The characteristic of laser forming aluminum sheet under consecutive irradiations

Laser forming of steel is a hot forming process with high heating and cooling rate, during which strain hardening, dynamic recrystallization, and phase transformation take place. Numerical models considering strain rate and temperature effects only usually give unsatisfactory results when applied to multiscan laser forming operations. This is mainly due to the inadequate constitutive models employed to describe the hot flow behavior. In this work, this limitation is overcome by considering the effects of microstructure change on the flow stress in laser forming processes of low carbon steel. The incorporation of such flow stress models with thermal mechanical FEM simulation increases numerical model accuracy in predicting geometry change and mechanical properties.

Download Full-text

Forming limit analysis for two-stage forming of 5182-O aluminum sheet with intermediate annealing

International Journal of Plasticity ◽

10.1016/j.ijplas.2012.10.004 ◽

2013 ◽

Vol 45 ◽

pp. 21-43 ◽

Cited By ~ 54

Author(s):

Jingjing Li ◽

John E. Carsley ◽

Thomas B. Stoughton ◽

Louis G. Hector ◽

S. Jack Hu

Keyword(s):

Limit Analysis ◽

Aluminum Sheet ◽

Forming Limit ◽

Intermediate Annealing ◽

Two Stage

Download Full-text

Affected Characteristics Analysis of the Pulsed Laser Forming of Metal Sheet

Key Engineering Materials ◽

10.4028/www.scientific.net/kem.375-376.333 ◽

2008 ◽

Vol 375-376 ◽

pp. 333-337

Author(s):

Li Jun Yang ◽

Yang Wang

Keyword(s):

Laser Beam ◽

Pulsed Laser ◽

Metal Sheet ◽

Grain Structure ◽

Experimental Result ◽

Laser Forming ◽

Forming Process ◽

Grain Orientations ◽

Characteristics Analysis ◽

Relationship Of

Laser forming of metal sheet is a forming technology of sheet without a die that the sheet is deformed by internal thermal stress induced by partially irradiation of a laser beam. In this paper, the bending behavior of common stainless steel 1Cr18Ni9 sheet is studied after being irradiated by straight line with a Nd:YAG pulsed laser beam. The aim of the investigation is to find out the relationship of the physical behaviors of heat affected zone (HAZ) with the pulse parameters of the laser. Through the analysis of the fundamental theory of pulsed laser affected, this paper shows the affected characteristics of metal sheet with pulsed laser forming. The results show that the microstructure of HAZ of pulsed laser scanned is layered, and the micro-hardness is improved than that in matrix. The microstructures show that the deformed grain structure is inhomogeneous, that caused the grain sizes and grain orientations in HAZ to become different. By qualitative analysis of experimental result, the conclusion obtained may provide basis for theoretical investigation and possible industrial application of laser forming process in the future.

Download Full-text