Verification of the Hensel Blockage Correction in the National Full-Scale Aerodynamics Complex 40- by 80-foot Wind Tunnel Using Hypersonic Inflatable Aerodynamic Decelerators

2014 ◽  
Author(s):  
Patrick W. Goulding
Keyword(s):  
Wind Tunnel ◽  
Full Scale ◽  
Blockage Correction

Wind Tunnel to Full Scale Mapping of Winds and Loads for Launch-Vehicle Ground Wind Loads

2021 ◽  
Author(s):  
Thomas G. Ivanco ◽  
Donald F. Keller ◽  
Jennifer L. Pinkerton
Keyword(s):  
Wind Tunnel ◽  
Launch Vehicle ◽  
Full Scale ◽  
Wind Loads

Characterization of wind-induced pressure on membrane roofs based on full-scale wind tunnel testing

2021 ◽  
Vol 235 ◽  
pp. 112101
Author(s):  
Johnny Estephan ◽  
Changda Feng ◽  
Arindam Gan Chowdhury ◽  
Mauricio Chavez ◽  
Appupillai Baskaran ◽  
...  
Keyword(s):  
Wind Tunnel ◽  
Full Scale ◽  
Wind Tunnel Testing ◽  
Tunnel Testing

A New Method of Modeling Underexpanded Exhaust Plumes for Wind Tunnel Aerodynamic Testing

1989 ◽  
Vol 111 (4) ◽  
pp. 748-754
Author(s):  
V. Salemann ◽  
J. M. Williams
Keyword(s):  
Wind Tunnel ◽  
Free Stream ◽  
Dynamic Pressure ◽  
Pressure Ratio ◽  
Area Ratio ◽  
Full Scale ◽  
New Method ◽  
Thrust Coefficient ◽  
Model Scale ◽  
Exhaust Plumes

A new method for modeling hot underexpanded exhaust plumes with cold model scale plumes in aerodynamic wind tunnel testing has been developed. The method is applicable to aeropropulsion testing where significant interaction between the exhaust and the free stream and aftbody may be present. The technique scales the model and nozzle external geometry, including the nozzle exit area, matches the model jet to free-stream dynamic pressure ratio to full-scale jet to free-stream dynamic pressure ratio, and matches the model thrust coefficient to full-scale thrust coefficient. The technique does not require scaling of the internal nozzle geometry. A generalized method of characteristic computer code was used to predict the plume shapes of a hot (γ = 1.2) half-scale nozzle of area ratio 3.2 and of a cold (γ = 1.4) model scale nozzle of area ratio 1.3, whose pressure ratio and area ratio were selected to satisfy the above criteria and other testing requirements. The plume shapes showed good agreement. Code validity was checked by comparing code results for cold air exhausting into a quiescent atmosphere to pilot surveys and shadowgraphs of model nozzle plumes taken in a static facility.

Full-Scale Wind-Tunnel Investigation of an Ayres S2R-800 Thrush Agricultural Airplane

1979 ◽  
Author(s):  
Joseph L. Johnson ◽  
H. Clyde Mclemore ◽  
Richard White ◽  
Frank L. Jordan
Keyword(s):  
Wind Tunnel ◽  
Full Scale
Sign in / Sign up

Export Citation Format

Share Document