scholarly journals Implementation of modern tools for the improvement of the road infrastructure on the Trans-European road network – road safety inspection (RSI)

2019 ◽  
Vol 65 (2) ◽  
pp. 49-53
Author(s):  
Miladin Nešić ◽  
Dušan Mladenović ◽  
Mirjana Ilić ◽  
Ivana Andrijanić ◽  
Mirko Koković ◽  
...  

The European Directive on the Road Infrastructure Safety Improvement (2008/96/EC) has established the implementation of appropriate procedures as the basic tools for improving the road infrastructure on the trans-European road network. The Law on Roads (2018) prescribes the implementation of the following procedures: Road safety impact assessment; Road safety audit; Road safety inspection; Risk mapping; Black spot identification; and In depth road accident studies. The Law on Roads also prescribes that the Minister will prescribe the manner of implementation and the contents of the Evaluation, Audit and Independent Assessment reports, as well as the manner of determining the major risk portions and the identification and ranking of hazardous sites (black spots). Since the method of implementation and the content of the report are not yet prescribed, the authors contributed in this paper to defining the manner of implementation and content of the traffic safety report on the example of the section of the highway, as the highest category of state road. In the framework of the training of auditors and auditors, among others, a pilot project was carried out for the safety of traffic on the part of the E-75 (A1) highway, about 2,7 km ahead of the Mali Požarevac loop, including the loop. The verified part of the highway also includes a ramp with a toll ramp, service facility, overpass, bridge, etc., so the selected checked part is representative for defining a recommendation for the mode of implementation and the model for the preparation of the report.

Author(s):  
Tetiana Bondar ◽  
Olga Belenchuk ◽  
Yevhen Tepliuk ◽  
Oleksandr Pyna

Road safety management begins with a detailed analysis of accidents, which is reflected in Article 24 of the Law of Ukraine “On Road Traffic” which states that when performing repairs and maintenance of roads, streets and railway crossings road maintenance organizations in the first place should take measures for road safety on the basis of accounting and analysis of road accidents, results of inspections and surveys of roads, streets and railway crossings, and especially in emergency and dangerous areas and in places of concentration of road accidents. The problem of reducing the accident rate and reducing the number of victims of road accidents during the maintenance of roads has so far been solved mainly by identifying areas (places) of concentration of accidents with the development of measures to improve road conditions and improve the organization of traffic on them and conducting annual commission spring and autumn inspections of the road network by representatives of road organizations and the police. However, the areas of concentration of road accidents were not fully covered on the road network of local significance due to the lack of accurate reference of the places of accident in the accident registration cards, as well as they were not identified on the streets and roads of cities and other settlements due to the absence of any criteria for their identification and therefore the maximum efficiency from introduction of management of sites (places) of concentration of road accident isn’t reached. The article analyzes the criteria for determining the areas of concentration of accidents on public roads in different periods, examines the dynamics of the number of areas of concentration of accidents and considers other modern opportunities for effective traffic safety management, in particular, inspection (inspection) of existing roads.


2011 ◽  
Vol 97-98 ◽  
pp. 360-366
Author(s):  
Jian Cheng Sun ◽  
Lin Song Wang

The subject Introduced the analysis method of the black-spot, established the black-spot discriminant model, And gave its algorithm. According to the characteristics of China's traffic flow, we develope black-spot database, so that the work of the black-spot identification can be quickly carried out。The Road black-spot traffic accidents describes the road sections which have significantly higher accident rate than the average level . Road black-spots identification, analysis and processing are widely considered to be the most efficient way to prevent traffic accidents. The identification of Road accident black-spots is the concern of road design, road safety review, operation management, and security studies , The research studies of road black-spot identification,and determines risk road sections, so that countermeasures can be put forward, and we can achieve the goals of design improvement, strengthen management, improvement of road safety operation environment, decrease of the number of traffic accidents and improvement of the whole road traffic safety performance.


2012 ◽  
Vol 23 (1) ◽  
pp. 71-82
Author(s):  
Kazimierz Jamroz

Abstract To ensure that road transport safety measures are effective and efficient, forecast tools should be applied to help with strategic decision-making. Models of road safety measures provide such tools. The paper presents a proposed macro model of road accident casualties. The proposed models of road accident fatalities are built from a database covering more than fifty countries worldwide. The concepts of model design can be used for developing factor-based models to describe strategic societal risk on the road networks of selected countries worldwide. One of the concepts was applied to model the number of road accident fatalities. The analyses used Smeed’s model and its modifications developed for the needs of this analysis.


Electronics ◽  
2019 ◽  
Vol 8 (3) ◽  
pp. 341 ◽  
Author(s):  
Miha Ambrož ◽  
Uroš Hudomalj ◽  
Alexander Marinšek ◽  
Roman Kamnik

Measuring friction between the tyres of a vehicle and the road, often and on as many locations on the road network as possible, can be a valuable tool for ensuring traffic safety. Rather than by using specialised equipment for sequential measurements, this can be achieved by using several low-cost measuring devices on vehicles that travel on the road network as part of their daily assignments. The presented work proves the hypothesis that a low cost measuring device can be built and can provide measurement results comparable to those obtained from expensive specialised measuring devices. As a proof of concept, two copies of a prototype device, based on the Raspberry Pi single-board computer, have been developed, built and tested. They use accelerometers to measure vehicle braking deceleration and include a global positioning receiver for obtaining the geolocation of each test. They run custom-developed data acquisition software on the Linux operating system and provide automatic measurement data transfer to a server. The operation is controlled by an intuitive user interface consisting of two illuminated physical pushbuttons. The results show that for braking tests and friction coefficient measurements the developed prototypes compare favourably to a widely used professional vehicle performance computer.


2020 ◽  
Vol 15 (2) ◽  
pp. 31-48
Author(s):  
Vilma Jasiūnienė ◽  
Rasa Vaiškūnaitė

Network-wide road safety assessment throughout the whole network is one of the four road infrastructure safety management procedures regulated by Directive 2019/1936/EC of the European Parliament and of the Council of 23 October 2019 Аmending Directive 2008/96/EC on Road Infrastructure Safety Management and one of the methods for determining the direction of investment in road safety. So far, the implementation of the procedure has been lightly regulated and adapted using various road safety indicators. The paper describes the evaluation of road accident data that is one of the criteria for conducting a network-wide road safety assessment. Taking into consideration that networkwide road safety assessment is a proactive road safety activity, the paper proposes to conduct road safety assessment considering the expected fatal accident density. Such assessment makes it possible to assess the severity of accidents, and the use of the predicted road accident data on calculating the introduced road accident rate contributing to the prevention of accidents. The paper describes both the empirical Bayes method for predicting road accidents and the application of one of the road safety indicators – the expected fatal accident density – to determine five road safety categories across the road network. The paper demonstrates the application of the proposals submitted to Lithuanian highways using road accident and traffic data for the period 2014–2018.


In India road accidents are very serious problem because of large population and high traffic density of vehicles. Most of the road accidents occur mainly due to the negligence of driver and poor infrastructure only a few accidents occur due to the technical error of vehicles. The main purpose of this research paper is prevention of road traffic accidents and improvement of road safety in Shimla. Road safety is very important aspect of today’s life, so it is important that everybody should aware about road safety. To do this study a section of 12km length is chosen between Panthaghati to Dhalli in district Shimla on NH 5 where accidents black spots are identified for the section by analyzing secondary data used to prevent road accidents. In this study primary data is used for observing the road conditions and secondary data is used to find accidents black spot. Black Spot is a point or a place on the road where road accident occurs repeatedly one after another which is known as accident black spot. To identify these black spots we use weighted severity index (WSI) method. It is one the most reliable and effective method for determining the most proven accidents black spots. Shimla is a hilly area and it has narrow roads, blind curve and black spots which increase the chances of road traffic accidents. In past recent years road traffic accidents are increasing in Shimla and this study deals with identification of major issues causing road traffic accidents. This research paper helps to improve the road safety in Shimla because in this study the analysis has been done to identify the major problems responsible for gradually increasing road accidents. This research paper is also used in future research paper as reference purpose and it will also provide an overview to other researchers who want do their research on similar kind of topics.


2020 ◽  
Vol 50 (1) ◽  
pp. 215-236
Author(s):  
Joanna Wachnicka ◽  
Katarzyna Palikowska

AbstractThe article presents the application of the GWR (Geographically Weighted Regression) model to the description of differences in the level of road traffic safety in individual counties on the example of the Kuyavian-Pomeranian Voivodeship. The GWR model developed for counties, taking into account the diversity of NUTS 3 regions, can be a helpful tool for traffic safety management in voivodships and lower administrative units, and such an approach has not yet been applied.


2021 ◽  
Vol 1202 (1) ◽  
pp. 012034
Author(s):  
Valentina Amare ◽  
Juris Smirnovs

Abstract The highest number of road accidents occurs at junctions. One of the aims of traffic organisation is to improve traffic safety in these areas. Based on a variety of indices – road capacity, points of conflict, number, and severity of road traffic accidents – different alternatives for junctions are evaluated. However, the road network has many junctions and roads serve to travel from point "A" to point "B" at a given time. Therefore, one of the most important tasks when addressing the issue of road safety is to find a rational way of improving the safety without losing the importance of the road. The aim of this paper is to analyse the impact of different junctions on the road network and basing on actual data develop a method for the evaluation of different types of junctions with respect to road class.


Author(s):  
Araoye Olarinkoye Ajiboye ◽  
Olusola Joseph Kolawole ◽  
Adeola Adebanji Adebanjo

The recent road crashes along the main routes in Oyo State have drawn the attention of people towards the role and statutory responsibilities of Federal Road Safety Corps (FRSC). Therefore, this research was conducted to assess the statutory duties of FRSC aimed at limiting the number of road crashesin Oyo State. This work was limited to 3 Local Government Areas (LGAs) out of 11 LGAs that make up Ibadan and its environs. The study adopted simple random sampling technique using well-structured questionnaires to elicit information regarding the statutory duties of FRSC, a major road transport enforcement agency in Nigeria. From110 respondents ranging from commercial drivers, private vehicle owners, commercial motorcyclists, commuters, and road accident victims, 103 questionnaires were retrieved and were found analysable. The collected data was processed using descriptive data analysis techniques. It was found that out of 22 statutory duties of FRSC, only seven were being discharged effectively. Hence, it can easily be inferred that the operational performance of FRSC is not satisfactory. Therefore, this study recommends that the authorities should give prompt medical attention and care to accident victims on the road and should also enforce speed limits with the use of speed limit devices. The use of mobile phone while driving should be discouraged and the use of seatbelts should be promoted. At the same time, individuals, NGOs and corporate bodies should be given a free hand to contribute in reducing the number of road accidents. The use of sirens, beacon lights and flashers should be well-controlled and the struggle against fake driving licences should be enhanced.


Road accidents are one of the causes of disability, injury and death. As per the latest road accident data released by the Ministry of Road Transport & Highways (MoRTH), the total number of accidents increased by 2.5 percent from 4,89,400 in 2014 to 5,01,423 in 2015. The analysis reveals that about 1,374 accidents and 400 deaths take place every day. Every single year, it has been estimated that over three lakh persons die and 10-15 million persons are injured in road accidents throughout the world. According to the analyses, statistics of global accident indicate that in developing countries, the rate of fatality per licensed vehicle is very high as compared to that of industrialized countries. A road stretch of about 500 metres in length in which either ten fatalities or five road accidents (involving grievous injuries/fatalities) took place during last three calendar years, on National Highways is considered as a road accident black spot according to MoRTH, Government of India. In the present study the identified black spots of Haridwar and Dehradun city were included comprising of a total of 81 black spots out of which there were 49 black spots which were identified in Dehradun followed by 32 black spots in Haridwar. The present study was an attempt to carry out the prioritization of these identified blackspots with respect to the factors that were considered to evaluate accident prone locations on the road. The identified black spots were then prioritized using the classification scheme (ranking from low to high).The study reveals that the advantage of using this approach for prioritizing accident black spots on roads is that it requires very less additional data other than the road network maps.


Sign in / Sign up

Export Citation Format

Share Document