Spatially distributed models of broadband turbomachinery and jet exhaust noise for engine source breakdown processing of phased array measurements

Author(s):  
Brian Tester ◽  
Gwenael Gabard ◽  
Stewart Glegg
1997 ◽  
Vol 25 ◽  
pp. 367-370 ◽  
Author(s):  
Richard Kattelmann

Snow cover in the intermittent snow zone of the Sierra Nevada can occupy more than 10 000 km2 of the mountain range, but it has received relatively little attention in river forecasting. Snow is deposited at lower elevations only during the cold storms of winter, and remains there only for a few days or weeks. When cold storms have created a thin snow cover at low elevations, a subsequent warm storm can melt this snow in just a few hours and increase the runoff response dramatically. Operational hydrological models and river-forecasting procedures have tended to overlook contributions from the intermittent-snow zone, focusing instead on rainfall-runoff or melt from the snowpack zone at higher elevations. Data-collection efforts are minimal in this zone, too. Ideally, spatially distributed models of snowmelt and runoff generation are needed to account for the typically large differences in snow cover on different aspects in the intermittent snow zone. Although aircraft and satellite imagery would be most desirable to monitor the distribution of snow cover in the intermittent-snow zone, even a few climate stations that report precipitation type and snow presence would be a major improvement over the present situation in the Sierra Nevada.


2015 ◽  
Vol 19 (2) ◽  
pp. 857-876 ◽  
Author(s):  
S. Wi ◽  
Y. C. E. Yang ◽  
S. Steinschneider ◽  
A. Khalil ◽  
C. M. Brown

Abstract. This study tests the performance and uncertainty of calibration strategies for a spatially distributed hydrologic model in order to improve model simulation accuracy and understand prediction uncertainty at interior ungaged sites of a sparsely gaged watershed. The study is conducted using a distributed version of the HYMOD hydrologic model (HYMOD_DS) applied to the Kabul River basin. Several calibration experiments are conducted to understand the benefits and costs associated with different calibration choices, including (1) whether multisite gaged data should be used simultaneously or in a stepwise manner during model fitting, (2) the effects of increasing parameter complexity, and (3) the potential to estimate interior watershed flows using only gaged data at the basin outlet. The implications of the different calibration strategies are considered in the context of hydrologic projections under climate change. To address the research questions, high-performance computing is utilized to manage the computational burden that results from high-dimensional optimization problems. Several interesting results emerge from the study. The simultaneous use of multisite data is shown to improve the calibration over a stepwise approach, and both multisite approaches far exceed a calibration based on only the basin outlet. The basin outlet calibration can lead to projections of mid-21st century streamflow that deviate substantially from projections under multisite calibration strategies, supporting the use of caution when using distributed models in data-scarce regions for climate change impact assessments. Surprisingly, increased parameter complexity does not substantially increase the uncertainty in streamflow projections, even though parameter equifinality does emerge. The results suggest that increased (excessive) parameter complexity does not always lead to increased predictive uncertainty if structural uncertainties are present. The largest uncertainty in future streamflow results from variations in projected climate between climate models, which substantially outweighs the calibration uncertainty.


Author(s):  
Alexander Quayle ◽  
Ann Dowling ◽  
Holger Babinsky ◽  
William Graham ◽  
Yu Liu

2012 ◽  
Vol 588-589 ◽  
pp. 747-750
Author(s):  
Tao Chen ◽  
Hong Hou ◽  
Zhi Fei Chen ◽  
Cheng Kun Jiang

Flyover noise measurements were conducted on an aircraft ARJ21 aiming at landing gear noise prediction schemes. The analysis is based on acoustic dedopplerized spectra and localization maps was calculated with the pressure signals of a acoustic phased array with 30 microphones. The acoustic phased array is a spatially distributed set of microphones which simultaneously sample the acoustic field. The doppler shifts was removed using linear interpolation.By appropriately time delaying the output of individual microphones, the origin and level of noise source(the landing gear) can potentially be determined. The success of this approach depends largely on the phased array design, and the array data processing method. This paper focuses on the two areas.


Geophysics ◽  
2011 ◽  
Vol 76 (3) ◽  
pp. WA113-WA123 ◽  
Author(s):  
Kurt T. Nihei ◽  
Seiji Nakagawa ◽  
Frederic Reverdy ◽  
Larry R. Myer ◽  
Luca Duranti ◽  
...  

Sediments undergoing compaction typically exhibit transversely isotropic (TI) elastic properties. We present a new experimental apparatus, the phased array compaction cell, for measuring the TI elastic properties of clay-rich sediments during compaction. This apparatus uses matched sets of P- and S-wave ultrasonic transducers located along the sides of the sample and an ultrasonic P-wave phased array source, together with a miniature P-wave receiver on the top and bottom ends of the sample. The phased array measurements are used to form plane P-waves that provide estimates of the phase velocities over a range of angles. From these measurements, the five TI elastic constants can be recovered as the sediment is compacted, without the need for sample unloading, recoring, or reorienting. This paper provides descriptions of the apparatus, the data processing, and an application demonstrating recovery of the evolving TI properties of a compacting marine sediment sample.


Sign in / Sign up

Export Citation Format

Share Document