scholarly journals Comparison of Multi-Resonant- and Hysteresis Band Controllers used in Current Control Loop of Shunt Active Power Filter

2012 ◽  
pp. 1832-1837
Author(s):  
Rastislav Ravlanin ◽  
Pavol Spanik ◽  
Branislav Dobrucky
Keyword(s):  
Active Power Filter ◽  
Active Power ◽  
Current Control ◽  
Control Loop ◽  
Shunt Active Power Filter ◽  
Power Filter

scholarly journals Improving Power Quality by a Four-Wire Shunt Active Power Filter: A Case Study

Energies ◽  
2021 ◽  
Vol 14 (7) ◽  
pp. 1951
Author(s):  
Mihaela Popescu ◽  
Alexandru Bitoleanu ◽  
Mihaita Linca ◽  
Constantin Vlad Suru
Keyword(s):  
Power Quality ◽  
Quality Indicators ◽  
Reactive Power ◽  
Control Method ◽  
Active Power Filter ◽  
Active Power ◽  
Current Control ◽  
Shunt Active Power Filter ◽  
Power Filter ◽  
Unbalanced Load

This paper presents the use of a three-phase four-wire shunt active power filter to improve the power quality in the Department of Industrial Electronics of a large enterprise from Romania. The specificity is given by the predominant existence of single-phase consumers (such as personal computers, printers, lighting and AC equipment). In order to identify the power quality indicators and ways to improve them, an A-class analyzer was used to record the electrical quantities and energy parameters in the point of common coupling (PCC) with the nonlinear loads for 27 h. The analysis shows that, in order to improve the power quality in PCC, three goals must be achieved: the compensation of the distortion power, the compensation of the reactive power and the compensation of the load unbalance. By using the conceived three-leg shunt active power filter, controlled through the indirect current control method in an original variant, the power quality at the supply side is very much improved. In the proposed control algorithm, the prescribed active current is obtained as a sum of the loss current provided by the DC voltage and the equivalent active current of the unbalanced load. The performance associated with each objective of the compensation is presented and analyzed. The results show that all the power quality indicators meet the specific standards and regulations and prove the validity of the proposed solution.

scholarly journals Cooperation of Voltage Controlled Active Power Filter with Grid-Connected DGs in Microgrid

2018 ◽  
Vol 11 (1) ◽  
pp. 154 ◽  
Author(s):  
Hafiz Munir ◽  
Jianxiao Zou ◽  
Chuan Xie ◽  
Josep Guerrero
Keyword(s):  
Power Distribution ◽  
Distribution Systems ◽  
Active Power Filter ◽  
Active Power ◽  
Current Control ◽  
Control Loop ◽  
Renewable Energy Resources ◽  
Harmonic Compensation ◽  
Power Filter ◽  
Voltage Feedback

Due to the excessive use of nonlinear loads and inverter interfaced distributed generators, harmonic issues have been regarded as a major concern in power distribution systems. Therefore, harmonic compensation in microgrids is a subject of current interest. Consequently, a novel direct harmonic voltage-controlled mode (VCM) active power filter (APF) is proposed to mitigate the harmonics in a cooperative manner and provide a better harmonic compensation performance of less than 5%. Due to the dispersive characteristics of renewable energy resources, voltage feedback based on a harmonic compensation control loop is implemented for the first time. This system can be smoothly combined with the current control loop. Our method proposes a better performance while mitigating the harmonics in comparison with conventional resistive active power filters (R-APF). Based on direct voltage detection at the point of common coupling (PCC), the proposed VCM-APF can therefore be seamlessly incorporated with multiple grid-connected generators (DGs) to enhance their harmonic compensation capabilities. The advantage of this scheme is that it avoids the need for designing and tuning the resistance, which was required in earlier conventional control schemes of R-APF for voltage unbalance compensation. Additionally, our scheme does not require the grid and load current measurements since these can be carried out at the PCC voltage, which further reduces the implementation cost of the system. Furthermore, the simulation results show the significance of proposed method.

Hierarchical neuro-fuzzy current control for a shunt active power filter

2006 ◽  
Vol 15 (3-4) ◽  
pp. 223-238 ◽  
Author(s):  
K. Çağatay Bayındır ◽  
M. Uğraş Cuma ◽  
Mehmet Tümay
Keyword(s):  
Active Power Filter ◽  
Active Power ◽  
Current Control ◽  
Shunt Active Power Filter ◽  
Power Filter ◽  
Neuro Fuzzy
Sign in / Sign up

Export Citation Format

Share Document