scholarly journals Simulation of Fire in Super High-Rise Hospitals Using Fire Dynamics Simulator (FDS)

2020 ◽  
Vol 17 (3) ◽  
pp. em200
Author(s):  
Abdolrasoul Rahmani ◽  
Mohammad Salem
Keyword(s):  
Fire Dynamics ◽  
High Rise ◽  
Fire Dynamics Simulator

Full-Scale Experimental and Numerical Simulation of Fire in a High-Rise Residential Building

2012 ◽  
Vol 594-597 ◽  
pp. 2251-2256
Author(s):  
Jun Tao Yang ◽  
Yun Yang ◽  
Jing Liang
Keyword(s):  
Numerical Simulation ◽  
Residential Building ◽  
Full Scale ◽  
Fire Dynamics ◽  
High Rise ◽  
Fire Dynamics Simulator ◽  
Smoke Spread

Fires in high-rise residential building were studied experimentally by using an actual building with similar inner structure. The temperatures in the building interior corridors, elevators and staircases exit were measured. At the same time the fires in this construction were simulated by using FDS (Fire Dynamics Simulator) software, the variance trends of the temperatures in different positions within high-rise residential building were studied and compared with the experiment results, and the results of this simulation are proved to be valid. The results can be used to support the study of effectively controlling of the smoke spread and evacuation in high-rise residential building.

Evaluation of Positive Pressure Ventilation for High-Rise Buildings in Compartment Fire Situation

2012 ◽  
Vol 446-449 ◽  
pp. 2908-2913 ◽  
Author(s):  
Xiao Feng ◽  
Yan Feng Li
Keyword(s):  
Positive Pressure Ventilation ◽  
Optimal Rate ◽  
Positive Pressure ◽  
Airflow Rate ◽  
Compartment Fire ◽  
Fire Dynamics ◽  
High Rise ◽  
Fire Dynamics Simulator ◽  
Fire Condition ◽  
Fire Scenarios

An alternate means for protecting high-rise stairwell enclosures using the positive pressure ventilation is evaluated. An analysis performed by using the Fire Dynamics Simulator (FDS) model shows that the positive pressure ventilation can be an effective method for protecting the stairwell enclosure. Three types of ventilation methods are compared in the same fire condition and the best one is determined based on the decrease of temperature in the stairwell. The optimal rate for ventilating the stair requires optimization of the airflow rate according to postulated fire scenarios for the building and the desired performance with respect to tenability conditions within the stair.

scholarly journals Control method of mechanical smoke emission in high-rise building corridor

2021 ◽  
Vol 25 (6 Part A) ◽  
pp. 4099-4106
Author(s):  
Can Chen
Keyword(s):  
Neural Network ◽  
Convolutional Neural Network ◽  
Traditional Method ◽  
Control Method ◽  
Smoke Control ◽  
Fire Dynamics ◽  
Smoke Emission ◽  
High Rise ◽  
Fire Dynamics Simulator ◽  
High Rise Building

The traditional method has a large control error in the corridor mechanical smoke control method. Therefore, a multi-task convolutional neural network-based high-rise building corridor mechanical smoke control method is proposed. Through the mechanical smoke exhaust principle of high-rise building corridors, the threshold of mechanical smoke exhaust is set to predict the mechanical smoke exhaust volume of high-rise building corridors. The movement of mechanical smoke in high-rise building corridors is simulated according to fire dynamics simulator to determine the turbulence state of mechanical smoke in high-rise building corridors. Input the mechanical smoke exhaust data of high-rise building corridors into the multi-task convolutional neural network to complete the mechanical smoke exhaust control of high-rise building corridors. Experimental results show that the maximum accuracy of this method is about 98%, and the control time is always less than 1 second.

CFD Simulation of Smoke Spread Through Elevator Shafts During Fires in High Rise Buildings

2015 ◽  
Author(s):  
Qize He ◽  
Ofodike A. Ezekoye ◽  
Beth Tubbs ◽  
Carl Baldassarra
Keyword(s):  
Cfd Simulation ◽  
Gas Temperature ◽  
Fire Dynamics ◽  
High Rise ◽  
Fire Dynamics Simulator ◽  
Smoke Spread ◽  
Outflow Rate ◽  
Computational Fluid Dynamics Cfd ◽  
Temperature And Pressure ◽  
Two Phases

Smoke spread through the elevator shafts of high rise buildings has been numerically investigated using the Fire Dynamics Simulator (FDS), which is a computational fluid dynamics (CFD) program suitable for fire induced heat and mass transfer. A model of a high rise building was developed and a fire was set at the first level. The smoke spread process through the elevator shafts was evaluated. The process can be divided into two phases. In the first phase, the smoke gradually fills the shafts, and the gas temperature and pressure in the shafts are transient. After this phase, the smoke fully fills the shafts, the temperature and pressure in the shaft are almost steady, which suggests that the smoke inflow rate equals the outflow rate. Throughout the process, the spatial distributions of temperature and pressure in the elevator shaft under fire situations were reported. The hot fire product gases entering the shaft causes a stack effect, which transports smoke to the upper levels. A method of partially enclosing the elevator lobbies was also investigated by the CFD simulation. The results were compared with the unenclosed situation, and showed that enclosing lobbies not only increases the time needed for the smoke to fully fill the shafts, but also reduces the temperature and pressure differences in the shafts.

Assessment of Fire Dynamics Simulator for Heat Flux and Flame Heights Predictions from Fires in SBI Tests

2008 ◽  
Vol 46 (2) ◽  
pp. 291-306 ◽  
Author(s):  
Jianping Zhang ◽  
Michael Delichatsios ◽  
Matthieu Colobert
Keyword(s):  
Heat Flux ◽  
Fire Dynamics ◽  
Fire Dynamics Simulator

An evaluation of fire-plume properties simulated with the Fire Dynamics Simulator (FDS) and the Clark coupled wildfire model

2006 ◽  
Vol 36 (11) ◽  
pp. 2894-2908 ◽  
Author(s):  
Ruiyu Sun ◽  
Mary Ann Jenkins ◽  
Steven K Krueger ◽  
William Mell ◽  
Joseph J Charney
Keyword(s):  
Fluid Dynamics ◽  
Data Sets ◽  
Fire Plume ◽  
Fire Dynamics ◽  
Fire Model ◽  
Fire Dynamics Simulator ◽  
Physically Based ◽  
Vertical Grid ◽  
Simplifying Assumptions ◽  
Good Agreement

Before using a fluid dynamics physically based wildfire model to study wildfire, validation is necessary and model results need to be systematically and objectively analyzed and compared to real fires, which requires suitable data sets. Observational data from the Meteotron experiment are used to evaluate the fire-plume properties simulated by two fluid dynamics numerical wildfire models, the Fire Dynamics Simulator (FDS) and the Clark coupled atmosphere–fire model. Comparisons based on classical plume theory between numerical model and experimental Meteotron results show that plume theory, because of its simplifying assumptions, is a fair but restricted rendition of important plume-averaged properties. The study indicates that the FDS, an explicit and computationally demanding model, produces good agreement with the Meteotron results even at a relatively coarse horizontal grid size of 4 m for the FDS, while the coupled atmosphere–fire model, a less explicit and less computationally demanding model, can produce good agreement, but that the agreement is sensitive to surface vertical-grid sizes and the method by which the energy released from the fire is put into the atmosphere.

Numerical Analysis of Evacuation from Taiwan Hsuehshan Tunnel Fire

2014 ◽  
Vol 955-959 ◽  
pp. 1840-1849
Author(s):  
Cherng Shing Lin ◽  
Kuo Da Chou
Keyword(s):  
Numerical Simulation ◽  
Fire Protection ◽  
Quantitative Data ◽  
Relevant Information ◽  
Simulation Software ◽  
Escape Time ◽  
Fire Dynamics ◽  
Fire Dynamics Simulator ◽  
Tunnel Fire ◽  
Protection Engineering

Taiwan is an island nation with numerous mountains and few plains. Consequently, the number of tunnel projects has gradually increased and tunnels are becoming longer. Because the number of large tunnels that exceed 1000 meters in length has increased, the effective escape and evacuation of people during a fire and the minimization of injury are crucial to fire protection engineers. For this study, an actual example of a fire that occurred in Hsuehshan Tunnel (12.9 kilometers and the longest tunnel in Southeast Asia) was used. A fire dynamics simulator (FDS) including numerical simulation software was applied to analyze this fire and the relevant information that was collected was compared and verified. The fire site simulation showed the escape and evacuation of people during the fire. Simulations of the original fire site and the possible escape time for people with various attributes were discussed to provide quantitative data and recommendations based on the analysis results, which can serve as a reference for fire protection engineering.

scholarly journals Risco de incêndio numa fossa de resíduos sólidos

2011 ◽  
pp. 263-269
Author(s):  
Emanuel Ferreira ◽  
João Paulo C. Rodrigues ◽  
Leça Coelho
Keyword(s):  
Fire Dynamics ◽  
Fire Dynamics Simulator ◽  
Smoke Transport

Neste artigo é analisado o risco de incêndio numa instalação de tratamento de resíduos sólidos urbanos, nomeadamente ao nível da sua fossa de deposição desses resíduos. Foram realizadas simulações do desenvolvimento do incêndio usando um modelo de duas zonas, o Consolidated Model of Fire and Smoke Transport (CFAST) e um modelo de campo, o Fire Dynamics Simulator and Smokeview (FDS-SMV), ambos do National Institute of Standards and Technology (NIST), sendo os resultados analisados e discutidos.

Assessment of the Fire Dynamics Simulator for Modeling Fire Suppression in Engine Rooms of Ships with Low-Pressure Water Mist

2019 ◽  
Vol 56 (3) ◽  
pp. 1315-1352 ◽  
Author(s):  
Roberto Bellas ◽  
Miguel A. Gómez ◽  
Arturo González-Gil ◽  
Jacobo Porteiro ◽  
José L. Míguez
Keyword(s):  
Fire Suppression ◽  
Low Pressure ◽  
Water Mist ◽  
Fire Dynamics ◽  
Fire Dynamics Simulator ◽  
Pressure Water
Sign in / Sign up

Export Citation Format

Share Document