Identification and Area Measurement of the Built-up Area with the Built-up Index (BUI)

2016 ◽  
Vol 5 (1) ◽  
pp. 1844-1858 ◽  
Author(s):  
Dimitris Kaimaris ◽  
◽  
Petros Patias ◽  
Keyword(s):  
Diabetes ◽  
2019 ◽  
Vol 68 (Supplement 1) ◽  
pp. 2114-P
Author(s):  
TAKUYA MINAMIZUKA ◽  
YUKARI MAEDA ◽  
MASAYA KOSHIZAKA ◽  
TAKAHIRO ISHIKAWA ◽  
YOSHIRO MAEZAWA ◽  
...  

Author(s):  
Bhargav Appasani ◽  
Amitkumar Vidyakant Jha ◽  
Sunil Kumar Mishra ◽  
Abu Nasar Ghazali

AbstractReal time monitoring and control of a modern power system has achieved significant development since the incorporation of the phasor measurement unit (PMU). Due to the time-synchronized capabilities, PMU has increased the situational awareness (SA) in a wide area measurement system (WAMS). Operator SA depends on the data pertaining to the real-time health of the grid. This is measured by PMUs and is accessible for data analytics at the data monitoring station referred to as the phasor data concentrator (PDC). Availability of the communication system and communication delay are two of the decisive factors governing the operator SA. This paper presents a pragmatic metric to assess the operator SA and ensure optimal locations for the placement of PMUs, PDC, and the underlying communication infrastructure to increase the efficacy of operator SA. The uses of digital elevation model (DEM) data of the surface topography to determine the optimal locations for the placement of the PMU, and the microwave technology for communicating synchrophasor data is another important contribution carried out in this paper. The practical power grid system of Bihar in India is considered as a case study, and extensive simulation results and analysis are presented for validating the proposed methodology.


2021 ◽  
Vol 7 (2) ◽  
pp. 258-261
Author(s):  
Rodrigo Bruno Biagioni ◽  
Bruno Vinicius Carvalho ◽  
Renato Manzioni ◽  
Marcelo Fernando Matielo ◽  
Francisco Cardoso Brochado Neto ◽  
...  

Diversity ◽  
2021 ◽  
Vol 13 (7) ◽  
pp. 288
Author(s):  
Ryan G. Eagleson ◽  
John S. Lumsden ◽  
Lorenzo Álvarez-Filip ◽  
Christophe M. Herbinger ◽  
Ryan A. Horricks

Despite coral community collapse, the mustard hill coral (Porites astreoides) is a species currently experiencing success throughout the Caribbean. The inshore reefs of Grenada were selected to study the influence of benthic factors on the abundance, size, and coverage of P. astreoides colonies. Surveys of reef communities along established 30 m transects were conducted at eight sites in 2014 and 2017 using a 0.5 m² quadrat. Coral Point Count was used to annotate the images, estimating the coverage of scleractinian corals, sponges, algae, and benthic substrates. Coverage, size, and abundance of P. astreoides colonies were quantified using the area measurement tool in ImageJ standardized against the quadrats. There were significant differences in benthic community assemblages between islands, selected sites, and between years. From 2014 to 2017 there was a significant decrease in the mean abundance of P. astreoides colonies and significant increases in mean colony size and coverage. The presence of P. astreoides colonies was significantly correlated with: rubble (−), sand (−); pavement (+); macroalgae (−); coralline algae (+); sponges (varying response); gorgonians (−); massive corals (+); and branching corals (−). P. astreoides follows similar recruitment patterns as other scleractinian corals. Observed changes in P. astreoides populations appear to indicate a recovery event following a disturbance, potentially tropical storm Chantal in 2013.


2021 ◽  
Vol 0 (0) ◽  
Author(s):  
Mohamed S. Yahia ◽  
Ahmed S. Elzaref ◽  
Magdy B. Awad ◽  
Ahmed M. Tony ◽  
Ahmed S. Elfeky

Abstract Commercial Granulated Active Carbon (GAC) has been modified using 10 Gy dose Gamma irradiation (GAC10 Gy) for increasing its ability of air purification. Both, the raw and treated samples were applied for removing Chlorpyrifos pesticide (CPF) from ambient midair. Physicochemical properties of the two materials were characterized by Fourier Transform Infrared (FT-IR) and Raman spectroscopy. The phase formation and microstructure were monitored using X-ray Diffraction (XRD), Scanning Electron Microscopy (SEM), supported with Energy-Dispersive X-ray (EDX). The Surface area measurement was detected using BET particle size prosometry. Obtained outcomes showed that, the maximum adsorption capacity, given by Langmuir equations, was greatly increased from 172.712 to 272.480 mg/g for GAC and GAC10 Gy, respectively, with high selectivity. The overall removal efficiency of GAC10 Gy was notably comparable to that of the original GAC-sorbent. The present study indicated that, gamma irradiation could be a promising technique for treating GAC and turned it more active in eliminating the pesticides pollutants from surrounding air. The data of equilibrium has been analyzed by Langmuir and Freundlich models, that were considerably better suited for the investigated materials than other models. The process kinetics of CPF adsorbed onto both tested carbon versions were found to obey the pseudo first order at all concentrations with an exception at 70 mg/l using GAC, where, the spontaneous exothermic adsorption of Chlorpyrifos is a strong function for the pseudo-first order (PFO) and pseudo second order (PSO) kinetics.


2019 ◽  
Vol 22 (2) ◽  
pp. 85-115
Author(s):  
Amanda L. Cullen ◽  
Jeffrey E. Barrett
Keyword(s):  

Catalysts ◽  
2020 ◽  
Vol 11 (1) ◽  
pp. 34
Author(s):  
Devendra P. Tekale ◽  
Ganapati D. Yadav ◽  
Ajay K. Dalai

Value addition to glycerol, the sole co-product in biodiesel production, will lead to reform of the overall biodiesel economy. Different valuable chemicals can be produced from glycerol using heterogeneous catalysis and these valuable chemicals are useful in industries such as cosmetics, pharmaceuticals, fuels, soap, paints, and fine chemicals. Therefore, the conversion of glycerol to valuable chemicals using heterogeneous catalysis is a noteworthy area of research. Etherification of glycerol with alkenes or alcohols is an important reaction in converting glycerol to various value-added chemicals. This article describes reaction of glycerol with benzyl alcohol in solvent-free medium by using a clay supported modified heteropolyacid (HPA), Cs2.5H0.5PW12O40/K-10 (Cs-DTP/K-10) as solid catalyst and its comparison with other catalysts in a batch reactor. Mono-Benzyl glycerol ether (MBGE) was the major product formed in the reaction along with formation of di-benzyl glycerol ether (DBGE). The effects of different parameters were studied to optimize the reaction parameters. This work provides an insight into characterization of Cs2.5H0.5PW12O40/K-10 catalyst by advanced techniques such as surface area measurement, X-ray analysis, ICP-MS, FT-IR, and SEM. Reaction products were characterized and confirmed by using the GCMS method. The kinetic model was developed from an insight into the reaction mechanism. The apparent energy of activation was found to be 18.84 kcal/mol.


Author(s):  
Filipe Ferreira ◽  
Ivan Miguel Pires ◽  
Vasco Ponciano ◽  
Monica Costa ◽  
Nuno M. Garcia

Sign in / Sign up

Export Citation Format

Share Document