scholarly journals Experimental Study of Boundary Layer Flow Control Using an Array of Ramp-Shaped Vortex Generators

2012 ◽  
Author(s):  
Stefanie Hirt ◽  
Khairul Zaman ◽  
Timothy Bencic
Keyword(s):  
Boundary Layer ◽  
Experimental Study ◽  
Flow Control ◽  
Boundary Layer Flow ◽  
Vortex Generators ◽  
Layer Flow

Interaction Phenomena of High Frequency Pulsed Blowing in LP Turbine-Like Boundary Layers at High Speed Test Conditions

2018 ◽  
Author(s):  
Valentin Bettrich ◽  
Martin Bitter ◽  
Reinhard Niehuis
Keyword(s):  
Boundary Layer ◽  
Flow Control ◽  
Boundary Layer Flow ◽  
High Frequency ◽  
Active Flow Control ◽  
Suction Side ◽  
Operating Point ◽  
Layer Flow ◽  
Lp Turbine ◽  
Active Flow

The use of fluidic oscillators for active flow control applications is a proven and efficient concept. For the well-known highly loaded LP turbine profile T161, the total pressure losses could already reduced by 40% at low Reynolds numbers, were usually flow separation occurs. For further improvements of the active flow control concept, it is essential to understand the driving flow phenomena responsible for the loss reduction mechanism, which are discussed in this paper. The results presented are based on experimental investigations on a flat plate with pressure gradient, imposed with an aerodynamically highly loaded low pressure turbine suction side flow and equipped with active flow control. The analogy to the suction side of the T161 is shown and validated against former cascade measurements. Based on the T161 equivalent operating point of Re = 70,000 and a theoretical out flow Mach number of Ma2,th = 0.6, the focus is set on the interaction of the boundary layer flow with high frequency actuation. The chosen actuator, a high frequency coupled fluidic oscillator, is designed to independently adjust mass flow and frequency. The flat plate is equipped with an array of high frequency actuators to control the flow separation. For this study one oscillator operating point at 6.7kHz is presented and the influence on transition and loss reduction compared to the non-actuated case is discussed. This oscillator operating point was found to be most efficient and the steady and unsteady mixing behavior of the high frequency actuator impact and the low pressure turbine like suction side boundary layer flow is investigated in much detail. Depending on the measurement technique, the isentropic Mach number distribution, frequency spectra, standard deviation, skewness and kurtosis are evaluated. The most important results are on the one hand, that the chosen concept is more efficient compared to former studies in means of mass flow investment, which is mainly based on the chosen oscillator outlet position and frequency. On the other hand, in a transonic flow the mixing and interaction of the high frequency pulses and the boundary layer flow require about 10% of the surface length to even establish and about to 30% to be completed. These results of the mixing behavior between actuator and boundary layer for compressible flow conditions help to attain a fundamental understanding for future designs of active flow control concepts.

Passive Boundary Layer Flow Control Using Porous Lamination

2018 ◽  
Vol 124 (2) ◽  
pp. 533-551 ◽  
Author(s):  
K. Aswathy Nair ◽  
A. Sameen ◽  
S. Anil Lal
Keyword(s):  
Boundary Layer ◽  
Flow Control ◽  
Boundary Layer Flow ◽  
Layer Flow
Sign in / Sign up

Export Citation Format

Share Document