Leading edge vortex and shear layer instabilities

1998 ◽  
Author(s):  
T. Ng ◽  
Doug Oliver
Keyword(s):  
Shear Layer ◽  
Leading Edge ◽  
Leading Edge Vortex ◽  
Edge Vortex

On the distribution of leading-edge vortex circulation in samara-like flight

2015 ◽  
Vol 776 ◽  
pp. 316-333 ◽  
Author(s):  
Eric Limacher ◽  
David E. Rival
Keyword(s):  
Shear Layer ◽  
Angle Of Attack ◽  
Leading Edge ◽  
Speed Ratio ◽  
Leading Edge Vortex ◽  
Tip Speed Ratio ◽  
Edge Vortex ◽  
Effective Angle ◽  
Rotating Plates ◽  
Vorticity Flux

As an abstraction of natural samara flight, steadily rotating plates in a free-stream flow have been studied. Particle image velocimetry on span-normal planes has been conducted to show that increasing rotation, as captured by the dimensionless parameter of tip speed ratio, causes a transition of the mean wake topology from that of a bluff body to that of a stable leading-edge vortex. Despite its notable effect on topology, a change in tip speed ratio has negligible effect on leading-edge circulation at a given spanwise position, local effective angle of attack and local effective velocity. The effective angle-of-attack distribution was held constant at different tip speed ratios by comparing rotating plates with different twist profiles. The shear-layer velocity profile at the leading edge was also resolved, allowing quantification of the vorticity flux passing through the leading-edge shear layer. Interestingly, the observed equilibrium values of circulation are not sensitive to changes in shear-layer vorticity flux.

Flight

2018 ◽  
Author(s):  
Anders Hedenström
Keyword(s):  
Bird Species ◽  
Leading Edge ◽  
Micro Air Vehicles ◽  
Leading Edge Vortex ◽  
Confined Spaces ◽  
Unsteady Aerodynamic ◽  
Maneuvering Flight ◽  
Edge Vortex ◽  
Lifting Surfaces ◽  
Animal Flight

Animal flight represents a great challenge and model for biomimetic design efforts. Powered flight at low speeds requires not only appropriate lifting surfaces (wings) and actuator (engine), but also an advanced sensory control system to allow maneuvering in confined spaces, and take-off and landing. Millions of years of evolutionary tinkering has resulted in modern birds and bats, which are achieve controlled maneuvering flight as well as hovering and cruising flight with trans-continental non-stop migratory flights enduring several days in some bird species. Unsteady aerodynamic mechanisms allows for hovering and slow flight in insects, birds and bats, such as for example the delayed stall with a leading edge vortex used to enhance lift at slows speeds. By studying animal flight with the aim of mimicking key adaptations allowing flight as found in animals, engineers will be able to design micro air vehicles of similar capacities.

Flow criticality governs leading-edge-vortex initiation on finite wings in unsteady flow

2021 ◽  
Vol 910 ◽  
Author(s):  
Yoshikazu Hirato ◽  
Minao Shen ◽  
Ashok Gopalarathnam ◽  
Jack R. Edwards
Keyword(s):  
Unsteady Flow ◽  
Leading Edge ◽  
Leading Edge Vortex ◽  
Edge Vortex

Abstract

Vorticity transport in the leading-edge vortex on a rotating blade

2014 ◽  
Vol 743 ◽  
pp. 249-261 ◽  
Author(s):  
Craig J. Wojcik ◽  
James H. J. Buchholz
Keyword(s):  
Leading Edge ◽  
Quasi Equilibrium ◽  
Transport Mechanisms ◽  
Leading Edge Vortex ◽  
Rotating Blade ◽  
Edge Vortex ◽  
Rotation Motion ◽  
Vorticity Transport ◽  
Control Volumes ◽  
Quiescent Fluid

AbstractVorticity transport is analysed within the leading-edge vortex generated on a rectangular flat plate of aspect ratio 4 undergoing a starting rotation motion in a quiescent fluid. Two analyses are conducted on the inboard half of the blade to better understand the vorticity transport mechanisms responsible for maintaining the quasi-equilibrium state of the leading-edge vortex. An initial global analysis between the $25$ and $50\, \%$ spanwise positions suggests that, although spanwise velocity is significant, spanwise convection of vorticity is insufficient to balance the flux of vorticity from the leading-edge shear layer. Subsequent detailed analyses of vorticity transport in planar control volumes at the $25$ and $50\, \%$ spanwise positions verify this conclusion and demonstrate that vorticity annihilation due to interaction between the leading-edge vortex and the opposite-sign layer on the plate surface is an important, often dominant, mechanism for regulation of leading-edge-vortex circulation. Thus, it provides an important condition for maintenance of an attached leading-edge vortex on the inboard portion of the blade.

Heat Transfer and Flowfield Measurements in the Leading Edge Region of a Stator Vane Endwall

1999 ◽  
Vol 121 (3) ◽  
pp. 558-568 ◽  
Author(s):  
M. B. Kang ◽  
A. Kohli ◽  
K. A. Thole
Keyword(s):  
Heat Transfer ◽  
Reynolds Number ◽  
Leading Edge ◽  
Reynolds Numbers ◽  
Secondary Flows ◽  
Edge Region ◽  
Leading Edge Vortex ◽  
Stator Vane ◽  
Edge Vortex ◽  
The Mean

The leading edge region of a first-stage stator vane experiences high heat transfer rates, especially near the endwall, making it very important to get a better understanding of the formation of the leading edge vortex. In order to improve numerical predictions of the complex endwall flow, benchmark quality experimental data are required. To this purpose, this study documents the endwall heat transfer and static pressure coefficient distribution of a modern stator vane for two different exit Reynolds numbers (Reex = 6 × 105 and 1.2 × 106). In addition, laser-Doppler velocimeter measurements of all three components of the mean and fluctuating velocities are presented for a plane in the leading edge region. Results indicate that the endwall heat transfer, pressure distribution, and flowfield characteristics change with Reynolds number. The endwall pressure distributions show that lower pressure coefficients occur at higher Reynolds numbers due to secondary flows. The stronger secondary flows cause enhanced heat transfer near the trailing edge of the vane at the higher Reynolds number. On the other hand, the mean velocity, turbulent kinetic energy, and vorticity results indicate that leading edge vortex is stronger and more turbulent at the lower Reynolds number. The Reynolds number also has an effect on the location of the separation point, which moves closer to the stator vane at lower Reynolds numbers.

Sign in / Sign up

Export Citation Format

Share Document