Automatically controlled laser-based welding process for repair of CFRP parts

2022 ◽  
Vol 34 (1) ◽  
pp. 012006
Author(s):  
Simon Hirt ◽  
Jan Erik Battmer ◽  
Verena Wippo ◽  
Peter Jaeschke ◽  
Stefan Kaierle ◽  
...  
Keyword(s):  
Welding Process

Effects of bottom plate in friction stir welding of AA6061-T6

2020 ◽  
Vol 118 (1) ◽  
pp. 108
Author(s):  
M.A. Vinayagamoorthi ◽  
M. Prince ◽  
S. Balasubramanian
Keyword(s):  
Mechanical Properties ◽  
Axial Load ◽  
Weld Zone ◽  
Welding Process ◽  
Bottom Plate ◽  
Welding Parameters ◽  
Nugget Zone ◽  
Friction Stir ◽  
Weld Joints ◽  
Fine Grain

The effects of 40 mm width bottom plates on the microstructural modifications and the mechanical properties of a 6 mm thick FSW AA6061-T6 joint have been investigated. The bottom plates are placed partially at the weld zone to absorb and dissipate heat during the welding process. An axial load of 5 to 7 kN, a rotational speed of 500 rpm, and a welding speed of 50 mm/min are employed as welding parameters. The size of the nugget zone (NZ) and heat-affected zone (HAZ) in the weld joints obtained from AISI 1040 steel bottom plate is more significant than that of weld joints obtained using copper bottom plate due to lower thermal conductivity of steel. Also, the weld joints obtained using copper bottom plate have fine grain microstructure due to the dynamic recrystallization. The friction stir welded joints obtained with copper bottom plate have exhibited higher ductility of 8.9% and higher tensile strength of 172 MPa as compared to the joints obtained using a steel bottom plate.

THERMOMECHANICAL ANALYSIS OF THE RESISTANCE SPOT-WELDING PROCESS

2018 ◽  
Vol 10 (5) ◽  
pp. 449-455 ◽  
Author(s):  
Habib Lebbal ◽  
Lahouari Boukhris ◽  
Habib Berrekia ◽  
Abdelkader Ziadi
Keyword(s):  
Resistance Spot Welding ◽  
Spot Welding ◽  
Welding Process ◽  
Thermomechanical Analysis ◽  
Resistance Spot
Sign in / Sign up

Export Citation Format

Share Document