Flight effects on the far-field noise of a heated supersonic jet

AIAA Journal ◽  
1997 ◽  
Vol 35 ◽  
pp. 952-957
Author(s):  
A. Krothapalli ◽  
P. D. Soderman ◽  
C. S. Allen ◽  
J. A. Nayes ◽  
S. M. Jaeger
Keyword(s):  
Supersonic Jet ◽  
Far Field ◽  
Field Noise

Flight Effects on the Far-Field Noise of a Heated Supersonic Jet

AIAA Journal ◽  
10.2514/2.203 ◽  
1997 ◽  
Vol 35 (6) ◽  
pp. 952-957 ◽  
Author(s):  
A. Krothapalli ◽  
P. T. Soderman ◽  
C. S. Allen ◽  
J. A. Hayes ◽  
S. M. Jaeger
Keyword(s):  
Supersonic Jet ◽  
Far Field ◽  
Field Noise

Near and Far-Field Investigations of Supersonic Jet Noise Predictions Using a Coupled LES and FW-H Equation Method

2011 ◽  
Author(s):  
James P. Erwin ◽  
Neeraj Sinha
Keyword(s):  
Supersonic Jet ◽  
Turbine Engines ◽  
Far Field ◽  
Noise Levels ◽  
Physical Acoustics ◽  
Aircraft Carrier ◽  
Eddy Simulation ◽  
Field Investigations ◽  
Large Eddy ◽  
Field Noise

The hot supersonic exhausts of gas turbine engines on military aircraft generate dangerously high noise levels. The noise levels associated with operating these engines are harmful to aircraft carrier deck personnel as well as detrimental to ship and aircraft structures. In this paper, the supersonic jet exhaust is simulated using Large Eddy Simulation (LES), and the Ffowcs Williams and Hawkings (FW-H) equation transforms the LES solution to an acoustic solution in the far-field. A Mach 1.5 laboratory jet test at United Technologies Research Center - Acoustics Research Tunnel is used as validation for the LES/FW-H method. A grid refinement study was performed with the objective of determining the requirements for accurate noise predictions. The finest grid resolution yields the best near and far-field acoustic prediction. A second LES/FW-H validation case is shown for a twin jet experiment that was performed in the anechoic chamber at University of Mississippi’s National Center for Physical Acoustics (NCPA). The LES/FW-H method is applied to the higher complexity heated twin jet with faceted nozzle profiles, demonstrating the applicability of the method over a wider range of flow regimes. The far-field noise prediction agrees very well with the NCPA experiment, including the prediction of broadband shock associated noise and jet screech.

Measurement of Near-Field and Far-Field Noise From Full Scale High Performance Jet Engines

2010 ◽  
Author(s):  
Richard McKinley ◽  
Robert McKinley ◽  
Kent Gee ◽  
Tony Pilan ◽  
Frank Mobley ◽  
...  
Keyword(s):  
High Performance ◽  
Noise Exposure ◽  
Near Field ◽  
Broad Band ◽  
Supersonic Jet ◽  
Full Scale ◽  
Far Field ◽  
Jet Engine ◽  
Field Noise ◽  
Non Linear Propagation

Accurate measurement of the noise fields emitted by a full scale high performance jet engine and jet plume (with supersonic jet flow) requires detailed planning and careful execution. The apparent acoustic source can be very large, more than 50 feet long and 20 feet high and wide. The jet plume contains many noise generating sources, the main two being shock (broad band and shock cells) and turbulent mixing. This paper is an initial description of a detailed method to accurately measure and describe the near-field noise while simultaneously measuring the far-field noise. For a large high performance jet engine, the acoustic far-field may not be formed until more than 1000 ft away from the plume. The paper also describes proposed methods to measure the non-linear propagation of the noise from the near-field to the far-field. The proposed methodology described with vetting will be considered as an US military standard (MILSTD) with possible later consideration as American standard measurement technique to describe noise fields for personnel noise exposure and for measuring the performance of jet engine noise reduction technologies.

Effects of forward flight on the far-field noise of a heated supersonic jet

1996 ◽  
Author(s):  
A. Krothapalli ◽  
P. Soderman ◽  
J. Hayes ◽  
C. Allen ◽  
S. Jaeger
Keyword(s):  
Supersonic Jet ◽  
Far Field ◽  
Forward Flight ◽  
Field Noise

scholarly journals Jet-Surface Interaction Test: Far-Field Noise Results

2013 ◽  
Vol 135 (7) ◽  
Author(s):  
Clifford A. Brown
Keyword(s):  
High Speed ◽  
Radial Distance ◽  
Jet Noise ◽  
Surface Interaction ◽  
Shielding Effect ◽  
Noise Prediction ◽  
Far Field ◽  
Wide Range ◽  
Field Noise ◽  
Surface Length

Many configurations proposed for the next generation of aircraft rely on the wing or other aircraft surfaces to shield the engine noise from the observers on the ground. However, the ability to predict the shielding effect and any new noise sources that arise from the high-speed jet flow interacting with a hard surface is currently limited. Furthermore, quality experimental data from jets with surfaces nearby suitable for developing and validating noise prediction methods are usually tied to a particular vehicle concept and, therefore, very complicated. The Jet-Surface Interaction Tests are intended to supply a high quality set of data covering a wide range of surface geometries and positions and jet flows to researchers developing aircraft noise prediction tools. The initial goal is to measure the noise of a jet near a simple planar surface while varying the surface length and location in order to: (1) validate noise prediction schemes when the surface is acting only as a jet noise shield and when the jet-surface interaction is creating additional noise, and (2) determine regions of interest for future, more detailed, tests. To meet these objectives, a flat plate was mounted on a two-axis traverse in two distinct configurations: (1) as a shield between the jet and the observer and (2) as a reflecting surface on the opposite side of the jet from the observer. The surface length was varied between 2 and 20 jet diameters downstream of the nozzle exit. Similarly, the radial distance from the jet centerline to the surface face was varied between 1 and 16 jet diameters. Far-field and phased array noise data were acquired at each combination of surface length and radial location using two nozzles operating at jet exit conditions across several flow regimes: subsonic cold, subsonic hot, underexpanded, ideally expanded, and overexpanded supersonic. The far-field noise results, discussed here, show where the jet noise is partially shielded by the surface and where jet-surface interaction noise dominates the low frequency spectrum as a surface extends downstream and approaches the jet plume.

Implementation of the Ffowcs Williams-Hawkings Equation: Predicting the Far Field Noise From Airfoils While Using Boundary Layer Tripping Mechanisms

2018 ◽  
Author(s):  
Andrew L. Bodling ◽  
Anupam Sharma
Keyword(s):  
Boundary Layer ◽  
High Frequency ◽  
Permeable Surface ◽  
Far Field ◽  
Trailing Edge ◽  
Extraneous Noise ◽  
Field Noise ◽  
High Frequency Waves

A study was done to investigate how boundary layer tripping mechanisms can affect the ability of a permeable surface FW-H solver to predict the far field noise emanating from an airfoil trailing edge. The far field noise in a baseline airfoil as well as the baseline airfoil fitted with fin let fences was analyzed. Two numerical boundary layer tripping mechanisms were implemented. The results illustrated the importance of choosing a permeable integration surface that is outside any high frequency waves emanating from the trip region. The results also illustrated the importance of choosing a boundary layer tripping mechanism that minimizes any extraneous noise so that an integration surface can be taken close to the airfoil.

scholarly journals A fast computational model for near- and far-field noise prediction due to offshore pile driving

2021 ◽  
Vol 149 (3) ◽  
pp. 1772-1790
Author(s):  
Yaxi Peng ◽  
Apostolos Tsouvalas ◽  
Tasos Stampoultzoglou ◽  
Andrei Metrikine
Keyword(s):  
Computational Model ◽  
Pile Driving ◽  
Noise Prediction ◽  
Far Field ◽  
Field Noise

scholarly journals Bioinspired aerofoil adaptations: the next steps for theoretical models

2019 ◽  
Vol 377 (2159) ◽  
pp. 20190070 ◽  
Author(s):  
Lorna J. Ayton
Keyword(s):  
Experimental Data ◽  
Theoretical Models ◽  
Theoretical Modelling ◽  
Experimental Measurements ◽  
Far Field ◽  
Acoustic Analogy ◽  
Trailing Edge ◽  
Trailing Edge Noise ◽  
Theoretical Predictions ◽  
Field Noise

The extended introduction in this paper reviews the theoretical modelling of leading- and trailing-edge noise, various bioinspired aerofoil adaptations to both the leading and trailing edges of blades, and how these adaptations aid in the reduction of aerofoil–turbulence interaction noise. Attention is given to the agreement between current theoretical predictions and experimental measurements, in particular, for turbulent interactions at the trailing edge of an aerofoil. Where there is a poor agreement between theoretical models and experimental data the features neglected from the theoretical models are discussed. Notably, it is known that theoretical predictions for porous trailing-edge adaptations do not agree well with experimental measurements. Previous works propose the reason for this: theoretical models do not account for surface roughness due to the porous material and thus omit a key noise source. The remainder of this paper, therefore, presents an analytical model, based upon the acoustic analogy, to predict the far-field noise due to a rough surface at the trailing edge of an aerofoil. Unlike previous roughness noise models which focus on roughness over an infinite wall, the model presented here includes diffraction by a sharp edge. The new results are seen to be in better agreement with experimental data than previous models which neglect diffraction by an edge. This new model could then be used to improve theoretical predictions for far-field noise generated by turbulent interactions with a (rough) porous trailing edge. This article is part of the theme issue ‘Frontiers of aeroacoustics research: theory, computation and experiment’.

Sign in / Sign up

Export Citation Format

Share Document