scholarly journals Special Issue on Fracture Mechanics. Analysis of Stress/Strain Field and Damage Evolution around a Crack-tip in Particulate-Reinforced Composite.

1994 ◽  
Vol 43 (493) ◽  
pp. 1211-1217
Author(s):  
Keiichiro TOHGO ◽  
Naomori SUZUKI ◽  
Hitoshi ISHII
Keyword(s):  
Fracture Mechanics ◽  
Strain Field ◽  
Damage Evolution ◽  
Crack Tip ◽  
Special Issue ◽  
Stress Strain ◽  
Reinforced Composite ◽  
Mechanics Analysis ◽  
Particulate Reinforced

Specimens for Simultaneous Mode II, III and II+III Fatigue Crack Propagation: Elasto-Plastic Solution of Crack Tip Stress-Strain Field

2014 ◽  
Vol 891-892 ◽  
pp. 1585-1590 ◽  
Author(s):  
Jana Horníková ◽  
Pavel Šandera ◽  
Stanislav Žák ◽  
Jaroslav Pokluda
Keyword(s):  
Fatigue Crack ◽  
Crack Growth ◽  
Strain Field ◽  
Simple Procedure ◽  
Crack Tip ◽  
Small Scale ◽  
Shear Mode ◽  
Mode Ii ◽  
Threshold Region ◽  
Stress Strain

Determination of fatigue crack growth characteristics under shear-mode loading is a rather complicated problem. To increase an efficiency and precision of such testing, special specimens enabling simultaneous propagation of shear cracks under II, III and II+III loading modes started to be used rather recently. K-calibration of these specimens was performed and, after unique pre-crack and heat-treatment procedures, effective thresholds in several metallic materials could be measured. However, a description of crack growth rate in terms of appropriate fracture mechanics quantities demands a precise assessment of plastic zone size under various shear-mode loading levels. This contribution is focused on the numerical elasto-plastic analysis of stress-strain field at the crack tip in specimens made of a pure polycrystalline (ARMCO) iron. The results reveal that the small scale yielding conditions are fulfilled in the near-threshold region. Starting from ΔK values approximately two times higher than the threshold, however, the ΔKJ or ΔJ approach should already be utilized. Probably the most interesting result of the analysis lies in a simple procedure that enables us to separate individual loading components ΔKJ,II and ΔKJ,III, applied in the mixed-mode II+III part of the specimen, by comparing elasto-plastic and elastic solutions.

Sign in / Sign up

Export Citation Format

Share Document