Preparation of CdS Thin Films by Reactive Sputtering Method

Shinku ◽  
1974 ◽  
Vol 17 (1) ◽  
pp. 19-22 ◽  
Author(s):  
Hiroharu HIRABAYASHI ◽  
Minoru NOGAMI
Keyword(s):  
Thin Films ◽  
Reactive Sputtering ◽  
Cds Thin Films

Chemical synthesis and study of structural and optoelectronic properties of CdS thin films: Effect of SILAR growth cycles

2015 ◽  
Vol 9 (3) ◽  
pp. 2461-2469
Author(s):  
S. R. Gosavi ◽  
K. B. Chaudhari
Keyword(s):  
Thin Films ◽  
Average Crystallite Size ◽  
X Ray Diffraction ◽  
Silar Method ◽  
Growth Cycles ◽  
Glass Substrates ◽  
Layer Adsorption ◽  
Cds Thin Films ◽  
Structural And Optoelectronic Properties ◽  
Deposited Film

CdS thin films were deposited on glass substrates by using successive ionic layer adsorption and reaction (SILAR) method at room temperature. The effect of SILAR growth cycles on structural, morphological, optical and electrical properties of the films has been studied.  The thickness of the deposited film is measured by employing weight difference method. The X-ray diffraction (XRD) and field emission scanning electron microscopy (FE-SEM) studies showed that all the films exhibit polycrystalline nature and are covered well with glass substrates. The values of average crystallite size were found to be 53 nm, 58 nm, 63 nm and 71 nm corresponding to the thin films deposited with 30, 40, 50 and 60 SILAR growth cycles respectively. From the UV–VIS spectra of the deposited thin films, it was seen that both the absorption properties and energy bandgap of the films changes with increasing number of SILAR growth cycles. A decrease of electrical resistivity has been observed with increasing SILAR growth cycle. 

Single Crystal, High Band Gap CdS Thin Films Grown by RF Magnetron Sputtering in Argon Atmosphere for Solar Cell Applications

2018 ◽  
Vol 10 (3) ◽  
pp. 03005-1-03005-6 ◽  
Author(s):  
Rupali Kulkarni ◽  
◽  
Amit Pawbake ◽  
Ravindra Waykar ◽  
Ashok Jadhawar ◽  
...  
Keyword(s):  
Thin Films ◽  
Solar Cell ◽  
Magnetron Sputtering ◽  
Single Crystal ◽  
Band Gap ◽  
Rf Magnetron Sputtering ◽  
Argon Atmosphere ◽  
Cds Thin Films ◽  
High Band

Substrate bias effects during R-F sputtering of Y-Ba-Cu-O films

1990 ◽  
Vol 5 (4) ◽  
pp. 677-679 ◽  
Author(s):  
A. J. Drehman ◽  
M. W. Dumais
Keyword(s):  
Thin Films ◽  
Strontium Titanate ◽  
Reactive Sputtering ◽  
Negative Bias ◽  
Superconducting Thin Films ◽  
Substrate Bias ◽  
Composition Control ◽  
Zero Resistance

Y-Ba-Cu-O films were made by R-F diode sputtering using a single oxide target. It was found that if a small negative bias is applied to the substrate, the etching associated with reactive sputtering is significantly reduced. This results in better composition control and uniformity, which are quite important for the formation of superconducting thin films. Films deposited on strontium titanate, when annealed in oxygen, become superconducting with zero resistance at 89 K.

Optical properties of indium doped CdS thin films

1988 ◽  
Vol 17 (1) ◽  
pp. 55-64 ◽  
Author(s):  
E. Bertran ◽  
A. Lousa ◽  
M. Varela ◽  
M.V. García-Cuenca ◽  
J.L. Morenza
Keyword(s):  
Thin Films ◽  
Optical Properties ◽  
Cds Thin Films

Thermally evaporated CdS thin films for CdS/CdTe solar cells: Effect of substrate temperature on CdS layer

2021 ◽  
Vol 273 ◽  
pp. 115406
Author(s):  
A.A.I. Lakmal ◽  
R.K.K.G.R.G. Kumarasinghe ◽  
V.A. Seneviratne ◽  
Jiann-Yeu Chen ◽  
Jenn-Ming Song ◽  
...  
Keyword(s):  
Thin Films ◽  
Solar Cells ◽  
Substrate Temperature ◽  
Cdte Solar Cells ◽  
Cds Thin Films

Structural, optical and electrical properties of Ni-doped CdS thin films prepared by spray pyrolysis

2013 ◽  
Vol 557 ◽  
pp. 53-59 ◽  
Author(s):  
A. Rmili ◽  
F. Ouachtari ◽  
A. Bouaoud ◽  
A. Louardi ◽  
T. Chtouki ◽  
...  
Keyword(s):  
Thin Films ◽  
Electrical Properties ◽  
Spray Pyrolysis ◽  
Optical And Electrical Properties ◽  
Cds Thin Films
Sign in / Sign up

Export Citation Format

Share Document