scholarly journals Numerical Simulations of Buoyancy Effects in Low Density Gas Jets

Author(s):  
Rajani Satti ◽  
Kasyap Pasumarthi ◽  
Ajay Agrawal
AIAA Journal ◽  
2003 ◽  
Vol 41 (10) ◽  
pp. 1973-1979 ◽  
Author(s):  
Tze-Wing Yep ◽  
Ajay K. Agrawal ◽  
DeVon Griffin

2019 ◽  
Vol 488 (2) ◽  
pp. 2405-2411 ◽  
Author(s):  
Ore Gottlieb ◽  
Ehud Nakar ◽  
Tsvi Piran

ABSTRACT VLBI and JVLA observations revealed that GW170817 involved a narrow jet (θj ≈ 4°) that dominated the afterglow peak at our viewing angle, θobs ≈ 20°. This implies that at the time of the afterglow peak, the observed signal behaved like an afterglow of a top-hat jet seen at θobs ≫ θj, and it can be modelled by analytic expressions that describe such jets. We use a set of numerical simulations to calibrate these analytic relations and obtain generic equations for the peak time and flux of such an afterglow as seen from various observing angles. Using the calibrated equations and the estimated parameters of GW170817, we estimate the detectability of afterglows from future double neutron star mergers during the Advanced LIGO/Virgo observation run O3. GW170817 took place at a relatively low-density environment. Afterglows of similar events will be detectable only at small viewing angles, θobs ≲ 20°, and only 20 per cent of the GW detections of these events will be accompanied by a detectable afterglow. At higher densities, more typical to sGRB sites, up to $70\,\rm{per\,cent}$ of the GW detections are expected to be followed by a detectable afterglow, typically at θobs ∼ 30°. We also provide the latest time one should expect an afterglow detection. We find that for typical parameters, if the jet emission had not been detected within about a year after the merger, it is unlikely to be ever detected.


2008 ◽  
Vol 2008.2 (0) ◽  
pp. 207-208
Author(s):  
Akinori MURAMATSU ◽  
On Ishikawa ◽  
Tomoya SASAKI
Keyword(s):  

AIAA Journal ◽  
2006 ◽  
Vol 44 (7) ◽  
pp. 1505-1515 ◽  
Author(s):  
Rajani P. Satti ◽  
Ajay K. Agrawal

1999 ◽  
Vol 190 ◽  
pp. 84-92
Author(s):  
Joel N. Bregman

Three different topics regarding the ISM in the Magellanic Clouds are discussed. First, we examine how the Magellanic Stream can be used as a tracer of the ionizing radiation leaking out of Galaxy and the Magellanic Clouds. We show that the radiation reaching the Magellanic Stream is less than 1% of the ionizing radiation produced by Galactic 0 and B stars. Since about 14% of the ionizing radiation from these stars is required to ionize the Reynolds layer, which is within 1 kpc of the disk, most of this radiation must be absorbed before reaching the Stream.Second, we examine the reliability of using CO as a tracer of H2 in regions of low or modest column densities (not giant molecular cloud complexes). For our Galaxy, the usual CO to H2 conversion factor overlooks a considerable amount of H2 and the evidence suggests that this may be true in the LMC as well. Finally, we present numerical hydrodynamical calculations of the interstellar medium in disk galaxies for a region of size 2 kpc along the plane and 15 kpc out of the plane. The simulations reveal a rich structure of low density hot regions separated by cold dense material, with the resulting position velocity diagrams being qualitatively similar to the recent HI studies of the LMC. A number of other aspects of these simulations are discussed also.


Sensors ◽  
2021 ◽  
Vol 21 (14) ◽  
pp. 4745
Author(s):  
Kyei Anim ◽  
Henry Abu Diawuo ◽  
Young-Bae Jung

This paper presents a new configuration of a slotted waveguide antenna (SWA) array aimed at the X-band within the desired band of 9.38~9.44 GHz for shipboard marine radars. The SWA array, which typically consists of a slotted waveguide, a polarizing filter, and a metal reflector, is widely employed in marine radar applications. Nonetheless, conventional slot array designs are weighty, mechanically complex, and geometrically large to obtain high performances, such as gain. These features of the conventional SWA are undesirable for the shipboard marine radar, where the antenna rotates at high angular speed for the beam scanning mechanism. The proposed SWA array herein reduces the conventional design’s size by 62% using a tapered dielectric-inset guide structure. It shows high gain performance (up to 30 dB) and obtains improvements in radiation efficiency (up to 80% in the numerical simulations) and weight due to the use of loss and low-density dielectric material.


2013 ◽  
Vol 371 ◽  
pp. 534-538 ◽  
Author(s):  
Ionut Laurentiu Sandu ◽  
Felicia Stan ◽  
Catalin Fetecau

The objective of this paper consists in the determination of the flow front length using o circular spiral mold. The paper also studies the influence of the process parameters on the flow front length using the method of statistical analysis. For this purpose, a number of numerical simulations are carried out by utilizing the combination of four process parameters (i.e., the melt temperature, the spiral thickness, the injection pressure and the mold temperature) at three levels. In order to reduce the number of numerical simulations, a simplistic Taguchi L27orthogonal array was chosen. The material chosen for this study was a low density polyethylene and a high density polyethylene. The flow front length was measured through a marked pattern of the circular spiral using the AutoCAD.


Sign in / Sign up

Export Citation Format

Share Document