Lift Enhancement at Low Reynolds Numbers Using Self-Activated Movable Flaps

2010 ◽  
Vol 47 (1) ◽  
pp. 348-351 ◽  
Author(s):  
Jorg U. Schluter
Keyword(s):  
Reynolds Numbers ◽  
Low Reynolds Numbers ◽  
Lift Enhancement ◽  
Low Reynolds

Lift Enhancement by Plasma Actuators at Low Reynolds Numbers

2013 ◽  
Vol 50 (1) ◽  
pp. 12-19 ◽  
Author(s):  
Alexander Vorobiev ◽  
R. M. Rennie ◽  
Eric J. Jumper
Keyword(s):  
Reynolds Numbers ◽  
Plasma Actuators ◽  
Low Reynolds Numbers ◽  
Lift Enhancement ◽  
Low Reynolds

scholarly journals Lift Enhancement by Means of Small-Amplitude Airfoil Oscillations at Low Reynolds Numbers

AIAA Journal ◽  
2011 ◽  
Vol 49 (9) ◽  
pp. 2018-2033 ◽  
Author(s):  
D. J. Cleaver ◽  
Z. Wang ◽  
I. Gursul ◽  
M. R. Visbal
Keyword(s):  
Small Amplitude ◽  
Reynolds Numbers ◽  
Low Reynolds Numbers ◽  
Lift Enhancement ◽  
Low Reynolds

A Leading-Edge Alula-Inspired Device (LEAD) for Stall Mitigation and Lift Enhancement for Low Reynolds Number Finite Wings

2018 ◽  
Author(s):  
Mihary R. Ito ◽  
Chengfang Duan ◽  
Leonardo P. Chamorro ◽  
Aimy A. Wissa
Keyword(s):  
Aspect Ratio ◽  
Flow Separation ◽  
Three Dimensional ◽  
Leading Edge ◽  
Reynolds Numbers ◽  
Tip Vortices ◽  
Low Reynolds Numbers ◽  
Lift Enhancement ◽  
Low Reynolds ◽  
Torque Transducer

Even though Unmanned Aerial Vehicles (UAVs) operating at low Reynolds numbers are becoming common, their performance and maneuverability are still greatly limited due to aerodynamic phenomena such as stall and flow separation. Birds mitigate these limitations by adapting their wings and feather shapes during flight. Equipped with a set of small feathers, known as the alula, located near the leading edge and covering 5% to 20% of the span, bird wings can sustain the lift necessary to fly at low velocities and high angles of attack. This paper presents the effect on lift generation of different placements of a Leading-Edge Alula-inpsired Device (LEAD) along the span of a moderate aspect-ratio wing. The device is modeled after the alula on a bird, and it increases the capability of a wing to maintain higher pressure gradients by modifying the near-wall flow close to the leading-edge. It also generates tip vortices that modify the turbulence on the upper-surface of the wing, delaying flow separation. The effect of the LEAD can be compared to traditional slats or vortex generators on two-dimensional wings. For finite wings, on the other hand, the effect depends on the interaction between the LEADs tip vortices and those from the main structure. Wind tunnel experiments were conducted on a cambered wing at post-stall and deep-stall angles of attack at low Reynolds numbers of 100,000 and 135,000. To quantify the aerodynamic effect of the device, the lift generated by the wing with and without the LEAD were measured using a 6-axis force and torque transducer, and the resulting lift coefficients were compared. Results show that the location of the LEAD yielding the highest lift enhancement was 50% semi-span away from the wing root. Lift improvements of up to 32% for post stall and 37% for deep stall were obtained at this location, demonstrating that the three-dimensional effects of the LEAD are important. The lift enhancement was also more prominent on a finite moderate aspect-ratio wing (3D) than on an airfoil (2D), confirming that the LEAD is a three-dimensional device. Identifying the configurations and deployment parameters that improve lift generation the most is needed to design an adaptive LEAD that can be implemented on a UAV wing for increased mission-adaptability.

Investigation on the effect of leading edge tubercles of sweptback wing at low reynolds number

2020 ◽  
Vol 21 (6) ◽  
pp. 621
Author(s):  
Veerapathiran Thangaraj Gopinathan ◽  
John Bruce Ralphin Rose ◽  
Mohanram Surya
Keyword(s):  
Leading Edge ◽  
Reynolds Numbers ◽  
Sweep Angle ◽  
Laminar Separation ◽  
Low Reynolds Numbers ◽  
Flow Energy ◽  
Airplane Wing ◽  
Low Reynolds ◽  
Naca 0015 ◽  
Wing Performance

Aerodynamic efficiency of an airplane wing can be improved either by increasing its lift generation tendency or by reducing the drag. Recently, Bio-inspired designs have been received greater attention for the geometric modifications of airplane wings. One of the bio-inspired designs contains sinusoidal Humpback Whale (HW) tubercles, i.e., protuberances exist at the wing leading edge (LE). The tubercles have excellent flow control characteristics at low Reynolds numbers. The present work describes about the effect of tubercles on swept back wing performance at various Angle of Attack (AoA). NACA 0015 and NACA 4415 airfoils are used for swept back wing design with sweep angle about 30°. The modified wings (HUMP 0015 A, HUMP 0015 B, HUMP 4415 A, HUMP 4415 B) are designed with two amplitude to wavelength ratios (η) of 0.1 & 0.24 for the performance analysis. It is a novel effort to analyze the tubercle vortices along the span that induce additional flow energy especially, behind the tubercles peak and trough region. Subsequently, Co-efficient of Lift (CL), Co-efficient of Drag (CD) and boundary layer pressure gradients also predicted for modified and baseline (smooth LE) models in the pre & post-stall regimes. It was observed that the tubercles increase the performance of swept back wings by the enhanced CL/CD ratio in the pre-stall AoA region. Interestingly, the flow separation region behind the centerline of tubercles and formation of Laminar Separation Bubbles (LSB) were asymmetric because of the sweep.

Low Reynolds number flow around and heat transfer from a heated circular cylinder

2010 ◽  
Vol 1 (1-2) ◽  
pp. 15-20 ◽  
Author(s):  
B. Bolló
Keyword(s):  
Reynolds Number ◽  
Circular Cylinder ◽  
Lift Coefficient ◽  
Reynolds Numbers ◽  
Low Reynolds Numbers ◽  
Reynolds Number Flow ◽  
Two Dimensional Flow ◽  
Number Flow ◽  
Low Reynolds ◽  
Increasing Temperature

Abstract The two-dimensional flow around a stationary heated circular cylinder at low Reynolds numbers of 50 < Re < 210 is investigated numerically using the FLUENT commercial software package. The dimensionless vortex shedding frequency (St) reduces with increasing temperature at a given Reynolds number. The effective temperature concept was used and St-Re data were successfully transformed to the St-Reeff curve. Comparisons include root-mean-square values of the lift coefficient and Nusselt number. The results agree well with available data in the literature.

Sign in / Sign up

Export Citation Format

Share Document