scholarly journals Influence of pre-treatment methods on the adsorption of cadmium ions by chestnut shell

2010 ◽  
Author(s):  
G. Vázquez ◽  
O. Mosquera ◽  
M. S. Freire ◽  
G. Antorrena ◽  
J. González-Álvarez
Keyword(s):  
Treatment Methods ◽  
Cadmium Ions ◽  
Chestnut Shell ◽  
Pre Treatment

Minimizing of foaming in digesters by pre-treatment of the surplus-sludge

2000 ◽  
Vol 42 (9) ◽  
pp. 235-241 ◽  
Author(s):  
M. Barjenbruch ◽  
H. Hoffmann ◽  
O. Kopplow ◽  
J. Tränckner
Keyword(s):  
High Pressure ◽  
Activated Sludge ◽  
Treatment Methods ◽  
Foaming Agents ◽  
Instance Reduction ◽  
Filamentous Microorganisms ◽  
Hydrophobic Substances ◽  
Pre Treatment ◽  
Heating Up ◽  
The Impact

Several reasons can lead to the emergence of foam in digesting tanks, for instance overloading or the impact of hydrophobic substances. Furthermore, the foaming is in regular periods going together with the emergence of filamentous microorganisms. Up to now, several strategies to avoid foaming have been tested out (for instance reduction of the sludge load in the activated sludge stage, lowering of the sludge level in the digestion tank, dosage of anti foaming agents), but these have been done relatively unsystematically and with more or less success. For our contribution, laboratory-scale digestion tests were run to analyse mechanical and thermal pre-treatment methods for the destruction of the surplus sludge. Whereas the disintegration by a high pressure homogeniser did only achieve a low reduction of the foam phase, the thermal pre-treatment at 121°C made for an effective subduing of the foam emergence. Both methods allowed for a cutting up of the filaments, but only the heating up effected the reduction of the hydrophobic substances; thus, the foaming is possibly caused by them.

Advances in Eco-Friendly Pre-Treatment Methods and Utilization of Agro-Based Lignocelluloses

2017 ◽  
pp. 371-419 ◽  
Author(s):  
Mohd Azmuddin Abdullah ◽  
Muhammad Shahid Nazir ◽  
Huma Ajab ◽  
Safoura Daneshfozoun ◽  
Sakinatu Almustapha
Keyword(s):  
Treatment Methods ◽  
Pre Treatment

scholarly journals Investigation of Three Pre-treatment Methods Prior to Nanofiltration Membrane for Palm Oil Mill Effluent Treatment

2015 ◽  
Vol 44 (3) ◽  
pp. 421-427 ◽  
Author(s):  
Muhammad Said ◽  
Abdul Wahab Mohammad ◽  
Mohd Tusirin Mohd Nor ◽  
Siti Rozimah Sheikh Abdullah ◽  
Hassimi Abu Hasan
Keyword(s):  
Palm Oil ◽  
Effluent Treatment ◽  
Palm Oil Mill Effluent ◽  
Nanofiltration Membrane ◽  
Treatment Methods ◽  
Palm Oil Mill ◽  
Pre Treatment

scholarly journals Effect of pre treatment methods on fruits drying of grapes under warm air condition

2018 ◽  
Vol 33 (01) ◽  
Author(s):  
Priti Jain ◽  
S. P. Shrivastava ◽  
Sheela Pandey
Keyword(s):  
Olive Oil ◽  
Soy Lecithin ◽  
Drying Time ◽  
Treatment Methods ◽  
Pre Treatment ◽  
Drying Rates

In the present study, grapes pretreated with different concentrations of potassium carbonates plus olive oil and soy lecithin with different dipping times. A dryer was built to perform the experiment under controlled condition of drying air at temperature 50°C and velocity 1.0 m/s. Grapes dipped into 1percentage olive oil plus 6percentage K2CO3 emulsion, at 50°C for 2 min. prior to drying showed shorter drying times and comparatively good quality raisin, whereas grapes dipped into 1.5percentage soy lecithin, at same conditions resulted in a total drying time slightly higher than the most effective pre treatment. The drying rates of grapes were modeled by the page equations. Grapes that are naturally dried usually darken in colour, whereas dipped grapes stay yellow-green.

Alkaline pre-treatment of waste chestnut shell from a food industry to enhance cadmium, copper, lead and zinc ions removal

2012 ◽  
Vol 184 ◽  
pp. 147-155 ◽  
Author(s):  
Gonzalo Vázquez ◽  
Olga Mosquera ◽  
M. Sonia Freire ◽  
Gervasio Antorrena ◽  
Julia González-Álvarez
Keyword(s):  
Food Industry ◽  
Zinc Ions ◽  
Lead And Zinc ◽  
Chestnut Shell ◽  
Pre Treatment ◽  
Copper Lead

scholarly journals Hydrolytic pre-treatment methods for enhanced biobutanol production from agro-industrial wastes

2018 ◽  
Vol 249 ◽  
pp. 673-683 ◽  
Author(s):  
Sampa Maiti ◽  
Gorka Gallastegui ◽  
Gayatri Suresh ◽  
Saurabh Jyoti Sarma ◽  
Satinder Kaur Brar ◽  
...  
Keyword(s):  
Industrial Wastes ◽  
Treatment Methods ◽  
Pre Treatment

scholarly journals Pre-Treatment Methods for Regeneration of Spent Activated Carbon

Molecules ◽  
2020 ◽  
Vol 25 (19) ◽  
pp. 4561
Author(s):  
Sang Youp Hwang ◽  
Gi Bbum Lee ◽  
Ji Hyun Kim ◽  
Bum Ui Hong ◽  
Jung Eun Park
Keyword(s):  
Activated Carbon ◽  
Surface Area ◽  
Acid Treatment ◽  
Chemical Activation ◽  
Fixed Carbon ◽  
Treatment Methods ◽  
Positive Effects ◽  
Area Increase ◽  
Pre Treatment ◽  
Surface Area Increase

Spent activated carbon (SAC) usually exhibits a low specific surface area due to its high ash contents. In this study, pre-treatments, such as heat and acid treatments, were optimized to improve this feature. The heat pre-treatment did not reduce the ash content, nor did it increase the surface area. Because metallic ions adsorbed in SACs turn into ash upon the heat treatment. In the acid pre-treatment, the volatiles and fixed carbon were increased with decreasing ash contents. In this study, it was found that the surface area increase was correlated with the ratio between fixed carbon and ash. Among the pre-treatment methods, the combined heat and acid pre-treatment method highly increased the ratio, and therefore led to the surface area increase. Additionally, the acid pre-treatment was carried out using different types of acid (organic and inorganic acids) solutions to further improve the surface areas. The organic acid treatment caused a significant structural collapse compared to the inorganic acid treatment, decreasing the surface area. In particular, H3PO4 effectively removed ashes adsorbed on the activated carbon surface and regenerated the exhausted activated carbon. Both the heat and acid pre-treatments before chemical activation resulted in the positive effects such as strong desorption of pollutants and ashes within the internal structure of the activated carbon. Therefore, the regeneration introduced in this study is methodically the best method to regenerate SAC and maintain a stable structure.

Sign in / Sign up

Export Citation Format

Share Document