Relationship Between Grain Crushing and Excess Pore Pressure Generation by Sandy Soils in Ring-Shear Tests.

2000 ◽  
Vol 22 (2) ◽  
pp. 87-96 ◽  
Author(s):  
Fawu WANG ◽  
Kyoji SASSA
Keyword(s):  
Pore Pressure ◽  
Sandy Soils ◽  
Excess Pore Pressure ◽  
Shear Tests ◽  
Grain Crushing ◽  
Ring Shear ◽  
Ring Shear Tests ◽  
Excess Pore

scholarly journals Consolidated and Undrained Ring Shear Tests on the Sliding Surface of the Hsien-du-shan Landslide in Taiwan

Geofluids ◽  
2018 ◽  
Vol 2018 ◽  
pp. 1-12 ◽  
Author(s):  
Hung-Ming Lin ◽  
Jian-Hong Wu ◽  
Erik Sunarya
Keyword(s):  
Pore Pressure ◽  
Rock Avalanche ◽  
Excess Pore Pressure ◽  
High Water Content ◽  
Sliding Surface ◽  
Shear Tests ◽  
Typhoon Morakot ◽  
Ring Shear ◽  
Ring Shear Tests ◽  
Excess Pore

A new consolidated undrained ring shear test capable of measuring the pore pressures is presented to investigate the initiation mechanism of the Hsien-du-shan rock avalanche, triggered by Typhoon Morakot, in southern Taiwan. The postpeak state of the landslide surface between the Tangenshan sandstone and the remolded landslide gouge is discussed to address the unstable geomorphological precursors observed before the landslide occurred. Experimental results show that the internal friction angle of the high water content sliding surface in the total stress state, between 25.3 and 26.1°, clarifies the reason of the stable slope prior to Typhoon Morakot. In addition, during the ring shear tests, it is observed that the excess pore pressure is generated by the shear contractions of the sliding surface. The remolded landslide gouge, sheared under the high normal stress, rendered results associated with high shear strength, small shear contraction, low hydraulic conductivity, and continuous excess pore pressure. The excess pore pressure feedback at the sliding surface may have accelerated the landslide.

scholarly journals Excess pore pressure generation potential within shear zone by means of ring shear tests

Landslides ◽  
2002 ◽  
Vol 39 (3) ◽  
pp. 296-306
Author(s):  
Yasuhiko OKADA ◽  
Kyoji SASSA ◽  
Hiroshi FUKUOKA
Keyword(s):  
Pore Pressure ◽  
Shear Zone ◽  
Excess Pore Pressure ◽  
Shear Tests ◽  
Ring Shear ◽  
Ring Shear Tests ◽  
Excess Pore

Undrained shear behaviour of sands subjected to large shear displacement and estimation of excess pore-pressure generation from drained ring shear tests

2005 ◽  
Vol 42 (3) ◽  
pp. 787-803 ◽  
Author(s):  
Yasuhiko Okada ◽  
Kyoji Sassa ◽  
Hiroshi Fukuoka
Keyword(s):  
Pore Pressure ◽  
Triaxial Compression ◽  
Excess Pore Pressure ◽  
Compression Tests ◽  
Shear Tests ◽  
Ring Shear ◽  
Ring Shear Tests ◽  
Triaxial Compression Tests ◽  
Undrained Shear ◽  
Excess Pore

Undrained shear behaviour of fine silica and weathered granitic sand subjected to large shear displacement is examined. Parallel experiments using ring shear and the triaxial compression tests on soil specimens through a wide range of initial void ratios were conducted to investigate undrained shear strength as the key factor in the flow-like motion of landslides. The steady-state undrained shear strengths achieved in ring shear tests were, in general, smaller than those in the triaxial compression tests, probably because of the excess pore-pressure generation by grain crushing within the shear zone that occurred in ring shear. Very low steady-state shear strengths were achieved, however, in triaxial compression tests on the dense silica sand in which well-defined shear surfaces developed in the cylindrical specimens. In these triaxial compression tests, shear deformation must have been concentrated on these surfaces to generate excess pore pressure similar to that found in ring shear tests. An attempt was made to estimate excess pore pressure generated in undrained ring shear tests using the results of drained ring shear tests. The equivalent normal stress calculated as the ratio of volumetric strain in the drained test to the coefficient of volume change was introduced as a parameter for the estimation of excess pore-pressure generation for the large shear displacement that is usually found in landslides. Equivalent normal stress from drained tests was almost the same as the generated excess pore pressure in undrained tests with up to 1 m of shear displacement, at which the steady state was reached.Key words: undrained shear strength, excess pore pressure, equivalent normal stress, ring shear test, triaxial compression test, liquefaction.

Post-failure mobility of saturated sands in undrained load-controlled ring shear tests

2002 ◽  
Vol 39 (4) ◽  
pp. 821-837 ◽  
Author(s):  
Gonghui Wang ◽  
Kyoji Sassa
Keyword(s):  
Shear Strength ◽  
Steady State ◽  
Stress State ◽  
Initial Stress ◽  
Shear Behavior ◽  
Shear Tests ◽  
Grain Crushing ◽  
Ring Shear ◽  
Ring Shear Tests ◽  
Undrained Shear

The undrained shear behavior of soils with progress of shear displacement is essential to the understanding of liquefied slope failures with long travel distance. In this paper, using a newly developed ring shear apparatus, a series of ring-shear tests were conducted on a silty sand to examine the undrained behavior of sand subjected to long shear displacement. Based on the test results, the undrained shear behavior of sands with a wide range of densities is discussed. A very low effective stress corresponding to liquefaction was observed at the steady state in all of the tests on loose, medium, as well as dense sand. The effects of stress state and shear history on the undrained shear behavior were examined by performing tests on a sample with different initial stress states and shearing the same specimen repeatedly (three times) at each initial stress state. The tests at different initial stress states proved that the initial stress state has an influence on static liquefaction resistance but has no effect on the steady-state shear strength. Repeated shear tests on the same specimen showed that with increasing shear times, both the peak shear strength and the steady-state shear strength for each specimen became greater. Detailed examination of the shear deformation revealed that the liquefaction phenomena in ring shear tests are localized in the shear zone, irrespective of the initial state of the sand. Grain crushing within the shear zone was examined. Finally, it was found that there was an optimal density at which the undrained brittleness index had a minimum value; meanwhile, the undrained brittleness index became greater with increasing initial normal and shear stresses, but decreased with shear times. These findings offer some basic understanding in assessing the postfailure mobility in landslides.Key words: excess pore pressure, localized liquefaction, shear resistance, ring-shear tests, grain crushing, silty sands.

Vibro-Stone Column Reinforcement Mechanism and Numerical Analysis

2012 ◽  
Vol 446-449 ◽  
pp. 1940-1943
Author(s):  
Yang Liu ◽  
Hong Xiang Yan
Keyword(s):  
Numerical Simulation ◽  
Numerical Analysis ◽  
Pore Pressure ◽  
Numerical Procedure ◽  
Numerical Results ◽  
Excess Pore Pressure ◽  
Stone Column ◽  
Reinforcement Mechanism ◽  
Consolidation Theory ◽  
Excess Pore

Numerical simulation of vibro-stone column is taken to simulate the installation of vibro-stone column. A relationship based on test is adopted to calculate the excess pore pressure induced by vibratory energy during the installation of vibro-stone column. A numerical procedure is developed based on the formula and Terzaghi-Renduric consolidation theory. Finally numerical results of composite stone column are compared single stone column.

Sign in / Sign up

Export Citation Format

Share Document