Blade Passage Loads and Deformation of a Coaxial Rotor System in Hover

2019 ◽  
Vol 56 (6) ◽  
pp. 2144-2157 ◽  
Author(s):  
Daiju Uehara ◽  
Jayant Sirohi ◽  
Roland Feil ◽  
Jürgen Rauleder
Keyword(s):  
Rotor System ◽  
Blade Passage ◽  
Coaxial Rotor

scholarly journals Spectrum Analysis of a Coaxial Dual-Rotor System with Coupling Misalignment

2020 ◽  
Vol 2020 ◽  
pp. 1-19
Author(s):  
Hongxian Zhang ◽  
Liangpei Huang ◽  
Xuejun Li ◽  
Lingli Jiang ◽  
Dalian Yang ◽  
...  
Keyword(s):  
Spectral Characteristics ◽  
Element Model ◽  
Rotor System ◽  
Harmonic Frequencies ◽  
Coaxial Rotor ◽  
Outer Rotor ◽  
Frequency Components ◽  
Harmonic Resonance ◽  
The Finite Element Model ◽  
Engine Rotor

The finite element model of a dual-rotor system was established by Timoshenko beam element. The dual-rotor system is a coaxial rotor whose supporting structure is similar to that of an aero-engine rotor system. The inner rotor is supported by three bearings, which makes it a redundantly supported rotor. The outer rotor connects the inner rotor by an intershaft bearing. The spectrum characteristics of the dual-rotor system under unbalanced excitation and misalignment excitation were analysed in order to study the influence of coupling misalignment of the inner rotor on the spectral characteristics of the rotor system. The results indicate that the vibration caused by the misaligned coupling of the inner rotor will be transmitted to the outer rotor through the intershaft bearing. Multiple harmonic frequency components, mainly 1x and 2x, will be excited by the coupling misalignment. The amplitudes of all harmonic frequencies increase with the misalignment in both the inner and outer rotors. The vibration level of the outer rotor affected by the misalignment is lower than that of the inner rotor because it is far from the misaligned coupling. Harmonic resonance occurs when any harmonic frequencies of the misalignment response coincide with a natural frequency of the system. In order to verify the theoretical model, experiments are performed on a test rig. Both the experimental and simulation results are in good accordance with each other.

Sensitivity Analysis and Uncertainty Quantification of a Coaxial Rotor System

2019 ◽  
Author(s):  
Phuriwat Anusonti-Inthra ◽  
Ethan Corle ◽  
Brendan Smith ◽  
Zackery Nieto
Keyword(s):  
Sensitivity Analysis ◽  
Uncertainty Quantification ◽  
Rotor System ◽  
Coaxial Rotor

Aeromechanics Analysis of a High-Advance-Ratio Lift-Offset Coaxial Rotor System

2019 ◽  
Vol 56 (1) ◽  
pp. 166-178 ◽  
Author(s):  
Roland Feil ◽  
Jürgen Rauleder ◽  
Christopher G. Cameron ◽  
Jayant Sirohi
Keyword(s):  
Rotor System ◽  
Coaxial Rotor ◽  
Advance Ratio

Chaotic Vibration Analysis of a Coaxial Rotor System in Active Magnetic Bearings and Contact With Auxiliary Bearings

2016 ◽  
Vol 12 (3) ◽  
Author(s):  
Reza Ebrahimi ◽  
Mostafa Ghayour ◽  
Heshmatallah Mohammad Khanlo
Keyword(s):  
Dynamic Behavior ◽  
Rotor System ◽  
Magnetic Bearings ◽  
Effective Control ◽  
Speed Ratio ◽  
Maximum Lyapunov Exponent ◽  
Active Magnetic Bearings ◽  
Coaxial Rotor ◽  
Speed Parameter ◽  
Amb System

In many cases of rotating systems, such as jet engines, two or more coaxial shafts are used for power transmission between a high/low-pressure turbine and a compressor. The major purpose of this study is to predict the nonlinear dynamic behavior of a coaxial rotor system supported by two active magnetic bearings (AMBs) and contact with two auxiliary bearings. The model of the system is formulated by ten degrees-of-freedom in two different planes. This model includes gyroscopic moments of disks and geometric coupling of the magnetic actuators. The nonlinear equations of motion are developed by the Lagrange's equations and solved using the Runge–Kutta method. The effects of speed parameter, speed ratio of shafts, and gravity parameter on the dynamic behavior of the coaxial rotor–AMB system are investigated by the dynamic trajectories, power spectra analysis, Poincaré maps, bifurcation diagrams, and the maximum Lyapunov exponent. Also, the contact forces between the inner shaft and auxiliary bearings are studied. The results indicate that the speed parameter, speed ratio of shafts, and gravity parameter have significant effects on the dynamic responses and can be used as effective control parameters for the coaxial rotor–AMB system. Also, the results of analysis reveal a variety of nonlinear dynamical behaviors such as periodic, quasi-periodic, period-4, and chaotic vibrations, as well as jump phenomena. The obtained results of this research can give some insight to engineers and researchers in designing and studying the coaxial rotor–AMB systems or some turbomachinery in the future.

scholarly journals Wind Tunnel Studies on Hover and Forward Flight Performances of a Coaxial Rigid Rotor

Aerospace ◽  
2021 ◽  
Vol 8 (8) ◽  
pp. 205
Author(s):  
Chang Wang ◽  
Minqi Huang ◽  
Xianmin Peng ◽  
Guichuan Zhang ◽  
Min Tang ◽  
...  
Keyword(s):  
Wind Tunnel ◽  
Tilt Angle ◽  
Lift Coefficient ◽  
Rotor System ◽  
Rigid Rotor ◽  
Forward Flight ◽  
Coaxial Rotor ◽  
Advance Ratio ◽  
Hover Flight ◽  
Development Center

The aerodynamic performance of a reduced-scale coaxial rigid rotor system in hover and steady forward flights was experimentally investigated to gain insights into the effect of interference between upper and lower rotors and the influences of the advance ratio, shaft tilt angle and lift offset. The rotor system featured by 2 m-diameter, four-bladed upper and lower hingeless rotors and was installed in a coaxial rotor test rig. Experiments were conducted in the Φ3.2 m wind tunnel at China Aerodynamics Research and Development Center (CARDC). The rotor system was tested in hover states at collective pitches ranging from 0° to 13° and it was also tested in forward flights at advance ratios up to 0.6, with specific focus on the shaft tilt angle and lift offset sweeps. To ensure that the coaxial rotor was operating in a similar manner to that of the real flight, the torque difference was trimmed to zero in hover flight, whilst the constant lift coefficient was maintained in forward flight. An isolated single-rotor configuration test was also conducted with the same pitch angle setting in the coaxial rotor. The hover test results demonstrate that the figure of merit (FM) value of the lower rotor is lower than that of the upper rotor, and both are lower than that of the isolated single rotor. Moreover, the coaxial rotor configuration can contribute to better hover efficiency under the same blade loading coefficient (CT/σ). In forward flight, the effective lift-to-drag (L/De) ratio of the coaxial rigid rotor does not monotonously change as the advance ratio increases. Increases in the required power and drag in the case with a high advance ratio of 0.6 leads to the decreasing L/De ratio of the rotor. Meanwhile, the L/De ratio of the rotor is relatively high when the rotor shaft is tilted backward. The increasing lift offset tends to result in reduced required rotor power and an increase in the rotor drag. When the effect of the reduced rotor power is greater than that of the increased rotor drag, the L/De ratio increases as the lift offset increases. The L/De ratio can benefit significantly from lift offset at a high advance ratio, but it is much less influenced by lift offset at a low advance ratio. The forward performance efficiency of the upper rotor is poorer than that of the lower rotor, which is significantly different from the case in the hover flight.

scholarly journals Research on modeling and dynamic characteristics of complex coaxial rotor system

2017 ◽  
Vol 19 (3) ◽  
pp. 1524-1545 ◽  
Author(s):  
Fei Wang ◽  
Gui-Huo Luo ◽  
Xi-Guan Yang ◽  
Hai-Tao Cui
Keyword(s):  
Dynamic Characteristics ◽  
Rotor System ◽  
Coaxial Rotor
Sign in / Sign up

Export Citation Format

Share Document