Experimental Evaluation of Extremum Seeking Based Region-2 Controller for CART3 Wind Turbine

2016 ◽  
Author(s):  
Yan Xiao ◽  
Yaoyu Li ◽  
Mario Rotea
Keyword(s):  
Wind Turbine ◽  
Experimental Evaluation ◽  
Extremum Seeking

Real-Time Optimization of Wind Farm Energy Capture With Delay Compensated Nested-Loop Extremum Seeking Control

2017 ◽  
Author(s):  
Zhongyou Wu ◽  
Yaoyu Li
Keyword(s):  
Wind Turbine ◽  
Real Time ◽  
Wind Farm ◽  
Optimization Techniques ◽  
Extremum Seeking ◽  
Extremum Seeking Control ◽  
Energy Capture ◽  
Time Optimization ◽  
Real Time Optimization ◽  
Nested Loop

Real-time optimization of wind farm energy capture for below rated wind speed is critical for reducing the levelized cost of energy (LCOE). Performance of model based control and optimization techniques can be significantly limited by the difficulty in obtaining accurate turbine and farm models in field operation, as well as the prohibitive cost for accurate wind measurements. The Nested-Loop Extremum Seeking Control (NLESC), recently proposed as a model free method has demonstrated its great potential in wind farm energy capture optimization. However, a major limitation of previous work is the slow convergence, for which a primary cause is the low dither frequencies used by upwind turbines, primarily due to wake propagation delay through the turbine array. In this study, NLESC is enhanced with the predictor based delay compensation proposed by Oliveira and Krstic [1], which allows the use of higher dither frequencies for upwind turbines. The convergence speed can thus be improved, increasing the energy capture consequently. Simulation study is performed for a cascaded three-turbine array using the SimWindFarm platform. Simulation results show the improved energy capture of the wind turbine array under smooth and turbulent wind conditions, even up to 10% turbulence intensity. The impact of the proposed optimization methods on the fatigue loads of wind turbine structures is also evaluated.

Adaptive Maximization of Power Extraction of a Single Wind Turbine

2014 ◽  
Vol 615 ◽  
pp. 426-429
Author(s):  
Shu Yue Lin
Keyword(s):  
Wind Turbine ◽  
Engineering Industry ◽  
Extremum Seeking ◽  
Constant Input ◽  
Research Attention ◽  
Power Extraction ◽  
Point Tracking ◽  
Power Point Tracking ◽  
Control Scheme ◽  
Power Point

Nowadays the application of extremum seeking controller in various engineering industry has attracted a high research attention. Also, it is one of the best known maximum power point tracking algorithm. It can drive the output to its extreme point automatically and dynamically stabilize around the equilibrium. In this paper, it is implemented via Matlab/Simulink. The extremum seeking control scheme controls the wind turbine to operate at its optimal rotational speed adaptively. Piecewise constant input wind will be applied.

Using Extremum Seeking Control to Improve the Power Capture of Midsize Hydrostatic Wind Turbines

2021 ◽  
Author(s):  
Daniel Escobar-Naranjo ◽  
Biswaranjan Mohanty ◽  
Kim A. Stelson
Keyword(s):  
Adaptive Control ◽  
Wind Turbine ◽  
Wind Turbines ◽  
Control Strategies ◽  
Torque Control ◽  
Extremum Seeking ◽  
Extremum Seeking Control ◽  
Model Free ◽  
Point Tracking ◽  
Power Capture

Abstract Adaptive control strategies are commonly used for systems that change over time, such as wind turbines. Extremum Seeking Control (ESC) is a model-free real-time adaptive control strategy commonly used in conventional gearbox wind turbines for Maximum Power Point Tracking (MPPT). ESC optimizes the rotor power by constantly tuning the torque control gain (k) when operating below rated power. The same concept can be applied for hydrostatic wind turbines. This paper studies the use of ESC for a 60-kW hydrostatic wind turbine. First, a systematic approach to establish the ideal ESC is shown. Second, a comparison of the power capture performance of ESC versus the conventional torque control law (the kω2 law) is shown. The simulations include a timesharing power capture coefficient (Cp) to clearly show the advantages of using ESC. Studies under steady and realistic wind conditions show the main advantages of using ESC for a hydrostatic wind turbine.

Optimizing Energy Capture of Cascaded Wind Turbine Array With Nested-Loop Extremum Seeking Control

2015 ◽  
Vol 137 (12) ◽  
Author(s):  
Zhongzhou Yang ◽  
Yaoyu Li ◽  
John E. Seem
Keyword(s):  
Wind Speed ◽  
Wind Turbine ◽  
Simulation Study ◽  
Wind Farm ◽  
Extremum Seeking ◽  
Power Coefficient ◽  
Extremum Seeking Control ◽  
Energy Capture ◽  
Principle Of Optimality ◽  
Nested Loop

This paper proposes a nested-loop extremum seeking control (NLESC) scheme for optimizing the energy capture of wind farm that is formed by a wind turbine array along the prevailing wind direction. It has been shown in earlier work that the axial induction factors of individual wind turbines can be optimized from downstream to upstream units in a sequential manner, which is a spatial domain analogy to the principle of optimality in dynamic programing. Therefore, it is proposed to optimize the turbine operation by a nested-loop optimization framework from the downstream to upstream turbines, based on feedback of the power of the immediate turbine and its downstream units. The extremum seeking control (ESC) based on dither–demodulation scheme is selected as a model-free real-time optimization solution for the individual loops. First, the principle of optimality for optimizing wind farm energy capture is proved for the cascaded wind turbine array based on the disk model. Analysis shows that the optimal torque gain of each turbine in a cascade of turbines is invariant with wind speed if the wind direction does not change. Then, the NLESC scheme is proposed, with the array power coefficient selected as the performance index to be optimized in real-time. As changes of upstream turbine operation affect downstream turbines with significant delays due to wind propagation, a cross-covariance based delay estimate is used to improve the determination of the array power coefficient. The proposed scheme is evaluated with simulation study using a three-turbine wind farm with the simwindfarm simulation platform. Simulation study is performed under both smooth and turbulent winds, and the results indicate the convergence to the actual optimum. Also, simulation under different wind speeds supports the earlier analysis results that the optimal torque gains of the cascaded turbines are invariant to wind speed.

Maximizing Wind Turbine Energy Capture via Extremum Seeking Control

2008 ◽  
Author(s):  
Justin Creaby ◽  
Yaoyu Li ◽  
John E. Seem
Keyword(s):  
Wind Turbine ◽  
Torque Control ◽  
Extremum Seeking ◽  
Control Torque ◽  
Pass Filter ◽  
Extremum Seeking Control ◽  
Energy Capture ◽  
Variable Speed Wind Turbine ◽  
Speed Up ◽  
High Pass

Maximizing wind turbine energy capture has become an important issue as more turbines are installed in low wind areas. This paper investigates the application of extremum seeking control (ESC) to maximizing the energy capture of variable speed wind turbine. The optimal control torque and pitch angle are searched via ESC based on the measurement of output power. The advantage is the independency from accurate wind measurement. Simulation has been conducted on FAST for a wind turbine dynamic model, under uniformly steady wind, stair-case wind speed variations, and turbulence wind. The simulation results indicated that the captured power increased by up to 4% over the standard torque control. Anti-windup ESC was then applied to overcome the actuation saturation which may disable the ESC process. Finally, the ESC with high-pass filter input resetting was applied to speed up the transient under abrupt change of wind.

Sign in / Sign up

Export Citation Format

Share Document