Global wall interference correction and control for the NWTC Transonic Test Section

1997 ◽  
Author(s):  
W. Sickles ◽  
F. Steinle, Jr. ◽  
W. Sickles ◽  
F. Steinle, Jr.
Keyword(s):  
Test Section ◽  
Interference Correction ◽  
And Control

Studies on the Efficiency of the CFG Pile-Net Reinforcement in the Soft Soil Subgrade

2011 ◽  
Vol 94-96 ◽  
pp. 2222-2225
Author(s):  
Feng Zhang ◽  
Zhao Yi Xu ◽  
Zhi Yi Li
Keyword(s):  
Bearing Capacity ◽  
Test Section ◽  
Soft Soil ◽  
Quality Detection ◽  
Detection Technology ◽  
Practical Engineering ◽  
And Control ◽  
Cfg Pile

Combined with Wuhan test section of Wuhan-Guangzhou passenger special line, proportioning of mixtures、integrity of pile、bearing capacity and cushion of CFG pile detection technology were studied in this paper. The systematic and perfect methods of quality detection and control standard have been put forward. It provide useful reference for practical engineering．

Wall Interference Correction Method for Kevlar Wall Test Section

2020 ◽  
Vol 57 (5) ◽  
pp. 889-900
Author(s):  
Hiroki Ura ◽  
Masashi Shigemi ◽  
Tomonari Hirotani ◽  
Tomoyuki Homma
Keyword(s):  
Test Section ◽  
Correction Method ◽  
Interference Correction

WALL-INTERFERENCE CORRECTION FOR THE SURFACE-PRESSURE HYSTERESIS OF AN AIRFOIL UNDERGOING PLUNGING MOTION

2015 ◽  
Vol 39 (2) ◽  
pp. 293-305
Author(s):  
Mohammad Saeedi ◽  
Mahmoud Mani ◽  
Armin Hamta
Keyword(s):  
Numerical Simulation ◽  
Wind Tunnel ◽  
Test Section ◽  
Wind Tunnels ◽  
Far Field ◽  
Wind Tunnel Experiments ◽  
Interference Correction ◽  
Dimensional Parameters ◽  
Conventional Test ◽  
The Difference

In the current research, the results of a number of wind-tunnel experiments on a moving airfoil with plunging motion are presented. The experiments have been conducted in two different configurations which are tunnels with conventional and slotted test-section walls to provide resemblance to a far-field condition. The difference in results obtained from two test-section configurations can be considered as the wall effect and regulated as a function of non-dimensional parameters which can be further used for correcting experimental results obtained from conventional wind tunnels. When the derived correction factor is applied to a numerical simulation of a wind tunnel with a conventional test section (for points located in the front portion of the airfoil), the resulting pressure variations closely resembled that of a far-field numerical simulation. This methodology showed promising results for the specific configurations used in this research.

A Method of Wall Interference Correction for Kevlar Wall Test Section

2019 ◽  
Author(s):  
Hiroki Ura ◽  
Masashi Shigemi ◽  
Tomonari Hirotani ◽  
Tomoyuki Homma
Keyword(s):  
Test Section ◽  
Interference Correction

Control of Metal Alloy Oxidation with Electric Fields

1973 ◽  
Vol 31 ◽  
pp. 164-165
Author(s):  
R. R. Dils ◽  
P. S. Follansbee
Keyword(s):  
Electric Fields ◽  
Oxidation Process ◽  
Base Alloy ◽  
Oxide Surface ◽  
Platinum Electrodes ◽  
Insulating Layer ◽  
Iron Base Alloy ◽  
Alloy Oxidation ◽  
Aluminum Oxide Layer ◽  
And Control

Electric fields have been applied across oxides growing on a high temperature alloy and control of the oxidation of the material has been demonstrated. At present, three-fold increases in the oxidation rate have been measured in accelerating fields and the oxidation process has been completely stopped in a retarding field.The experiments have been conducted with an iron-base alloy, Pe 25Cr 5A1 0.1Y, although, in principle, any alloy capable of forming an adherent aluminum oxide layer during oxidation can be used. A specimen is polished and oxidized to produce a thin, uniform insulating layer on one surface. Three platinum electrodes are sputtered on the oxide surface and the specimen is reoxidized.

Evidence for a Blood Ganglion Barrier in the Superior Cervical Ganglion of the Rat

1982 ◽  
Vol 40 ◽  
pp. 204-204
Author(s):  
D. M. DePace
Keyword(s):  
Blood Vessels ◽  
Superior Cervical Ganglion ◽  
Peripheral Nerves ◽  
Time Schedule ◽  
Transmission Electron ◽  
Cervical Ganglion ◽  
The Central Nervous System ◽  
Cervical Ganglia ◽  
Capillary Circulation ◽  
And Control

The majority of blood vessels in the superior cervical ganglion possess a continuous endothelium with tight junctions. These same features have been associated with the blood brain barrier of the central nervous system and peripheral nerves. These vessels may perform a barrier function between the capillary circulation and the superior cervical ganglion. The permeability of the blood vessels in the superior cervical ganglion of the rat was tested by intravenous injection of horseradish peroxidase (HRP). Three experimental groups of four animals each were given intravenous HRP (Sigma Type II) in a dosage of.08 to.15 mg/gm body weight in.5 ml of.85% saline. The animals were sacrificed at five, ten or 15 minutes following administration of the tracer. Superior cervical ganglia were quickly removed and fixed by immersion in 2.5% glutaraldehyde in Sorenson's.1M phosphate buffer, pH 7.4. Three control animals received,5ml of saline without HRP. These were sacrificed on the same time schedule. Tissues from experimental and control animals were reacted for peroxidase activity and then processed for routine transmission electron microscopy.

Effects of renovascular hypertension on rat adrenal zona glomerulosa

1978 ◽  
Vol 36 (2) ◽  
pp. 582-583
Author(s):  
G. Mazzocchi ◽  
P. Rebuffat ◽  
C. Robba ◽  
P. Vassanelli ◽  
G. G. Nussdorfer
Keyword(s):  
Renovascular Hypertension ◽  
Left Kidney ◽  
Renin Angiotensin System ◽  
Plasma Renin ◽  
Zona Glomerulosa ◽  
Ultrastructural Changes ◽  
Albino Rats ◽  
Left Renal Artery ◽  
Angiotensin System ◽  
And Control

It is well known that the rat adrenal zona glomerulosa steroidogenic activity is controlled by the renin-angiotensin system. The ultrastructural changes in the rat zona glomerulosa cells induced by renovascular hypertension were described previously, but as far as we are aware no correlated biochemical and morphometric investigations were performed.Twenty adult male albino rats were divided into 2 experimental groups. One group was subjected to restriction of blood flow to the left kidney by the application of a silver clip about the left renal artery. The other group was sham-operated and served as a control. Renovascular hypertension developed in about 10 days: sistolic blood pressure averaged 165 ± 6. 4 mmHg, whereas it was about 110 ± 3. 8 mmHg in the control animals. The hypertensive and control rats were sacrificed 20 days after the operation. The blood was collected and plasma renin activity was determined by radioimmunological methods. The aldosterone concentration was radioimmunologically assayed both in the plasma and in the homogenate of the left capsular adrenal gland.

X-Ray Replication of Submicrometer Linewidth Patterns

1977 ◽  
Vol 35 ◽  
pp. 136-137
Author(s):  
Henry I. Smith ◽  
D.C. Flanders
Keyword(s):  
Electron Beam Lithography ◽  
Cross Sectional ◽  
X Ray ◽  
Electron Backscattering ◽  
Spatial Frequencies ◽  
Cross Sectional Profile ◽  
Carbon Foils ◽  
Sectional Profile ◽  
And Control ◽  
Soft Radiation

Scanning electron beam lithography has been used for a number of years to write submicrometer linewidth patterns in radiation sensitive films (resist films) on substrates. On semi-infinite substrates, electron backscattering severely limits the exposure latitude and control of cross-sectional profile for patterns having fundamental spatial frequencies below about 4000 Å(l),Recently, STEM'S have been used to write patterns with linewidths below 100 Å. To avoid the detrimental effects of electron backscattering however, the substrates had to be carbon foils about 100 Å thick (2,3). X-ray lithography using the very soft radiation in the range 10 - 50 Å avoids the problem of backscattering and thus permits one to replicate on semi-infinite substrates patterns with linewidths of the order of 1000 Å and less, and in addition provides means for controlling cross-sectional profiles. X-radiation in the range 4-10 Å on the other hand is appropriate for replicating patterns in the linewidth range above about 3000 Å, and thus is most appropriate for microelectronic applications (4 - 6).

Ultrastructural changes in sciatic nerve tissue: Effects of passive maternal smoking

1983 ◽  
Vol 41 ◽  
pp. 650-651
Author(s):  
Amankwah K.S. ◽  
A.D. Weberg ◽  
R.C. Kaufmann
Keyword(s):  
Sciatic Nerve ◽  
Maternal Smoking ◽  
Ultrastructural Level ◽  
Uranyl Acetate ◽  
Nerve Tissue ◽  
Ultrastructural Changes ◽  
Cacodylate Buffer ◽  
And Control ◽  
Spontaneous Delivery

Previous research has revealed that passive (involuntary inhalation) tobacco smoking during gestation can have adverse effects upon the developing fetus. These prior investigations did not concentrate on changes in fetal morphology. This study was undertaken to delineate fetal neural abnormalities at the ultrastructural level in mice pups exposed in utero to passive maternal smoking.Pregnant study animals, housed in a special chamber, were subjected to cigarette smoke daily from conception until delivery. Blood tests for determination of carbon monoxide levels were run at 15-18 days gestation. Sciatic nerve tissue from experimental and control animals were obtained following spontaneous delivery and fixed in 2.5% gluteraldehyde in 0.1M cacodylate buffer pH 7.3. The samples were post-fixed in osmium ferrocyanide (1:1 mixture of 1.5% aqueous OSO4 and 2.5% K4 Fe(CN)6). Following dehydration, the tissues were infiltrated with and embedded in Spurr. Sections were stained with uranyl acetate and lead citrate.

A Superconducting Microscope

1971 ◽  
Vol 29 ◽  
pp. 10-11 ◽  
Author(s):  
R. E. Worsham ◽  
J. E. Mann ◽  
E. G. Richardson
Keyword(s):  
Liquid Helium ◽  
Focal Length ◽  
Vacuum System ◽  
Objective Lens ◽  
Electrical Instability ◽  
Radiation Shields ◽  
And Control ◽  
Thermal Oscillations ◽  
Flux Pump

This superconducting microscope, Figure 1, was first operated in May, 1970. The column, which started life as a Siemens Elmiskop I, was modified by removing the objective and intermediate lenses, the specimen chamber, and the complete vacuum system. The large cryostat contains the objective lens and stage. They are attached to the bottom of the 7-liter helium vessel and are surrounded by two vapor-cooled radiation shields.In the initial operational period 5-mm and 2-mm focal length objective lens pole pieces were used giving magnification up to 45000X. Without a stigmator and precision ground pole pieces, a resolution of about 50-100Å was achieved. The boil-off rate of the liquid helium was reduced to 0.2-0.3ℓ/hour after elimination of thermal oscillations in the cryostat. The calculated boil-off was 0.2ℓ/hour. No effect caused by mechanical or electrical instability was found. Both 4.2°K and 1.7-1.9°K operation were routine. Flux pump excitation and control of the lens were quite smooth, simple, and, apparently highly stable. Alignment of the objective lens proved quite awkward, however, with the long-thin epoxy glass posts used for supporting the lens.

Sign in / Sign up

Export Citation Format

Share Document