scholarly journals A consensus-based voltage control for reactive power sharing and PCC voltage regulation in microgrids with parallel-connected inverters

2019 ◽  
Author(s):  
Ajay Krishna ◽  
Johannes Schiffer ◽  
Nima Monshizadeh ◽  
Jorg Raisch
Keyword(s):  
Reactive Power ◽  
Voltage Control ◽  
Voltage Regulation ◽  
Power Sharing

scholarly journals Contribution of Voltage Support Function to Virtual Inertia Control Performance of Inverter-Based Resource in Frequency Stability

Energies ◽  
2021 ◽  
Vol 14 (14) ◽  
pp. 4220
Author(s):  
Dai Orihara ◽  
Hiroshi Kikusato ◽  
Jun Hashimoto ◽  
Kenji Otani ◽  
Takahiro Takamatsu ◽  
...  
Keyword(s):  
Reactive Power ◽  
Control Function ◽  
Current Source ◽  
Voltage Control ◽  
Frequency Stability ◽  
Voltage Regulation ◽  
System Stability ◽  
Voltage Source ◽  
Apparent Difference ◽  
Virtual Inertia

Inertia reduction due to inverter-based resource (IBR) penetration deteriorates power system stability, which can be addressed using virtual inertia (VI) control. There are two types of implementation methods for VI control: grid-following (GFL) and grid-forming (GFM). There is an apparent difference among them for the voltage regulation capability, because the GFM controls IBR to act as a voltage source and GFL controls it to act as a current source. The difference affects the performance of the VI control function, because stable voltage conditions help the inertial response to contribute to system stability. However, GFL can provide the voltage control function with reactive power controllability, and it can be activated simultaneously with the VI control function. This study analyzes the performance of GFL-type VI control with a voltage control function for frequency stability improvement. The results show that the voltage control function decreases the voltage variation caused by the fault, improving the responsivity of the VI function. In addition, it is found that the voltage control is effective in suppressing the power swing among synchronous generators. The clarification of the contribution of the voltage control function to the performance of the VI control is novelty of this paper.

scholarly journals Power factor control of PV generators in local distribution networks using fuzzy logic concept

2018 ◽  
Vol 7 (2.28) ◽  
pp. 362
Author(s):  
Raed A. Shalwala
Keyword(s):  
Fuzzy Logic ◽  
Control System ◽  
Power Factor ◽  
Fuzzy Logic Control ◽  
Reactive Power ◽  
Distribution Network ◽  
Voltage Control ◽  
Distribution Networks ◽  
Voltage Regulation ◽  
Logic Control

One of the most important operational requirements for any electrical power network for both distribution and transmission level is voltage control. Many studies have been carried out to improve or develop new voltage control techniques to facilitate safe connection of distributed generation. In Saudi Arabia, due to environmental, economic and development perspectives, a wide integration of photovoltaic (PV) genera-tion in distribution network is expected in the near future. This development in the network may cause voltage regulation problems due to the interaction with the existing conventional control system. In a previous paper, a control system has been described using a fuzzy logic control to set the on-line tap changer for the primary substation. In this paper a new control system is proposed for controlling the power factor of individual PV invertors based on observed correlation between net active and reactive power at each connection. A fuzzy logic control has been designed to alter the power factor for the remote invertors from the secondary substation to keep the feeder voltage within the permissible limits. In order to confirm the validity of the proposed method, simulations are carried out for a realistic distribution network with real data for load and solar radiation. Results showing the performance of the new control method are presented and discussed.  

scholarly journals Simultaneous reactive power sharing and voltage regulation in an autonomous networked microgrid

2020 ◽  
Vol 14 (7) ◽  
pp. 1366-1377
Author(s):  
Mohsen Eskandari ◽  
Li Li ◽  
Mohammad H. Moradi ◽  
Pierluigi Siano ◽  
Frede Blaabjerg
Keyword(s):  
Reactive Power ◽  
Voltage Regulation ◽  
Power Sharing

scholarly journals Consensus Control of Distributed Energy Resources in a Multi-Bus Microgrid for Reactive Power Sharing and Voltage Control

Energies ◽  
2018 ◽  
Vol 11 (10) ◽  
pp. 2710 ◽  
Author(s):  
Li Yu ◽  
Di Shi ◽  
Guangyue Xu ◽  
Xiaobin Guo ◽  
Zhen Jiang ◽  
...  
Keyword(s):  
Distribution System ◽  
Reactive Power ◽  
Hierarchical Control ◽  
Voltage Control ◽  
Power Sharing ◽  
Consensus Control ◽  
Distributed Generator ◽  
Distributed Generators ◽  
Control Framework ◽  
Major Factors

The hierarchical control architecture, including layers of primary, secondary and tertiary controls, is becoming the standard operating paradigm for microgrids (MGs). Two major factors that limit the adoption of existing hierarchical control in microgrid are the low accuracy in reactive power sharing and the requirement for complex communication infrastructure. This paper addresses this problem by proposing a novel distributed primary and secondary control for distributed generators dispersed in a multi-bus microgrid. The proposed method realizes voltage control and accurate reactive power sharing in a distributed manner using minimum communication. Each distributed generator only needs its own information and minimum information from its neighboring units. Topology of the network can be flexible which supports the plug-and-play feature of microgrids. In a distribution system, high R/X ratio and system imbalance can no longer be neglected and thus the sequence component analysis and virtual impedance are implemented in the proposed control framework. The proposed framework is validated by simulation results on a MG testbed modified from the IEEE 13-bus distribution system.

scholarly journals Secondary voltage regulation based on average voltage control

TecnoLógicas ◽  
2018 ◽  
Vol 21 (42) ◽  
pp. 63-78
Author(s):  
Edwin H. Lopera-Mazo ◽  
Jairo Espinosa
Keyword(s):  
Control System ◽  
Power Systems ◽  
Reactive Power ◽  
Voltage Control ◽  
Voltage Regulation ◽  
Voltage Profile ◽  
Real Power ◽  
Power Resources ◽  
Control Actions ◽  
Secondary Voltage

This paper compares a conventional Secondary Voltage Regulation (SVR) scheme based on pilot nodes with a proposed SVR that takes into account average voltages of control zones. Voltage control significance for the operation of power systems has promoted several strategies in order to deal with this problem. However, the Hierarchical Voltage Control System (HVCS) is the only scheme effectively implemented with some relevant applications into real power systems.The HVCS divides the voltage control problem into three recognized stages. Among them, the SVR is responsible for managing reactive power resources to improve network voltage profile. Conventional SVR is based on dividing the system into some electrically distant zones and controlling the voltage levels of some specific nodes in the system named pilot nodes, whose voltage levels are accepted as appropriate indicators of network voltage profile.The SVR approach proposed in this work does not only consider the voltage on pilot nodes, but it also takes the average voltages of the defined zones to carry out their respective control actions. Additionally, this innovative approach allows to integrate more reactive power resources into each zone according to some previously defined participation factors.The comparison between these strategies shows that the proposed SVR achieves a better allocation of reactive power in the system than conventional SVR, and it is able to keep the desired voltage profile, which has been expressed in terms of network average voltage.

scholarly journals A Reactive Power-Voltage Control Strategy of an AC Microgrid Based on Adaptive Virtual Impedance

Energies ◽  
2019 ◽  
Vol 12 (16) ◽  
pp. 3057
Author(s):  
Yao Liu ◽  
Lin Guan ◽  
Fang Guo ◽  
Jianping Zheng ◽  
Jianfu Chen ◽  
...  
Keyword(s):  
Distributed Generation ◽  
Control Strategy ◽  
Reactive Power ◽  
Reference Value ◽  
Voltage Control ◽  
Power Sharing ◽  
Voltage Reference ◽  
Voltage Control Strategy ◽  
Voltage Recovery ◽  
Virtual Impedance

As an effective carrier of distributed generation, a microgrid is an effective way to ensure that distributed power can be reasonably utilized. However, due to the property of line impedance and other factors in a microgrid, reactive power supplied by distributed generation units cannot be shared rationally. To efficiently improve reactive power sharing, this paper proposes a reactive power-voltage control strategy based on adaptive virtual impedance. This method changes the voltage reference value by adding an adaptive term based on the traditional virtual impedance. Meanwhile, a voltage recovery mechanism was used to compensate the decline of distributed generation (DG) output voltage in the process. MATLAB/Simulink simulations and experimental results show that the proposed controller can effectively improve the steady state performance of the active and reactive power sharing. Finally, the feasibility and effectiveness of the proposed control strategy were verified.

Sign in / Sign up

Export Citation Format

Share Document