New Asymptotic Temperature-Heat Flux Integral Relationship in Cylindrical Coordinates

2009 ◽  
Vol 23 (1) ◽  
pp. 191-197 ◽  
Author(s):  
J. I. Frankel
Keyword(s):  
Heat Flux ◽  
Cylindrical Coordinates ◽  
Integral Relationship ◽  
Temperature Heat

Fabrication and electrical properties of polymer-derived ceramic (PDC) thin films for high-temperature heat flux sensors

2011 ◽  
Vol 165 (2) ◽  
pp. 250-255 ◽  
Author(s):  
Duckbong Seo ◽  
Sunghoon Jung ◽  
Stephen J. Lombardo ◽  
Z.C. Feng ◽  
J.K. Chen ◽  
...  
Keyword(s):  
Thin Films ◽  
Heat Flux ◽  
High Temperature ◽  
Electrical Properties ◽  
Heat Flux Sensors ◽  
Polymer Derived Ceramic ◽  
Temperature Heat

Measurement of Temperature and Heat Flux Changes During the Fixing Process in Electrophotographic Machines

1996 ◽  
Vol 118 (1) ◽  
pp. 150-154 ◽  
Author(s):  
T. Mitsuya ◽  
K. Masuda ◽  
Y. Hori
Keyword(s):  
Heat Flux ◽  
Print Quality ◽  
Two Dimensional ◽  
Temperature Changes ◽  
One Dimensional ◽  
Temperature Heat ◽  
Rapid Temperature ◽  
Pressure Changes ◽  
The Relationship ◽  
Electrophotographic Printing

Increasingly higher speeds of modern electrophotographic printing force examination of the problem of retaining sufficient fixing strength without deterioration of print quality. In the nip region between the two rollers where fixing occurs, the significant parameters are temperature, heat flux, and pressure changes. Their optimization is necessary to maintain both speed and print quality. Difficulty in analyzing the relationship among these parameters occurs because of the complexity of two-dimensional phenomena in a rotating field and the rapidity of changes. Experimental equipment to measure relative heat flux in the nip region during rapid temperature changes was designed. Two sensors are installed in the heat roller. An adiabatic piece is buried under sensor 1. Sensor 2, without an adiabatic piece, detects temperature. Sensor 1 is electrically heated and always at the same temperature as sensor 2. Heat flux changes are obtained by noting the electric power supplied to sensor 1. The equipment was fabricated and measurements were made. They indicate an intermittent two-dimensional heat flux. Because of this, temperature decreases rapidly before the entrance to the nip region. Estimates of two-dimensional effects are made and modified for a one-dimensional case. From them, the temperature field in the nip region for actual fixing conditions is calculated.

Sign in / Sign up

Export Citation Format

Share Document