Cailletaud ◽  
F. D. Fischer ◽  
A. Pineau ◽  
K. Tanaka
Keyword(s):  
Martensitic Transformation
Sign in / Sign up

Export Citation Format

Share Document