Posture control of adaptive sliding-mode controller for flexible parallel robots actuated by pneumatic artificial muscles

2014 ◽  
Author(s):  
M.K. Chang
Keyword(s):  
Sliding Mode ◽  
Parallel Robots ◽  
Posture Control ◽  
Artificial Muscles ◽  
Sliding Mode Controller ◽  
Adaptive Sliding Mode ◽  
Adaptive Sliding Mode Controller ◽  
Pneumatic Artificial Muscles

scholarly journals Design of RBF Adaptive Sliding Mode Controller for A Supercavitating Vehicle

IEEE Access ◽  
2021 ◽  
Vol 9 ◽  
pp. 39873-39883
Author(s):  
Wang Jinghua ◽  
Liu Yang ◽  
Cao Guohua ◽  
Zhao Yongyong ◽  
Zhang Jiafeng
Keyword(s):  
Sliding Mode ◽  
Sliding Mode Controller ◽  
Adaptive Sliding Mode ◽  
Adaptive Sliding Mode Controller ◽  
Supercavitating Vehicle

Impact analysis and adaptive sliding mode control for cislunar payload transportation using spinning tether system

2018 ◽  
Vol 90 (8) ◽  
pp. 1168-1179 ◽  
Author(s):  
Hongshi Lu ◽  
Li Aijun ◽  
Wang Changqing ◽  
Zabolotnov Michaelovitch Yuriy
Keyword(s):  
Impact Analysis ◽  
Sliding Mode ◽  
Mass Parameter ◽  
Sliding Mode Controller ◽  
Content Type ◽  
Loop Control ◽  
Adaptive Sliding Mode ◽  
Adaptive Sliding Mode Controller ◽  
Payload Mass ◽  
Spinning Tether

Purpose This paper aims to present the impact analysis of payload rendezvous with tethered satellite system and the design of an adaptive sliding mode controller which can deal with mass parameter uncertainty of targeted payload, so that the proposed cislunar transportation scheme with spinning tether system could be extended to a wider and more practical range. Design/methodology/approach In this work, dynamical model is first derived based on Langrangian equations to describe the motion of a spinning tether system in an arbitrary Keplerian orbit, which takes the mass of spacecraft, tether and payload into account. Orbital design and optimal open-loop control for the payload tossed by the spinning tether system are then presented. The real payload rendezvous impact around docking point is also analyzed. Based on reference acceleration trajectory given by optimal theories, a sliding mode controller with saturation functions is designed in the close-loop control of payload tossing stage under initial disturbance caused by actual rendezvous error. To alleviate the influence of inaccurate/unknown payload mass parameters, the adaptive law is designed and integrated into sliding mode controller. Finally, the performance of the proposed controller is evaluated using simulations. Simulation results validate that proposed controller is found effective in driving the spinning tether system to carry payload into desired cislunar transfer orbit and in dealing with payload mass parameter uncertainty in a relatively large range. Findings The results show that unideal rendezvous manoeuvres have significant impact on in-plane motion of spinning tether system, and the proposed adaptive sliding mode controller with saturation functions not only guarantees the stability but also provides good performance and robustness against the parameter and unstructured uncertainties. Originality/value This work addresses the analysis of actual impact on spinning tether system motion when payload is docking with system within tolerated docking window, rather than at the particular ideal docking point, and the robust tracking control of deep-space payload tossing missions with the spinning tether system using the adaptive sliding mode controller dealing with parameter uncertainties. This combination has not been proposed before for tracking control of multivariable spinning tether systems.

An adaptive sliding mode controller for the lateral control of articulated long vehicles

2018 ◽  
Vol 233 (3) ◽  
pp. 487-515 ◽  
Author(s):  
Naser Esmaeili ◽  
Reza Kazemi ◽  
S Hamed Tabatabaei Oreh
Keyword(s):  
High Speed ◽  
Sliding Mode ◽  
Sliding Mode Controller ◽  
Lane Change ◽  
Lateral Velocity ◽  
Low Speed ◽  
Adaptive Sliding Mode ◽  
Adaptive Sliding Mode Controller ◽  
Articulated Vehicle ◽  
The Stability

Today, use of articulated long vehicles is surging. The advantages of using large articulated vehicles are that fewer drivers are used and fuel consumption decreases significantly. The major problem of these vehicles is inappropriate lateral performance at high speed. The articulated long vehicle discussed in this article consists of tractor and two semi-trailer units that widely used to carry goods. The main purpose of this article is to design an adaptive sliding mode controller that is resistant to changing the load of trailers and measuring the noise of the sensors. Control variables are considered as yaw rate and lateral velocity of tractor and also first and second articulation angles. These four variables are regulated by steering the axles of the articulated vehicle. In this article after developing and verifying the dynamic model, a new adaptive sliding mode controller is designed on the basis of a nonlinear model. This new adaptive sliding mode controller steers the axles of the tractor and trailers through estimation of mass and moment of inertia of the trailers to maintain the stability of the vehicle. An articulated vehicle has been exposed to a lane change maneuver based on the trailer load in three different modes (low, medium and high load) and on a dry and wet road. Simulation results demonstrate the efficiency of this controller to maintain the stability of this articulated vehicle in a low-speed steep steer and high-speed lane change maneuvers. Finally, the robustness of this controller has been shown in the presence of measurement noise of the sensors. In fact, the main innovation of this article is in the designing of an adaptive sliding mode controller, which by changing the load of the trailers, in high-speed and low-speed maneuvers and in dry and wet roads, has the best performance compared to conventional sliding mode and linear controllers.

scholarly journals Design of Adaptive Sliding Mode Controller for Uncertain Pendulum System

2021 ◽  
Vol 39 (3A) ◽  
pp. 355-369
Author(s):  
Dina H. Tohma ◽  
Ahmed K. Hamoudi
Keyword(s):  
Control Method ◽  
Sliding Mode ◽  
Sliding Mode Controller ◽  
External Disturbances ◽  
Control Effort ◽  
Pendulum System ◽  
Adaptive Sliding Mode ◽  
Adaptive Sliding Mode Controller ◽  
Parameters Uncertainty ◽  
Better Than

This work aims to study and apply the adaptive sliding mode controller (ASMC) for the pendulum system with the existence of the parameters uncertainty, external disturbances, and coulomb friction. The adaptive sliding mode controller has several features over the conventional sliding mode control method. Firstly, the magnitude of the control signal is reduced to the minimally acceptable level defined by special conditions concerned with ASMC algorithm. Secondly, the upper bounds of uncertainties are not necessary to be defined before starting the work. For this reason, the ASMC can be used successfully to control the pendulum system with minimum control effort. These properties of the ASMC are confirming graphically by the simulation results using MATLAB 2019. The ASMC achieves an asymptotically stable system better than the Classical Sliding Mode Controller (CSMC). The unwanted phenomenon is called “chattering", which is appearing in the control action signal. These drawback properties are suppressed by employing a saturation function. Finally, the comparison between the results of the ASMC and CSMC showed that ASMC is the better one.

Sign in / Sign up

Export Citation Format

Share Document