scholarly journals Trajectory Tracking Performance Analysis of Underwater Manipulator for Autonomous Manipulation

2020 ◽  
Vol 34 (3) ◽  
pp. 180-193
Author(s):  
Junbo Chae ◽  
Taekyeong Yeu ◽  
Yeongjun Lee ◽  
Yoongen Lee ◽  
Suk-Min Yoon
Keyword(s):  
Performance Analysis ◽  
Trajectory Tracking ◽  
Tracking Performance ◽  
Autonomous Manipulation ◽  
Underwater Manipulator

scholarly journals Adaptive PD Sliding Mode Control For 4 DOF SCARA Variant

2021 ◽  
Author(s):  
Manjeet Tummalapalli
Keyword(s):  
Sliding Mode Control ◽  
Trajectory Tracking ◽  
High Speed ◽  
Sliding Mode ◽  
Adaptive Controller ◽  
Degree Of Freedom ◽  
Tracking Performance ◽  
Advantages And Disadvantages ◽  
Model Free ◽  
Adaptive Law

This project proposes a new SCARA variant with 4 degree of freedom. The proposed variant is achieved by swapping joint 2 and joint 3 of the standard SCARA robots. An adaptive controller is defined based on the advantages and disadvantages of PD, and SMC controllers.The purpose of the project is to understand the dynamics of the variant and to track the performance for trajectories. Simulations for tracking performance are carried under linear and circular trajectories. The variant is studied over the three controllers; PD, PD-SMC and A-PD-SMC. The variant under the adaptive controller is most efficient in terms of tracking performance and the control inputs to the system. The system is simulated under high speed and with the influence of friction at the joints. The control gains are held constant for both the trajectories and hence the controller is able to perform good under changing trajectories. Due to the use of the adaptive law, the system is at the ease of implementation and since no priori knowledge if the system is needed, it is model free. Therefore, the proposed adaptive PD-SMC has proven to provide good, robust trajectory tracking.

Effect of Short-Term Weather Predictions on Model Predictive Trajectory Tracking Performance of Unmanned Surface Vessels

2020 ◽  
Author(s):  
Benjamin Armentor ◽  
Joseph Stevens ◽  
Nathan Madsen ◽  
Andrew Durand ◽  
Joshua Vaughan
Keyword(s):  
Trajectory Tracking ◽  
Wind Waves ◽  
Tracking Error ◽  
Tracking Performance ◽  
Model Predictive Controller ◽  
Prediction Horizon ◽  
Surface Vessels ◽  
Waves And Currents ◽  
Predictive Controller ◽  
Disturbance Model

Abstract For mobile robots, such as Autonomous Surface Vessels (ASVs), limiting error from a target trajectory is necessary for effective and safe operation. This can be difficult when subjected to environmental disturbances like wind, waves, and currents. This work compares the tracking performance of an ASV using a Model Predictive Controller that includes a model of these disturbances. Two disturbance models are compared. One prediction model assumes the current disturbance measurements are constant over the entire prediction horizon. The other uses a statistical model of the disturbances over the prediction horizon. The Model Predictive Controller performance is also compared to a PI-controlled system under the same disturbance conditions. Including a disturbance model in the prediction of the dynamics decreases the trajectory tracking error over the entire disturbance spectrum, especially for longer horizon lengths.

The Leveling Position Control of a Four-Axial Active Pneumatic Isolation System Using PWM-Driving Parallel Dual-On/Off Valves

2011 ◽  
Vol 110-116 ◽  
pp. 3176-3183 ◽  
Author(s):  
Mao Hsiung Chiang ◽  
Hao Ting Lin
Keyword(s):  
Trajectory Tracking ◽  
Vibration Isolation ◽  
Position Control ◽  
Controller Design ◽  
Sliding Mode ◽  
Tracking Performance ◽  
Trajectory Tracking Control ◽  
Isolation System ◽  
Adaptive Sliding Mode Controller ◽  
Novel Concept

This study aims to develop a leveling position control of an active PWM-controlled pneumatic isolation table system. A novel concept using parallel dual-on/off valves with PWM control signals is implemented to realize active control and to improve the conventional pneumatic isolation table that supported by four pneumatic cushion isolators. In this study, the cushion isolators are not only passive vibration isolation devices, but also pneumatic actuators in active position control. Four independent closed-loop position feedback control system are designed and implemented for the four axial isolators. In this study, on/off valves are used, and PWM is realized by software. Therefore, additional hardware circuit is not required to implement PWM and not only cost down but also reach control precision of demand. In the controller design, the Fourier series-based adaptive sliding-mode controller with H∞ tracking performance is used to deal with the uncertainty and time-varying problems of pneumatic system. Finally, the experiments on the pneumatic isolation table system for synchronous position and trajectory tracking control, including no-load and loading conditions, and synchronous position control with master-slave method, are implemented in order to verify that the controller for each cushion isolator can realize good position and trajectory tracking performance.

scholarly journals Improving the trajectory tracking performance of autonomous orchard vehicles using wheel slip compensation

2016 ◽  
Vol 146 ◽  
pp. 149-164 ◽  
Author(s):  
Gokhan Bayar ◽  
Marcel Bergerman ◽  
Erhan i. Konukseven ◽  
Ahmet B. Koku
Keyword(s):  
Trajectory Tracking ◽  
Tracking Performance ◽  
Wheel Slip
Sign in / Sign up

Export Citation Format

Share Document