Graphing the Complex Roots of a Quadratic Equation

1985 ◽  
Vol 16 (4) ◽  
pp. 257 ◽  
Author(s):  
Floyd Vest
2021 ◽  
Vol 114 (3) ◽  
pp. 238-243
Author(s):  
Thomas Edwards ◽  
S. Asli Özgün-Koca ◽  
Kenneth Chelst

A quadratic equation was the basis for activities involving both concrete and technological representations.


1970 ◽  
Vol 63 (3) ◽  
pp. 229
Author(s):  
W. G. Brady

The graphical method for solving a quadratic equation as it is usually presented indicates real roots and coincident roots as intersections of a certain parabola with the x-axis and signals, by failure of intersection, that the roots are either complex or imaginary. In this note, we shall show a geometric method for finding the complex roots of the quadratic.


2019 ◽  
Author(s):  
Chem Int

This work is aimed at developing a mathematical model equation that can be used to predict the fate of contaminant in the soil environment. The mathematical model was developed based on the fundamental laws of conservation and the equation of continuity given asand was resolved to obtain a quadratic equation of the form C(X) = DX2+vX+f. The developed equation was then used to fit the experimental data that were obtained from the Physio-chemical analysis of the soil samples which were obtained at various depths; within the vicinity of the H & H Asphalt plant Company, located at Enito 3 in Ahoada West L.G.A, River State, Nigeria. The Experimental and Model results obtained from the Calculation and Simulation of the developed models were compared numerically and graphically as presented in this work. It was observed that there is reasonable level of agreement between the three results. The polynomial of the curve was established to ascertain the validity of the model; this was done for all the parameters that were analyzed. From the findings the model developed can be used to predict the concentration of a chemical pollutant at various depths. The reliability of the model developed was established giving the fact that through this quadratic equation the diffusivity (coefficient of diffusion), the water velocity and the irreversible reaction decay rate could be determined.


Mathematics ◽  
2021 ◽  
Vol 9 (4) ◽  
pp. 317
Author(s):  
Diogo Freitas ◽  
Luiz Guerreiro Lopes ◽  
Fernando Morgado-Dias

Finding arbitrary roots of polynomials is a fundamental problem in various areas of science and engineering. A myriad of methods was suggested to address this problem, such as the sequential Newton’s method and the Durand–Kerner (D–K) simultaneous iterative method. The sequential iterative methods, on the one hand, need to use a deflation procedure in order to compute approximations to all the roots of a given polynomial, which can produce inaccurate results due to the accumulation of rounding errors. On the other hand, the simultaneous iterative methods require good initial guesses to converge. However, Artificial Neural Networks (ANNs) are widely known by their capacity to find complex mappings between the dependent and independent variables. In view of this, this paper aims to determine, based on comparative results, whether ANNs can be used to compute approximations to the real and complex roots of a given polynomial, as an alternative to simultaneous iterative algorithms like the D–K method. Although the results are very encouraging and demonstrate the viability and potentiality of the suggested approach, the ANNs were not able to surpass the accuracy of the D–K method. The results indicated, however, that the use of the approximations computed by the ANNs as the initial guesses for the D–K method can be beneficial to the accuracy of this method.


Minerals ◽  
2021 ◽  
Vol 11 (2) ◽  
pp. 184
Author(s):  
Liping Zhang ◽  
Xiaofei Jiao ◽  
Shengnian Wu ◽  
Xuejing Song ◽  
Ruihan Yao

A large amount of collectors, inhibitors and modifiers such as oleic acid, water glass and sodium carbonate are added to the flotation processing of tungsten ore, resulting in the difficulty of the suspended solids (SS) with the residual water glass settling down in the flotation wastewater. The removal efficiency of the suspended solids is low with commonly used reagents like polyaluminium chloride (PAC) and polyacrylamide (PAM). This paper innovatively applied calcium chloride (CaCl2) to treat flotation wastewater and optimized the dosage of CaCl2, PAM and the pH value. The experimental results showed that when the dosage of 595 mg/L CaCl2 was combined with 21 mg/L PAM at pH 12, the turbidity removal ratio could reach 99.98%, and the residual turbidity of the supernatant was 0.23 NTU. The effluent could fully meet the requirements for reuse in industrial, urban miscellaneous and scenic environment water consumption (turbidity < 5 NTU). The quadratic equation model fitted with Design-Expert 8.0.6 software was constructed as Y = 91.52 + 8.68A + 1.11B − 1.02C − 1.7AB + 0.86AC + 0.06BC − 1.56A2 + 2.09B2 − 1.89C2, which had a good accuracy of the predicted responses versus the experimental data.


Axioms ◽  
2021 ◽  
Vol 10 (3) ◽  
pp. 169
Author(s):  
Avram Sidi

The secant method is a very effective numerical procedure used for solving nonlinear equations of the form f(x)=0. In a recent work (A. Sidi, Generalization of the secant method for nonlinear equations. Appl. Math. E-Notes, 8:115–123, 2008), we presented a generalization of the secant method that uses only one evaluation of f(x) per iteration, and we provided a local convergence theory for it that concerns real roots. For each integer k, this method generates a sequence {xn} of approximations to a real root of f(x), where, for n≥k, xn+1=xn−f(xn)/pn,k′(xn), pn,k(x) being the polynomial of degree k that interpolates f(x) at xn,xn−1,…,xn−k, the order sk of this method satisfying 1<sk<2. Clearly, when k=1, this method reduces to the secant method with s1=(1+5)/2. In addition, s1<s2<s3<⋯, such that limk→∞sk=2. In this note, we study the application of this method to simple complex roots of a function f(z). We show that the local convergence theory developed for real roots can be extended almost as is to complex roots, provided suitable assumptions and justifications are made. We illustrate the theory with two numerical examples.


Author(s):  
Grzegorz Tytko ◽  
Łukasz Dawidowski

Purpose Discrete eigenvalues occur in eddy current problems in which the solution domain was truncated on its edge. In case of conductive material with a hole, the eigenvalues are complex numbers. Their computation consists of finding complex roots of a complex function that satisfies the electromagnetic interface conditions. The purpose of this paper is to present a method of computing complex eigenvalues that are roots of such a function. Design/methodology/approach The proposed approach involves precise determination of regions in which the roots are found and applying sets of initial points, as well as the Cauchy argument principle to calculate them. Findings The elaborated algorithm was implemented in Matlab and the obtained results were verified using Newton’s method and the fsolve procedure. Both in the case of magnetic and nonmagnetic materials, such a solution was the only one that did not skip any of the eigenvalues, obtaining the results in the shortest time. Originality/value The paper presents a new effective method of locating complex eigenvalues for analytical solutions of eddy current problems containing a conductive material with a hole.


Author(s):  
S. Brodetsky ◽  
G. Smeal

The only really useful practical method for solving numerical algebraic equations of higher orders, possessing complex roots, is that devised by C. H. Graeffe early in the nineteenth century. When an equation with real coefficients has only one or two pairs of complex roots, the Graeffe process leads to the evaluation of these roots without great labour. If, however, the equation has a number of pairs of complex roots there is considerable difficulty in completing the solution: the moduli of the roots are found easily, but the evaluation of the arguments often leads to long and wearisome calculations. The best method that has yet been suggested for overcoming this difficulty is that by C. Runge (Praxis der Gleichungen, Sammlung Schubert). It consists in making a change in the origin of the Argand diagram by shifting it to some other point on the real axis of the original Argand plane. The new moduli and the old moduli of the complex roots can then be used as bipolar coordinates for deducing the complex roots completely: this also checks the real roots.


1954 ◽  
Vol 61 (9) ◽  
pp. 640
Author(s):  
D. Trifan
Keyword(s):  

Sign in / Sign up

Export Citation Format

Share Document