On the Thomson Effect and the Temperature Coefficient of Thermal Conductivity in Soft Iron between 115° and 204° C

1907 ◽  
Vol 42 (22) ◽  
pp. 597
Author(s):  
Edwin H. Hall ◽  
L. L. Campbell ◽  
S. B. Serviss ◽  
E. P. Churchill
Keyword(s):  
Thermal Conductivity ◽  
Temperature Coefficient ◽  
Thomson Effect ◽  
Coefficient Of Thermal Conductivity

Thermal Conductivity of Complex Hydrocarbon Systems at Pressures Up To 1000 MPa

2016 ◽  
Vol 138 (11) ◽  
Author(s):  
Vladimir Kutcherov ◽  
Alexey Chernoutsan ◽  
Anton Kolesnikov ◽  
Boris Grigoriev
Keyword(s):  
Thermal Conductivity ◽  
Crude Oil ◽  
Temperature Coefficient ◽  
Atmospheric Pressure ◽  
Pressure Range ◽  
Gas Condensate ◽  
Transient Hot Wire ◽  
Hot Wire ◽  
Coefficient Of Thermal Conductivity ◽  
Transient Hot Wire Technique

The thermal conductivity of five samples of crude oil and one sample of gas condensate was measured by the transient hot-wire technique. The measurements were made along isotherms (245, 250, 273, 295, 320, 336, and 373 K) in the pressure range from atmospheric pressure up to 1000 MPa and along isobars (at 0.1, 100, 200, 300, 400, 500, and 1000 MPa) in the temperature range 245–450 K. It was observed that the thermal conductivity of the samples investigated strongly depends on the pressure and rises with increasing pressure for all the temperatures. At a certain pressure, the temperature coefficient of thermal conductivity reverses from negative to positive. The pressure at which this reversal was observed varied in the range of 300–380 MPa.

scholarly journals Study of Thermometry in Two-Dimensional Sb2Te3 from Temperature-Dependent Raman Spectroscopy

2021 ◽  
Vol 16 (1) ◽  
Author(s):  
Manavendra P. Singh ◽  
Manab Mandal ◽  
K. Sethupathi ◽  
M. S. Ramachandra Rao ◽  
Pramoda K. Nayak
Keyword(s):  
Thermal Conductivity ◽  
Raman Spectroscopy ◽  
Temperature Coefficient ◽  
Heat Dissipation ◽  
Peak Position ◽  
Two Dimensional ◽  
Phonon Modes ◽  
Temperature Dependent ◽  
Excellent Candidate ◽  
High Figure

AbstractDiscovery of two-dimensional (2D) topological insulators (TIs) demonstrates tremendous potential in the field of thermoelectric since the last decade. Here, we have synthesized 2D TI, Sb2Te3 of various thicknesses in the range 65–400 nm using mechanical exfoliation and studied temperature coefficient in the range 100–300 K using micro-Raman spectroscopy. The temperature dependence of the peak position and line width of phonon modes have been analyzed to determine the temperature coefficient, which is found to be in the order of 10–2 cm−1/K, and it decreases with a decrease in Sb2Te3 thickness. Such low-temperature coefficient would favor to achieve a high figure of merit (ZT) and pave the way to use this material as an excellent candidate for thermoelectric materials. We have estimated the thermal conductivity of Sb2Te3 flake with the thickness of 115 nm supported on 300-nm SiO2/Si substrate which is found to be ~ 10 W/m–K. The slightly higher thermal conductivity value suggests that the supporting substrate significantly affects the heat dissipation of the Sb2Te3 flake.

Determination of the Thermal Properties of a PCB by Coupled Numerical and Experimental Approach

2020 ◽  
Author(s):  
Yener Usul ◽  
Mustafa Özçatalbaş
Keyword(s):  
Thermal Conductivity ◽  
Heat Capacity ◽  
Thermal Properties ◽  
Numerical Analysis ◽  
Specific Heat ◽  
Specific Heat Capacity ◽  
Thermal Analyses ◽  
Analysis Model ◽  
Linear Temperature ◽  
Coefficient Of Thermal Conductivity

Abstract Increasing demand for usage of electronics intensely in narrow enclosures necessitates accurate thermal analyses to be performed. Conduction based FEM (Finite Element Method) is a common and practical way to examine the thermal behavior of an electronic system. First step to perform a numerical analysis for any system is to set up the correct analysis model. In this paper, a method for obtaining the coefficient of thermal conductivity and specific heat capacity of a PCB which has generally a complex composite layup structure composed of conductive layers, and dielectric layers. In the study, above mentioned properties are obtained performing a simple nondestructive experiment and a numerical analysis. In the method, a small portion of PCB is sandwiched from one side at certain pressure by jaws. A couple of linear temperature profiles are applied to the jaws successively. Unknown values are tuned in the analysis model until the results of FEM analysis and experiment match. The values for the coefficient of thermal conductivity and specific heat capacity which the experiment and numerical analysis results match can be said to be the actual values. From this point on, the PCB whose thermal properties are determined can be analyzed numerically for any desired geometry and boundary condition.

scholarly journals PECULIARITIES OF KINETICS OF THE COEFFICIENT OF THERMAL CONDUCTIVITY DEPENDING ON THE HUMIDITY RATE OF WALL BLOCKS MADE OF AGRICULTURAL WASTES

2019 ◽  
Vol 4 (10) ◽  
pp. 19-28 ◽  
Author(s):  
А. Должонок ◽  
A. Dolzhonok ◽  
А. Бакатович ◽  
A. Bakatovich
Keyword(s):  
Thermal Conductivity ◽  
Building Materials ◽  
Moisture Absorption ◽  
Coarse Aggregate ◽  
Sustainable Use ◽  
Agricultural Wastes ◽  
Hygroscopic Moisture ◽  
Relative Air Humidity ◽  
Coefficient Of Thermal Conductivity ◽  
Kinetics Of

The article considers the prospect of plant wastes usage as aggregates while constructing new building materials in the form of wall blocks. The results of the research on water absorption of the wall blocks at the relative air humidity of 97 % are presented. The kinetics of change in humidity and the coefficient of thermal conductivity of the blocks with the rye and buckwheat straw coarse aggregate, and also the blocks with fine coarse aggregate of flax boon and atomized buckwheat are analyzed. Empirical dependences of the coefficient of thermal conductivity on the rate of humidity of wall blocks are obtained from experimental observations. After the maximum rate of hygroscopic moisture absorption, the best indexes are recorded on the blocks made of flax and straw. The humidity rate of the composite does not exceed 10,9 % with the increase of thermal conductivity up to 0.104 W/(m•°С). In the result of the research, the solution to the sustainable use of agricultural wastes to get environmental responsible building materials is proposed. Blocks can be are used in the erection of supporting and filler walls in one-story buildings and multistoried frame housing construction when filling exterior wall openings.

scholarly journals Thermal conductivity of silicon doped by phosphorus: ab initio study

2018 ◽  
Vol 35 (4) ◽  
pp. 717-724
Author(s):  
B. Andriyevsky ◽  
W. Janke ◽  
V.Yo. Stadnyk ◽  
M.O. Romanyuk
Keyword(s):  
Thermal Conductivity ◽  
Heat Conductivity ◽  
Phonon Scattering ◽  
Theoretical Calculations ◽  
Doped Semiconductors ◽  
Silicon Crystals ◽  
Coefficient Of Thermal Conductivity ◽  
Silicon Doped ◽  
Scattering Time ◽  
Phosphorus Doped

Abstract An original approach to the theoretical calculations of the heat conductivity of crystals based on the first principles molecular dynamics has been proposed. The proposed approach exploits the kinetic theory of phonon heat conductivity and permits calculating several material properties at certain temperature: specific heat, elastic constant, acoustic velocity, mean phonon scattering time and coefficient of thermal conductivity. The method has been applied to silicon and phosphorus doped silicon crystals and the obtained results have been found to be in satisfactory agreement with corresponding experimental data. The proposed computation technique may be applied to the calculations of heat conductivity of pure and doped semiconductors and isolators.

scholarly journals XVI Международная конференция "Термоэлектрики и их применения --- 2018" (ISCTA 2018), Санкт-Петербург, 8-12 октября 2018 г. Влияние неидеальности геометрической формы образца на неопределенность измерений теплопроводности методом лазерной вспышки

2019 ◽  
Vol 53 (6) ◽  
pp. 731
Author(s):  
А.В. Асач ◽  
Г.Н. Исаченко ◽  
А.В. Новотельнова ◽  
В.Е. Фомин ◽  
К.Л. Самусевич ◽  
...  
Keyword(s):  
Thermal Conductivity ◽  
Measurement Uncertainty ◽  
Conductivity Measurement ◽  
Laser Flash ◽  
Comsol Multiphysics ◽  
Flash Method ◽  
Cylindrical Shape ◽  
Plane Parallel ◽  
Coefficient Of Thermal Conductivity ◽  
Truncated Cylinder

The influence of the geometric shape of the samples on the uncertainty of the coefficient of thermal conductivity measurement of materials by the method of a laser flash has been studied. Using a method of mathematical modeling in the Comsol Multiphysics software, a model that simulates the process of measuring the coefficient of thermal conductivity of samples made of graphite, Mg2Si0.4Sn0.6 and bismuth telluride using a laser flash method has been created. Samples of cylindrical shape with plane-parallel sides and samples in the form of a truncated cylinder, as well as samples in the form of a parallelepiped with a square base, were investigated. It is shown that the measurement uncertainty of samples with plane-parallel sides and sizes up to 12.7 mm, does not exceed 2%. For samples in the form of a truncated cylinder with a diameter of 3 mm and at an angle of ϕ= 1.5°, the measurement uncertainty does not exceed 3%. With an increase in the sample diameter and the ϕ angle, the measurement uncertainty increases significantly.

scholarly journals On investigation of the inverse problem for a parabolic integro-differential equation with a variable coefficient of thermal conductivity

2020 ◽  
Vol 30 (4) ◽  
pp. 572-584
Author(s):  
D.K. Durdiev ◽  
J.Z. Nuriddinov
Keyword(s):  
Thermal Conductivity ◽  
Inverse Problem ◽  
Variable Coefficient ◽  
Direct Problem ◽  
Local Existence ◽  
Problem Solution ◽  
Volterra Type ◽  
Integral Term ◽  
Local Existence And Uniqueness ◽  
Coefficient Of Thermal Conductivity

The inverse problem of determining a multidimensional kernel of an integral term depending on a time variable $t$ and $ (n-1)$-dimensional spatial variable $x'=\left(x_1,\ldots, x_ {n-1}\right)$ in the $n$-dimensional heat equation with a variable coefficient of thermal conductivity is investigated. The direct problem is the Cauchy problem for this equation. The integral term has the time convolution form of kernel and direct problem solution. As additional information for solving the inverse problem, the solution of the direct problem on the hyperplane $x_n = 0$ is given. At the beginning, the properties of the solution to the direct problem are studied. For this, the problem is reduced to solving an integral equation of the second kind of Volterra-type and the method of successive approximations is applied to it. Further the stated inverse problem is reduced to two auxiliary problems, in the second one of them an unknown kernel is included in an additional condition outside integral. Then the auxiliary problems are replaced by an equivalent closed system of Volterra-type integral equations with respect to unknown functions. Applying the method of contraction mappings to this system in the Hölder class of functions, we prove the main result of the article, which is a local existence and uniqueness theorem of the inverse problem solution.

scholarly journals Теплопроводность цепочки ротаторов с двухбарьерным потенциалом взаимодействия

2021 ◽  
Vol 63 (7) ◽  
pp. 975
Author(s):  
А.П. Клинов ◽  
М.А. Мазо ◽  
В.В. Смирнов
Keyword(s):  
Thermal Conductivity ◽  
Heat Conductivity ◽  
Normal Modes ◽  
Double Barrier ◽  
One Dimensional ◽  
Internal Barrier ◽  
Local Fluctuations ◽  
Small Height ◽  
Coefficient Of Thermal Conductivity ◽  
Height Dependence

The thermal conductivity of a one-dimensional chain of rotators with a double-barrier interaction potential of nearest neighbors has been studied numerically. We show that the height of the "internal" barrier, which separates topologically nonequivalent degenerate states, significantly affects the temperature dependence of the heat conductivity of the system. The small height of this barrier leads to the dominant contribution of the non-linear normal modes at low temperatures. In such a case the coefficient of thermal conductivity turns out to be the risen function of the temperature. The growth of the coefficient is limited by local fluctuations corresponding to jumps over the barriers. At higher values of the internal barrier height, dependence of the heat conductivity on temperature is similar to that of classical rotators.

Sign in / Sign up

Export Citation Format

Share Document