Water Fingering Into an Oil-Wet Porous Medium Saturated with Oil At Connate Water Saturation

1984 ◽  
Vol 39 (4) ◽  
pp. 517-521 ◽  
Author(s):  
L. Paterson ◽  
V. Hornof ◽  
G. Neale
Keyword(s):  
Porous Medium ◽  
Water Saturation ◽  
Connate Water

Distribution of the Oil Phase Obtained Upon Imbibition of Water

1964 ◽  
Vol 4 (01) ◽  
pp. 49-55 ◽  
Author(s):  
Pietro Raimondi ◽  
Michael A. Torcaso
Keyword(s):  
Primary Production ◽  
Relative Permeability ◽  
Water Saturation ◽  
Initial Conditions ◽  
Flow Behavior ◽  
Phase System ◽  
Residual Oil ◽  
Two Phase ◽  
Connate Water ◽  
Phase Water

Abstract The distribution of the oil phase in Berea sandstone resulting from increasing and decreasing the water saturation by imbibition was investigated Three types of distribution were recognized: trapped, normal and lagging. The amount of oil in each of these distributions was determined as a function of saturation by carrying out a miscible displacement in the oil phase under steady-state conditions of saturation. These conditions were maintained by flowing water and oil simultaneously in given ratios and by using a displacing solvent having essentially the same density and viscosity as the oil.A correlation shows the amount of trapped oil at any saturation to be directly proportional to the conventional residual oil saturation Sir The factor of proportionality is related to the fractional permeability to the water phase. Part of the oil which was not trapped was displaced in a piston- like manner (normal part) and part was eluted gradually (lagging part). The observed phenomena are more than of mere academic importance. Oil which is trapped may well provide the fuel essential for forward combustion and thus be beneficial. On the contrary, in tertiary recovery operations, it is this trapped oil which seems to make current techniques uneconomic. Introduction A typical oilfield may initially contain connate water and oil. After a period of primary production water often enters the field either from surrounding aquifers or from surface injection. During primary production evolution and establishment of a free gas saturation usually occurs. The effect and importance of this third phase is fully recognized. However, this investigation is limited to a two- phase system, one wetting phase (water) and one non-wetting phase (oil). The increase in water content of a water-wet system is termed imbibition. In a relative permeability-saturation diagram such as the one shown in Fig. 1, the initial conditions of the field would he represented by a point below a water saturation of about 35 per cent, i.e., where the imbibition and the drainage curves to the non-wetting phase nearly coincide. When water enters the field the relative permeability to oil decreases along the imbibition curve. At watered-out conditions the relative permeability to the oil becomes zero. At this point a considerable amount of oil, called residual oil, (about 35 per cent in Fig. 1) remains unrecovered. Any attempt to produce this oil will require that its saturation be increased. In Fig. 1 this would mean retracing the imbibition curve upwards. In addition, processes like alcohol and fire flooding, which can be employed at any stage of production, involve the complete displacement of connate water and an increase, or imbibition, of water saturation ahead of the displacing front. Thus, in several types of oil production it is the imbibition-relative permeability curve which rules the flow behavior. For this reason a knowledge of the distribution of the non-wetting phase, as obtained through imbibition, whether "coming down" or "going up" on the imbibition curve, is important. SPEJ P. 49^

scholarly journals Cortex Effect on Vacuum Drying Process of Porous Medium

2013 ◽  
Vol 2013 ◽  
pp. 1-8 ◽  
Author(s):  
Zhijun Zhang ◽  
Shiwei Zhang ◽  
Tianyi Su ◽  
Shuangshuang Zhao
Keyword(s):  
Mass Transfer ◽  
Porous Medium ◽  
Fruits And Vegetables ◽  
Water Saturation ◽  
Coupled Model ◽  
Water Evaporation ◽  
Vacuum Drying ◽  
Vapor Pressures ◽  
Drying Process ◽  
Medium Vacuum

Corns, fruits, and vegetables are usually used as porous medium in drying process. But in fact, it must be considered as the cortex effect on mass transfer because the mass transfer of cortex is very difficult than inner medium. Based on the theory of heat and mass transfer, a coupled model for the porous medium vacuum drying process with cortex effect is constructed. The model is implemented and solved using COMSOL software. The water evaporation rate is determined using a nonequilibrium method with the rate constant parameterKrthat has been studied. The effects of different vapor pressures (1000, 5000, and 9000 Pa), initial moisture contents (0.3, 0.4, and 0.5 water saturation), drying temperatures (323, 333, and 343 K), and intrinsic permeability for cortex part (10−13, 10−14, 10−15 m2) on vacuum drying process were studied. The results facilitate a better understanding of the porous medium vacuum drying process that nearer to the reality.

Proxy models for evaluation of permeability, three-phase relative permeability, and capillary pressure curves from rate-transient data

SIMULATION ◽  
2019 ◽  
pp. 003754971985713 ◽  
Author(s):  
Zhenzihao Zhang ◽  
Turgay Ertekin
Keyword(s):  
Capillary Pressure ◽  
Relative Permeability ◽  
Functional Relationship ◽  
Water Saturation ◽  
Petrophysical Properties ◽  
Laboratory Measurements ◽  
Connate Water ◽  
Three Phase ◽  
Transient Data ◽  
Critical Gas Saturation

This study developed a data-driven forecasting tool that predicts petrophysical properties from rate-transient data. Traditional estimations of petrophysical properties, such as relative permeability (RP) and capillary pressure (CP), strongly rely on coring and laboratory measurements. Coring and laboratory measurements are typically conducted only in a small fraction of wells. To contend with this constraint, in this study, we develop artificial neural network (ANN)-based tools that predict the three-phase RP relationship, CP relationship, and formation permeability in the horizontal and vertical directions using the production rate and pressure data for black-oil reservoirs. Petrophysical properties are related to rate-transient data as they govern the fluid flow in oil/gas reservoirs. An ANN has been proven capable of mimicking any functional relationship with a finite number of discontinuities. To generate an ANN representing the functional relationship between rate-transient data and petrophysical properties, an ANN structure pool is first generated and trained. Cases covering a wide spectrum of properties are then generated and put into training. Training of ANNs in the pool and comparisons among their performance yield the desired ANN structure that performs the most effectively among the ANNs in the pool. The developed tool is validated with blind tests and a synthetic field case. Reasonable predictions for the field cases are obtained. Within a fraction of second, the developed ANNs infer accurate characteristics of RP and CP for three phases as well as residual saturation, critical gas saturation, connate water saturation, and horizontal permeability with a small margin of error. The predicted RP and CP relationship can be generated and applied in history matching and reservoir modeling. Moreover, this tool can spare coring expenses and prolonged experiments in most of the field analysis. The developed ANNs predict the characteristics of three-phase RP and CP data, connate water saturation, residual oil saturation, and critical gas saturation using rate-transient data. For cases fulfilling the requirement of the tool, the proposed technique improves reservoir description while reducing expenses and time associated with coring and laboratory experiments at the same time.

The Role of Connate Water Saturation in VAPEX Process

2008 ◽  
Vol 47 (02) ◽  
Author(s):  
B.B. Maini ◽  
S.R. Etminan ◽  
R. Kharrat
Keyword(s):  
Water Saturation ◽  
Connate Water

scholarly journals Relationships among air-water interfacial area, capillary pressure, and water saturation for a sandy porous medium

2006 ◽  
Vol 42 (3) ◽  
Author(s):  
Mark L. Brusseau ◽  
Sheng Peng ◽  
Gregory Schnaar ◽  
Molly S. Costanza-Robinson
Keyword(s):  
Porous Medium ◽  
Capillary Pressure ◽  
Water Saturation ◽  
Interfacial Area
Sign in / Sign up

Export Citation Format

Share Document