Experimental nonlinear response of tapered ceramic matrix composite plates to base excitation

AIAA Journal ◽  
2002 ◽  
Vol 40 ◽  
pp. 1682-1687
Author(s):  
S. M. Spottswood ◽  
M. P. Mignolet
Keyword(s):  
Matrix Composite ◽  
Nonlinear Response ◽  
Ceramic Matrix Composite ◽  
Composite Plates ◽  
Ceramic Matrix ◽  
Base Excitation

scholarly journals Investigation of the Film-Cooling Performance of 2.5D Braided Ceramic Matrix Composite Plates with Preformed Hole

Aerospace ◽  
2021 ◽  
Vol 8 (4) ◽  
pp. 116
Author(s):  
Chenwei Zhao ◽  
Zecan Tu ◽  
Junkui Mao
Keyword(s):  
Matrix Composite ◽  
Film Cooling ◽  
Thermal Gradient ◽  
Numerical Models ◽  
Ceramic Matrix Composite ◽  
Side Wall ◽  
Composite Plates ◽  
Ceramic Matrix ◽  
Cooling Performance ◽  
Film Cooling Holes

The film-cooling performance of a 2.5D braided ceramic matrix composite (CMC) plate with preformed holes was numerically studied. Four numerical models containing braided structures were established: one model with film-cooling holes preformed through fiber extrusion deformation (EP-Hole), one model with film-cooling holes directly woven through fibers (WP-Hole), and two models with directly drilled holes (DP-Hole1,2). Besides, the influence of the ratio between the equivalent thermal conductivities on the axial and radial directions of fiber Kr was investigated. The results show that the preformed holes have better performance in controlling the thermal gradient with the increase of Kr. The maximum thermal gradient around the DP-Hole is significantly higher than that of the WP-Hole and EP-Hole, and the maximum relative variation reaches 123.3%. With Kr increasing from 3.32 to 13.05, the overall cooling effectiveness on the hot-side wall decreases for all models, by about 10%. Compared with the traditional drill method, the new preformed film-cooling hole studied in this paper can reduce the temperature and the thermal gradient in the region around the holes.

scholarly journals Sustainable Machining of Cf/SiC Ceramic Matrix Composite Using Green Cutting Fluids

Procedia CIRP ◽  
2021 ◽  
Vol 98 ◽  
pp. 151-156
Author(s):  
Shyam ◽  
M. Shanmuka Srinivas ◽  
Kishor Kumar Gajrani ◽  
A. Udayakumar ◽  
M. Ravi Sankar
Keyword(s):  
Matrix Composite ◽  
Ceramic Matrix Composite ◽  
Ceramic Matrix ◽  
Cutting Fluids ◽  
Sustainable Machining ◽  
Sic Ceramic
Sign in / Sign up

Export Citation Format

Share Document