Large-Eddy Simulation of a Single Airfoil Tip-Leakage Flow

AIAA Journal ◽  
2021 ◽  
pp. 1-12
Author(s):  
Régis Koch ◽  
Marlène Sanjosé ◽  
Stéphane Moreau
Keyword(s):  
Large Eddy Simulation ◽  
Leakage Flow ◽  
Tip Leakage Flow ◽  
Tip Leakage ◽  
Eddy Simulation ◽  
Large Eddy

Cut-cell method based large-eddy simulation of tip-leakage flow

2015 ◽  
Vol 27 (7) ◽  
pp. 075106 ◽  
Author(s):  
Alexej Pogorelov ◽  
Matthias Meinke ◽  
Wolfgang Schröder
Keyword(s):  
Large Eddy Simulation ◽  
Leakage Flow ◽  
Tip Leakage Flow ◽  
Tip Leakage ◽  
Cell Method ◽  
Eddy Simulation ◽  
Cut Cell ◽  
Large Eddy

Investigation of Turbulence Characteristics in a Tip Leakage Flow Model Using Large-Eddy Simulation

2019 ◽  
Author(s):  
Yanfei Gao ◽  
Yangwei Liu ◽  
Lipeng Lu
Keyword(s):  
Large Eddy Simulation ◽  
Flow Model ◽  
Side Wall ◽  
Leakage Flow ◽  
Mean Flow ◽  
Tip Leakage Flow ◽  
Turbulence Characteristics ◽  
Tip Leakage ◽  
Eddy Simulation ◽  
Large Eddy

Abstract A simple tip leakage flow (TLF) model which consists of a square duct with a longitudinal slit on the top of a side wall is proposed to reproduce the jet flow/main flow shear mechanism of the tip leakage vortex (TLV) rolling-up in turbomachinery. Large-eddy simulation (LES) is employed to investigate the turbulence characteristics of the flow model under low Reynolds number condition. The geometry and boundary conditions of the flow model are simplified from a compressor rotor and modified to apply to low-Re condition for LES. The vortex structures and turbulence characteristics of the LES results are compared with the measurements of the rotor. It is found that the flow model could reproduce similar flow field and turbulence structures compared with the TLF in the real rotor, thus it can be used to investigate the turbulence in practical flows. Reynolds-Averaged Navier-Stokes (RANS) calculations are also carried out. The mean flow and turbulence behaviors of different cases are analyzed. The budgets of turbulent kinetic energy (k) are analyzed to investigate the turbulence transport nature in the TLF model, indicating that the non-equilibrium transport process of k is significant, especially the pressure and turbulent transport, which is not predicted by RANS.

Prediction of Unsteady Tip Leakage Flow of a Transonic Compressor Rotor by Reynolds-Stress-Constrained Large Eddy Simulation

2018 ◽  
Author(s):  
Yueqing Zhuang ◽  
Hui Liu
Keyword(s):  
Large Eddy Simulation ◽  
Reynolds Stress ◽  
Rotor Blade ◽  
Leading Edge ◽  
Leakage Flow ◽  
Tip Leakage Flow ◽  
Tip Leakage ◽  
Transonic Compressor ◽  
Eddy Simulation ◽  
Large Eddy

Since the unsteadiness of tip leakage flow has profound effects on both aerodynamic performance and stall margin of axial compressors, it is important to accurately predict the transient tip flow at affordable computational cost. Limited by the high requirement of grid resolution of wall turbulence flow, large eddy simulation (LES) method is greatly restricted in engineering application. In the present work, a Reynolds-stress-constrained large eddy simulation (CLES) method has been introduced, in which the whole domain is simulated using LES while Reynolds stress constraint is enforced on the subgrid-scale (SGS) stress model for near-wall regions aiming at reducing the near-wall grid resolution. The CLES simulations have been performed to investigate the flow behaviors of the unsteady tip leakage flow in a transonic compressor NASA Rotor 67 at near-stall conditions. Reliability assessments have been conducted through comparisons of experimental measurements and numerical results obtained by RANS, DES, CLES as well as LES, respectively. Both the total pressure ratio and isentropic efficiency calculated by CLES agree well with experiment. The turbulence statistical results show three distinct high flow fluctuation regions near the blade tip. The first one is a long and narrow strip ahead of the leading edge of the rotor caused by the movement of the passage shock wave. The second one is formed on the suction side from the leading-edge of the rotor blade due to the oscillation of the tip leakage vortex. And the third one, which occupies most of the blade passage from the middle part of the rotor blade, is generated under multiple factors. The frequency characteristic of the unsteady tip leakage flow has been analyzed. The energy spectrums of the local transient pressure signals are highly related with the local unsteady flow features. The originating mechanisms of the flow unsteadiness in the rotor tip leakage flow have also been discussed, and the results show that the flow unsteadiness is mainly caused by a combined interaction effect of the double leakage flow, the tip leakage vortex flow spilled from the adjacent blade passage, as well as the involved main flow.

Zonal large-eddy simulation of a tip leakage flow

2016 ◽  
Vol 15 (6-7) ◽  
pp. 646-661 ◽  
Author(s):  
Jérôme Boudet ◽  
Joëlle Caro ◽  
Bo Li ◽  
Emmanuel Jondeau ◽  
Marc C Jacob
Keyword(s):  
Large Eddy Simulation ◽  
Leakage Flow ◽  
Tip Leakage Flow ◽  
Tip Leakage ◽  
Eddy Simulation ◽  
Large Eddy

scholarly journals Numerical Prediction of the Aerodynamics and Acoustics of a Tip Leakage Flow Using Large-Eddy Simulation

2021 ◽  
Vol 6 (3) ◽  
pp. 27
Author(s):  
David Lamidel ◽  
Guillaume Daviller ◽  
Michel Roger ◽  
Hélène Posson
Keyword(s):  
Large Eddy Simulation ◽  
Complex Structure ◽  
Flow Region ◽  
Leakage Flow ◽  
Tip Leakage Flow ◽  
Tip Leakage Vortex ◽  
Tip Leakage ◽  
Eddy Simulation ◽  
Wall Pressure Fluctuations ◽  
Large Eddy

A Large-Eddy Simulation of the tip leakage flow of a single airfoil is carried out. The configuration consists of a non-rotating, isolated airfoil between two horizontal plates with a gap of 10 mm between the tip of the airfoil and the lower plate. The Mach number of the incoming flow is 0.2, and the Reynolds number based on the chord is 9.3 × 105. The objective of the present study is to investigate the best way to compute both the aerodynamics and acoustics of the tip leakage flow. In particular, the importance of the inflow conditions on the prediction of the tip leakage vortex and the airfoil loading is underlined. On the other hand, the complex structure of the tip leakage vortex and its convection along the airfoil was recovered due to the use of a mesh adaptation based on the dissipation of the kinetic energy. Finally, the ability of the wall law to model the flow in the tip leakage flow region was proven in terms of wall pressure fluctuations and acoustics in the far-field.

scholarly journals Aerodynamic investigation of a linear cascade with tip gap using large-eddy simulation

2021 ◽  
Vol 5 ◽  
pp. 39-49
Author(s):  
Koch Régis ◽  
Sanjosé Marlène ◽  
Moreau Stéphane
Keyword(s):  
Boundary Layer ◽  
Large Eddy Simulation ◽  
Suction Side ◽  
Leakage Flow ◽  
Compressor Cascade ◽  
Tip Leakage Flow ◽  
Tip Leakage Vortex ◽  
Tip Leakage ◽  
Eddy Simulation ◽  
Large Eddy

The flow in a linear compressor cascade with tip gap is simulated using a wall-resolved compressible Large-Eddy Simulation. The cascade is based on the Virginia Tech Low Speed Cascade Wind Tunnel. The Reynolds number based on the chord is 3.88 x 10⁵ and the Mach number is 0.07. The gap considered in this study is 4.0 mm (2.9% of axial chord). An aerodynamic analysis of the tip-leakage flow allow us identifying the main mechanisms responsible for the development and the convection of the tip-leakage vortex downstream of the cascade. A region of high turbulence and vorticity levels is located along an ellipse that borders the top of the tip-leakage vortex. The influence of the airfoil suction side boundary layer development on the tip-leakage vortex is highlighted by tripping the flow. A tripped boundary layer induces a stronger and larger tip-leakage vortex that tends to move further away from the airfoil suction side and from the endwall compared with an untripped flow. The boundary layer turbulent state influences the tip-leakage flow development.

Vortex Structures Analysis and Loss Mechanisms in Axial Compressor Cascade With and Without Bleeding Slot Using Large Eddy Simulation

2020 ◽  
Author(s):  
Yun Gong ◽  
Shaowen Chen ◽  
Haipeng Zheng ◽  
Songtao Wang
Keyword(s):  
Large Eddy Simulation ◽  
Axial Compressor ◽  
Vortex Structures ◽  
Leakage Flow ◽  
Compressor Cascade ◽  
Tip Leakage Flow ◽  
Tip Leakage ◽  
Eddy Simulation ◽  
Passage Vortex ◽  
Large Eddy

Abstract Tip leakage flow is one of the main sources of flow losses in an axial compressor, and the understanding of the tip leakage flow helps to explore better flow control methods and design more advanced compressors. Therefore, the vortex structures and loss mechanisms were analyzed in a compressor cascade with tip clearance in the present paper. Large eddy simulation was used to better resolve the vortices with more accurate numerical results. The iso-surface of Q criterion in the compressor cascade is captured for recognizing and analyzing the vortex structures. The horse shoe vortices, tip leakage vortex, induced vortex, tip separation vortex and passage vortex were well captured and their interactions were interpreted. Fast Fourier Transformation was also applied to analyze the frequency signal in the flow field. Afterwards, the case with an upstream bleeding slot was also calculated and compared with the original case without a bleeding slot. The bleeding rate is 2.8% of the mass flow rate at inlet. The removal of the inlet boundary layer resulting from the bleeding leads a 42.4% reduction of the total pressure loss coefficient compared with that of the case without the bleeding slot. In the case with the bleeding slot, the size of the passage vortex is greatly reduced, and the mixing between the tip leakage vortex and passage vortex is postponed. Better performance is achieved with the bleeding slot accordingly.

scholarly journals Zonal Large-Eddy Simulation of a Fan Tip-Clearance Flow, With Evidence of Vortex Wandering

2015 ◽  
Vol 137 (6) ◽  
Author(s):  
Jérôme Boudet ◽  
Adrien Cahuzac ◽  
Philip Kausche ◽  
Marc C. Jacob
Keyword(s):  
Large Eddy Simulation ◽  
Good Description ◽  
Region Of Interest ◽  
Tip Clearance ◽  
Velocity Spectrum ◽  
Tip Leakage Flow ◽  
Tip Clearance Flow ◽  
Tip Leakage ◽  
Eddy Simulation ◽  
Large Eddy

The flow in a fan test-rig is studied with combined experimental and numerical methods, with a focus on the tip-leakage flow. A zonal RANS/LES approach is introduced for the simulation: the region of interest at tip is computed with full large-eddy simulation (LES), while Reynolds-averaged Navier–Stokes (RANS) is used at inner radii. Detailed comparisons with the experiment show that the simulation gives a good description of the flow. In the region of interest at tip, a remarkable prediction of the velocity spectrum is achieved, over about six decades of energy. The simulation precisely captures both the tonal and broadband contents. Furthermore, a detailed analysis of the simulation allows identifying a tip-leakage vortex (TLV) wandering, whose influence onto the spectrum is also observed in the experiment. This phenomenon might be due to excitation by upstream turbulence from the casing boundary layer and/or the adjacent TLV. It may be a precursor of rotating instability. Finally, considering the outlet duct acoustic spectrum, the vortex wandering appears to be a major contribution to noise radiation.

Sign in / Sign up

Export Citation Format

Share Document