scholarly journals Experimental investigation of two-phase relative permeability of gas and water for tight gas carbonate under different test conditions

2019 ◽  
Vol 74 ◽  
pp. 23 ◽  
Author(s):  
Teng Wan ◽  
Shenglai Yang ◽  
Lu Wang ◽  
Liting Sun
Keyword(s):  
Relative Permeability ◽  
Factor Model ◽  
Ct Scanning ◽  
Wettability Alteration ◽  
Tight Gas ◽  
Tight Sandstone ◽  
Two Phase ◽  
Slippage Effect ◽  
Tight Carbonate ◽  
Relative Permeability Curves

Currently, tight carbonate gas reservoir has received little attention due to few discoveries of them. In this study, gas–water two-phase relative permeability was measured under two different conditions: High Temperature High Pore Pressure (HTHPP – 80 °C, 38 MPa), as well as Ambient Condition (AC), using whole core samples of tight gas carbonate. Relative permeability curves obtained at HTHPP showed two contrary curve profiles of gas relative permeability, corresponding to the distinctive micro-pore structure acquired from CT-Scanning. Then, based on Klinkenberg theory and a newly developed slip factor model for tight sandstone, slippage effect under AC is calibrated and the overestimation of gas relative permeability prove up to 41.72%–52.34% in an assumed heterogeneity. In addition, relative permeability curves obtained at HTHPP switch to higher gas saturation compared to that under AC with the rock wettability change from water-wet to less water-wet. And the wettability alteration is believed to be caused by charge change on mineral surface.

scholarly journals Productivity Influence Factors of Tight Sandstone Gas Reservoir with Water Produced

Geofluids ◽  
2021 ◽  
Vol 2021 ◽  
pp. 1-9
Author(s):  
Yongchao Xue ◽  
Qingshuang Jin ◽  
Hua Tian
Keyword(s):  
Pressure Gradient ◽  
Relative Permeability ◽  
Gas Flow ◽  
Influence Factors ◽  
Stress Sensitivity ◽  
Consumption Pattern ◽  
Tight Sandstone ◽  
Gas Reservoir ◽  
Two Phase ◽  
Start Up

Finding ways to accelerate the effective development of tight sandstone gas reservoirs holds great strategic importance in regard to the improvement of consumption pattern of world energy. The pores and throats of the tight sandstone gas reservoir are small with abundant interstitial materials. Moreover, the mechanism of gas flow is highly complex. This paper is based on the research of a typical tight sandstone gas reservoir in Changqing Oilfield. A strong stress sensitivity in tight sandstone gas reservoir is indicated by the results, and it would be strengthened with the water production; at the same time, a rise to start-up pressure gradient would be given by the water producing process. With the increase in driving pressure gradient, the relative permeability of water also increases gradually, while that of gas decreases instead. Following these results, a model of gas-water two-phase flow has been built, keeping stress sensitivity, start-up pressure gradient, and the change of relative permeability in consideration. It is illustrated by the results of calculations that there is a reduction in the duration of plateau production period and the gas recovery factor during this period if the stress sensitivity and start-up pressure gradient are considered. In contrast to the start-up pressure gradient, stress sensitivity holds a greater influence on gas well productivity.

An Equation To Predict Two-Phase Relative Permeability Curves in Fractures

2010 ◽  
Author(s):  
Andres Chima ◽  
Efren Antonio Chavez Iriarte ◽  
Zuly Himelda Calderon Carrillo
Keyword(s):  
Relative Permeability ◽  
Two Phase ◽  
Relative Permeability Curves

Lowering the phase-trap damage in tight-gas reservoirs by using interfacial tension (IFT) reducers

2013 ◽  
Vol 53 (1) ◽  
pp. 363
Author(s):  
Yangfan Lu ◽  
Hassan Bahrami ◽  
Mofazzal Hossain ◽  
Ahmad Jamili ◽  
Arshad Ahmed ◽  
...  
Keyword(s):  
Relative Permeability ◽  
Reservoir Simulation ◽  
Water Saturation ◽  
Tight Gas ◽  
Gas Reservoirs ◽  
Tight Gas Reservoirs ◽  
Water Based ◽  
Tight Formations ◽  
Tight Reservoirs ◽  
Relative Permeability Curves

Tight-gas reservoirs have low permeability and significant damage. When drilling the tight formations, wellbore liquid invades the formation and increases water saturation of the near wellbore area and significantly deceases permeability of this area. Because of the invasion, the permeability of the invasion zone near the wellbore in tight-gas formations significantly decreases. This damage is mainly controlled by wettability and capillary pressure (Pc). One of the methods to improve productivity of tight-gas reservoirs is to reduce IFT between formation gas and invaded water to remove phase trapping. The invasion of wellbore liquid into tight formations can damage permeability controlled by Pc and relative permeability curves. In the case of drilling by using a water-based mud, tight formations are sensitive to the invasion damage due to the high-critical water saturation and capillary pressures. Reducing the Pc is an effective way to increase the well productivity. Using the IFT reducers, Pc effect is reduced and trapped phase can be recovered; therefore, productivity of the TGS reservoirs can be increased significantly. This study focuses on reducing phase-trapping damage in tight reservoirs by using reservoir simulation to examine the methods, such use of IFT reducers in water-based-drilled tight formations that can reduce Pc effect. The Pc and relative permeability curves are corrected based on the reduced IFT; they are then input to the reservoir simulation model to quantitatively understand how IFT reducers can help improve productivity of tight reservoirs.

scholarly journals Relative Permeability Characteristics During Carbon Capture and Sequestration Process in Low-Permeable Reservoirs

Materials ◽  
2020 ◽  
Vol 13 (4) ◽  
pp. 990
Author(s):  
Mingxing Bai ◽  
Lu Liu ◽  
Chengli Li ◽  
Kaoping Song
Keyword(s):  
Relative Permeability ◽  
Carbon Capture ◽  
Oil And Gas ◽  
Co2 Flooding ◽  
Two Phase ◽  
Permeability Characteristics ◽  
Gas Recovery ◽  
Miscible Flooding ◽  
Relative Permeability Curves ◽  
Carbon Dioxide Co2

The injection of carbon dioxide (CO2) in low-permeable reservoirs can not only mitigate the greenhouse effect on the environment, but also enhance oil and gas recovery (EOR). For numerical simulation work of this process, relative permeability can help predict the capacity for the flow of CO2 throughout the life of the reservoir, and reflect the changes induced by the injected CO2. In this paper, the experimental methods and empirical correlations to determine relative permeability are reviewed and discussed. Specifically, for a low-permeable reservoir in China, a core displacement experiment is performed for both natural and artificial low-permeable cores to study the relative permeability characteristics. The results show that for immiscible CO2 flooding, when considering the threshold pressure and gas slippage, the relative permeability decreases to some extent, and the relative permeability of oil/water does not reduce as much as that of CO2. In miscible flooding, the curves have different shapes for cores with a different permeability. By comparing the relative permeability curves under immiscible and miscible CO2 flooding, it is found that the two-phase span of miscible flooding is wider, and the relative permeability at the gas endpoint becomes larger.

The Characteristics and Impacts Factors of Relative Permeability Curves in High Temperature and Low-Permeability Limestone Reservoirs

2014 ◽  
Vol 1010-1012 ◽  
pp. 1676-1683 ◽  
Author(s):  
Bin Li ◽  
Wan Fen Pu ◽  
Ke Xing Li ◽  
Hu Jia ◽  
Ke Yu Wang ◽  
...  
Keyword(s):  
Relative Permeability ◽  
Oil Recovery ◽  
Water Saturation ◽  
Phase Region ◽  
Two Phase ◽  
Experimental Conditions ◽  
Irreducible Water Saturation ◽  
Productive Water ◽  
Relative Permeability Curves ◽  
Water Cut

To improve the understanding of the influence of effective permeability, reservoir temperature and oil-water viscosity on relative permeability and oil recovery factor, core displacement experiments had been performed under several experimental conditions. Core samples used in every test were natural cores that came from Halfaya oilfield while formation fluids were simulated oil and water prepared based on analyze data of actual oil and productive water. Results from the experiments indicated that the shape of relative permeability curves, irreducible water saturation, residual oil saturation, width of two-phase region and position of isotonic point were all affected by these factors. Besides, oil recovery and water cut were also related closely to permeability, temperature and viscosity ratio.

A Semianalytical Approach for Analysis of Wells Exhibiting Multiphase Transient Linear Flow: Application to Field Data

SPE Journal ◽  
2020 ◽  
Vol 25 (06) ◽  
pp. 3265-3279
Author(s):  
Hamidreza Hamdi ◽  
Hamid Behmanesh ◽  
Christopher R. Clarkson
Keyword(s):  
Numerical Model ◽  
Relative Permeability ◽  
History Matching ◽  
Volatile Oil ◽  
Low Permeability ◽  
Two Phase ◽  
Linear Flow ◽  
Field Case ◽  
Three Phase ◽  
Relative Permeability Curves

Summary Rate-transient analysis (RTA) is a useful reservoir/hydraulic fracture characterization method that can be applied to multifractured horizontal wells (MFHWs) producing from low-permeability (tight) and shale reservoirs. In this paper, we applied a recently developed three-phase RTA technique to the analysis of production data from an MFHW completed in a low-permeability volatile oil reservoir in the Western Canadian Sedimentary Basin. This RTA technique is used to analyze the transient linear flow regime for wells operated under constant flowing bottomhole pressure (BHP) conditions. With this method, the slope of the square-root-of-time plot applied to any of the producing phases can be used to directly calculate the linear flow parameter xfk without defining pseudovariables. The method requires a set of input pressure/volume/temperature (PVT) data and an estimate of two-phase relative permeability curves. For the field case studied herein, the PVT model is constructed by tuning an equation of state (EOS) from a set of PVT experiments, while the relative permeability curves are estimated from numerical model history-matchingresults. The subject well, an MFHW completed in 15 stages, produces oil, water, and gas at a nearly constant (measured downhole) flowing BHP. This well is completed in a low-permeability,near-critical volatile oil system. For this field case, application of the recently proposed RTA method leads to an estimate of xfk that is in close agreement (within 7%) with the results of a numerical model history match performed in parallel. The RTA method also provides pressure–saturation (P–S) relationships for all three phases that are within 2% of those derived from the numerical model. The derived P–S relationships are central to the use of other RTA methods that require calculation of multiphase pseudovariables. The three-phase RTA technique developed herein is a simple-yet-rigorous and accurate alternative to numerical model history matching for estimating xfk when fluid properties and relative permeability data are available.

scholarly journals Towards Relative Permeability Measurements in Tight Gas Formations

2020 ◽  
Vol 146 ◽  
pp. 05001
Author(s):  
Denis Dzhafarov ◽  
Benjamin Nicot
Keyword(s):  
Steady State ◽  
Relative Permeability ◽  
Water Saturation ◽  
Gas Permeability ◽  
Tight Gas ◽  
Two Phase ◽  
Pressure Step ◽  
Injection Ratio ◽  
Insight Into ◽  
Good Agreement

Relative permeability is a concept used to convey the reduction in flow capability due to the presence of multiple fluids. Relative permeability governs the multiphase flow, therefore it has a significant importance in understanding the reservoir behavior. These parameters are routinely measured on conventional rocks, however their measurement becomes quite challenging for low permeability rocks such as tight gas formations. This study demonstrates a methodology for relative permeability measurements on tight gas samples. The gas permeability has been measured by the Step Decay method and two different techniques have been used to vary the saturations: steady state flooding and vapor desorption. Series of steady-state gas/water simultaneous injection have been performed on a tight gas sample. After stabilization at each injection ratio, NMR T2, NMR Saturation profile and low pressure Step Decay gas permeability have been measured. In parallel, progressive desaturation by vapor desorption technique has been performed on twin plugs. After stabilization at each relative humidity level the NMR T2 and Step Decay gas permeability have been measured in order to compare and validate the two approaches. The techniques were used to gain insight into the tight gas two phase relative permeability of extremely low petrophysical properties (K<100 nD, phi < 5 pu) of tight gas samples of Pyrophyllite outcrop. The two methods show quite good agreement. Both methods demonstrate significant permeability degradation at water saturation higher than irreducible. NMR T2 measurements for both methods indicates bimodal T2-distributions, and desaturation first occurs on low T2 signal (small pores). Comparison of humidity drying and steady-state desaturation technique has shown a 12-18 su difference between critical water saturation (Swc) measured in gas/water steady-state injection and irreducible saturation (Swirr) measured by vapor desorption.

Sign in / Sign up

Export Citation Format

Share Document