scholarly journals Effect of different adsorption/desorption properties and biodegradability of chemicals on the performance of powdered activated carbon (PACT) processes

2007 ◽  
Vol 5 (2) ◽  
pp. 71-78 ◽  
Author(s):  
Yoichi Nakano ◽  
Tri Widjaja ◽  
Tomonori Miyata ◽  
Wataru Nishijima ◽  
Mitsumasa Okada
Keyword(s):  
Activated Carbon ◽  
Powdered Activated Carbon ◽  
Adsorption Desorption

The adsorption-desorption mechanisms on the powdered activated carbon (PAC) of an anionic textile dye (RBY 3GL)

2017 ◽  
Vol 70 ◽  
pp. 134-138
Author(s):  
Ahmet Gürses ◽  
Duygu Yalvaç ◽  
Kübra Güneş ◽  
Elif Şahin ◽  
Metin Açıkyıldız
Keyword(s):  
Activated Carbon ◽  
Powdered Activated Carbon ◽  
Textile Dye ◽  
Adsorption Desorption

Adsorption/desorption properties of activated carbon on toluene with operation condition and characteristics

2015 ◽  
Vol 14 (1) ◽  
pp. 66-72 ◽  
Author(s):  
Seo-Hyun Pak ◽  
◽  
Myung-Seop Shin ◽  
Hyun-Jung Kim ◽  
Yong-Woo Jeon
Keyword(s):  
Activated Carbon ◽  
Operation Condition ◽  
Adsorption Desorption

Effect of operational modes on the removal of a synthetic organic chemical by powdered activated carbon during ultrafiltration

2001 ◽  
Vol 1 (5-6) ◽  
pp. 39-47
Author(s):  
Y. Matsui ◽  
A. Yuasa ◽  
F. Colas
Keyword(s):  
Activated Carbon ◽  
Cross Flow ◽  
Powdered Activated Carbon ◽  
Organic Chemical ◽  
Filtration Cycle ◽  
Dead End ◽  
Synthetic Organic Chemical ◽  
The Cross ◽  
Short Time ◽  
Operational Modes

The effects of operational modes on the removal of a synthetic organic chemical (SOC) in natural water by powdered activated carbon (PAC) during ultrafiltration (UF) were studied, through model simulations and experiments. The removal percentage of the trace SOC was independent of its influent concentration for a given PAC dose. The minimum PAC dosage required to achieve a desired effluent concentration could quickly be optimized from the C/C0 plot as a function of the PAC dosage. The cross-flow operation was not advantageous over the dead-end regarding the SOC removal. Added PAC was re-circulated as a suspension in the UF loop for only a short time even under the cross-flow velocity of gt; 1.0 m/s. The cross-flow condition did not contribute much to the suspending of PAC. The pulse PAC addition at the beginning of a filtration cycle resulted in somewhat better SOC removal than the continuous PAC addition. The increased NOM loading on PAC which was dosed in a pulse and stayed longer in the UF loop could possibly further decrease the adsorption rate.

Fate of Toxic Organic Compounds in Activated Sludge and Integrated PAC Systems

1987 ◽  
Vol 19 (3-4) ◽  
pp. 471-482 ◽  
Author(s):  
W. J. Weber ◽  
B. E. Jones ◽  
L. E. Katz
Keyword(s):  
Activated Carbon ◽  
Activated Sludge ◽  
Organic Compounds ◽  
Powdered Activated Carbon ◽  
Carbon Adsorption ◽  
Powdered Carbon ◽  
Benzene Toluene ◽  
Adsorptive Properties ◽  
Carbon Concentrations ◽  
Toxic Organic Compounds

The addition of powdered activated carbon (PAC) to activated sludge treatment systems to enhance removal of specific toxic organic compounds from wastewater was evaluated. Nine organic compounds encompassing a range of solubility, volatility, biodegradability, and adsorptive properties were studied. Kate and equilibrium investigations were conducted to quantify the removal mechanisms of volatilization, biodegradation, biosorption, and carbon adsorption. Results from steady-state bioreactor studies showed that the addition of less than 100 mg/ℓ powdered activated carbon to the influent did not enhance the removal of the biodegradable target compounds investigated: benzene, toluene, ethylbenzene, o-xylene, chlorobenzene, and nitrobenzene. Significantly improved removals of the poorly degradable and non-biodegradable compounds 1,2-dichlorobenzene, 1,2,4-trichlorobenzene, and lindane occurred at influent powdered carbon concentrations in the 12.5 to 25 mg/ℓ range. Influent powdered carbon concentrations of 100 mg/ℓ effected overall removals of greater than 90%. The addition of powdered activated carbon not only reduced effluent concentrations but also reduced the amounts of the volatile compounds stripped to the atmosphere.

scholarly journals Hazardous cyanobacteria integrity response to velocity gradient and powdered activated carbon in water treatment plants

2021 ◽  
Vol 773 ◽  
pp. 145110
Author(s):  
Samylla Oliveira ◽  
Allan Clemente ◽  
Indira Menezes ◽  
Amanda Gois ◽  
Ismael Carloto ◽  
...  
Keyword(s):  
Activated Carbon ◽  
Water Treatment ◽  
Velocity Gradient ◽  
Powdered Activated Carbon ◽  
Water Treatment Plants

scholarly journals Removal of organic pollutants from produced water by batch adsorption treatment

2021 ◽  
Author(s):  
Eman Hashim Khader ◽  
Thamer Jassim Mohammed ◽  
Nourollah Mirghaffari ◽  
Ali Dawood Salman ◽  
Tatjána Juzsakova ◽  
...  
Keyword(s):  
Activated Carbon ◽  
Produced Water ◽  
Oxygen Demand ◽  
Powdered Activated Carbon ◽  
Pollutant Removal ◽  
Operating Conditions ◽  
Isotherm Models ◽  
Batch Adsorption ◽  
Order Kinetic ◽  
Zeolite X

AbstractThis paper studied the adsorption of chemical oxygen demand (COD), oil and turbidity of the produced water (PW) which accompanies the production and reconnaissance of oil after treating utilizing powdered activated carbon (PAC), clinoptilolite natural zeolite (CNZ) and synthetic zeolite type X (XSZ). Moreover, the paper deals with the comparison of pollutant removal over different adsorbents. Adsorption was executed in a batch adsorption system. The effects of adsorbent dosage, time, pH, oil concentration and temperature were studied in order to find the best operating conditions. The adsorption isotherm models of Langmuir, Freundlich and Temkin were investigated. Using pseudo-first-order and pseudo-second-order kinetic models, the kinetics of oil sorption and the shift in COD content on PAC and CNZ were investigated. At a PAC adsorbent dose of 0.25 g/100 mL, maximum oil removal efficiencies (99.57, 95.87 and 99.84 percent), COD and total petroleum hydrocarbon (TPH) were identified. Moreover, when zeolite X was used at a concentration of 0.25 g/100 mL, the highest turbidity removal efficiency (99.97%) was achieved. It is not dissimilar to what you would get with PAC (99.65 percent). In comparison with zeolites, the findings showed that adsorption over PAC is the most powerful method for removing organic contaminants from PW. In addition, recycling of the consumed adsorbents was carried out in this study to see whether the adsorbents could be reused. Chemical and thermal treatment will effectively regenerate and reuse powdered activated carbon and zeolites that have been eaten. Graphic abstract

Sign in / Sign up

Export Citation Format

Share Document