scholarly journals Comparison of performance of biodiesels of mahua oil and gingili oil in dual fuel engine

2008 ◽  
Vol 12 (1) ◽  
pp. 151-156 ◽  
Author(s):  
Kapilan Nadar ◽  
Pratap Reddy ◽  
Rao Anjuri
Keyword(s):  
Carbon Monoxide ◽  
Methyl Ester ◽  
Dual Fuel ◽  
Injection Timing ◽  
Nox Emissions ◽  
Test Results ◽  
Liquefied Petroleum Gas ◽  
Mahua Oil ◽  
Hydro Carbon ◽  
Pilot Fuel

In this work, an experimental work was carried out to compare the performance of biodiesels made from non edible mahua oil and edible gingili oil in dual fuel engine. A single cylinder diesel engine was modified to work in dual fuel mode and liquefied petroleum gas was used as primary fuel. Biodiesel was prepared by transesterification process and mahua oil methyl ester (MOME) and gingili oil methyl ester (GOME) were used as pilot fuels. The viscosity of MOME is slightly higher than GOME. The dual fuel engine runs smoothly with MOME and GOME. The test results show that the performance of the MOME is close to GOME, at the pilot fuel quantity of 0.45 kg/h and at the advanced injection timing of 30 deg bTDC. Also it is observed that the smoke, carbon monoxide and unburnt hydro carbon emissions of GOME lower than the MOME. But the GOME results in slightly higher NOx emissions. From the experimental results it is concluded that the biodiesel made from mahua oil can be used as a substitute for diesel in dual fuel engine.

scholarly journals Combustion and emission characteristics of a dual fuel engine operated with mahua oil and liquefied petroleum gas

2008 ◽  
Vol 12 (1) ◽  
pp. 115-123 ◽  
Author(s):  
Kapilan Nadar ◽  
Rana Reddy
Keyword(s):  
Methyl Ester ◽  
Injection Pressure ◽  
Dual Fuel ◽  
Test Results ◽  
Liquefied Petroleum Gas ◽  
Opening Pressure ◽  
Brake Thermal Efficiency ◽  
Performance And Emission ◽  
Mahua Oil ◽  
Pilot Fuel

For the present work, a single cylinder diesel engine was modified to work in dual fuel mode. To study the feasibility of using methyl ester of mahua oil as pilot fuel, it was used as pilot fuel and liquefied petroleum gas was used as primary fuel. In dual fuel mode, pilot fuel quantity and injector opening pressure are the few variables, which affect the performance and emission of dual fuel engine. Hence, in the present work, pilot fuel quantity and injector opening pressure were varied. From the test results, it was observed that the pilot fuel quantity of 5 mg per cycle and injector opening pressure of 200 bar results in higher brake thermal efficiency. Also the exhaust emissions such as smoke, unburnt hydrocarbon and carbon monoxide are lower than other pressures and pilot fuel quantities. The higher injection pressure and proper pilot fuel quantity might have resulted in better atomization, penetration of methyl ester of mahua oil and better combustion of fuel.

scholarly journals EFFECT OF INJECTOR OPENING PRESSURE ON PERFORMANCE AND EMISSION OF LPG - METHYL ESTER OF MAHUA OIL DUAL FUEL ENGINE

2017 ◽  
Vol 25 (2) ◽  
pp. 373-381
Author(s):  
N. Kapilan
Keyword(s):  
Methyl Ester ◽  
Injection Pressure ◽  
Dual Fuel ◽  
Test Results ◽  
Opening Pressure ◽  
Brake Thermal Efficiency ◽  
Performance And Emission ◽  
Mahua Oil ◽  
Pilot Fuel ◽  
Work Effect

One of variables, which affect the performance and emission of dual fuel engine is injection pressure. Hence in the present work, effect of Injector opening pressure on the performance of the engine was studied.  A four stroke single cylinder engine was modified to work in dual fuel mode. Three injector opening pressures (180 bar, 200 bar and 220 bar) were considered for the present work. Methyl ester of mahua oil was used as pilot fuel and LPG was used as primary fuel.    From the test results, it was observed that the injector opening pressure of 200 bar results in higher brake thermal efficiency. The higher injector opening pressure results in better atomization and peneatration of methyl ester of mahua oil. The exhaust emissions such as Smoke, unburnt hydro carbon and carbon monoxide of 200 bar is lower than other pressures.       

Performance of Dual Fuel Engine Running on Jojoba Oil as Pilot Fuel and CNG or LPG

2007 ◽  
Author(s):  
Mohamed Y. E. Selim ◽  
M. S. Radwan ◽  
H. E. Saleh
Keyword(s):  
Methyl Ester ◽  
Natural Gas ◽  
Pressure Rise ◽  
Combustion Noise ◽  
Dual Fuel ◽  
Maximum Pressure ◽  
Injection Timing ◽  
Pressure Rise Rate ◽  
Rise Rate ◽  
Pilot Fuel

The use of Jojoba Methyl Ester as a pilot fuel was investigated for almost the first time as a way to improve the performance of dual fuel engine running on natural gas or LPG at part load. The dual fuel engine used was Ricardo E6 variable compression diesel engine and it used either compressed natural gas (CNG) or liquefied petroleum gas (LPG) as the main fuel and Jojoba Methyl Ester as a pilot fuel. Diesel fuel was used as a reference fuel for the dual fuel engine results. During the experimental tests, the following have been measured: engine efficiency in terms of specific fuel consumption, brake power output, combustion noise in terms of maximum pressure rise rate and maximum pressure, exhaust emissions in terms of carbon monoxide and hydrocarbons, knocking limits in terms of maximum torque at onset of knocking, and cyclic data of 100 engine cycle in terms of maximum pressure and its pressure rise rate. The tests examined the following engine parameters: gaseous fuel type, engine speed and load, pilot fuel injection timing, pilot fuel mass and compression ratio. Results showed that using the Jojoba fuel with its improved properties has improved the dual fuel engine performance, reduced the combustion noise, extended knocking limits and reduced the cyclic variability of the combustion.

scholarly journals Assessment of late pilot injection effect in dual-fuel combustion

2020 ◽  
Vol 197 ◽  
pp. 06010
Author(s):  
Antonio Caricato ◽  
Antonio Paolo Carlucci ◽  
Antonio Ficarella ◽  
Luciano Strafella
Keyword(s):  
Injection Pressure ◽  
Dual Fuel ◽  
Injection Timing ◽  
Pilot Injection ◽  
Compression Ignition Engine ◽  
Engine Load ◽  
Pilot Fuel ◽  
Dual Fuel Combustion ◽  
Cylinder Compression ◽  
Injection Effect

In this paper, the effect of late injection on combustion and emission levels has been investigated on a single cylinder compression ignition engine operated in dual-fuel mode injecting methane along the intake duct and igniting it through a pilot fuel injected directly into the combustion chamber. During the tests, the amount of pilot fuel injected per cycle has been kept constant, while the amount of methane has been varied on three levels. Therefore, three levels of engine load have been tested, while speed has been kept constant equal to 1500rpm. Pilot injection pressure has been varied on three set points, namely 500, 1000 and 1500 bar. For each engine load and injection pressure, pilot injection timing has been swept on a very broad range of values, spanning from very advanced to very late values. The analysis of heat release rate indicates that MK-like conditions are established in dual-fuel mode with late pilot injection. In these conditions, pollutant species, and NOx levels in particular, are significantly reduced without penalization – and in several conditions with improvement – on fuel conversion efficiency.

scholarly journals Hydrogen Injection in a Dual Fuel Engine Fueled with Low-Pressure Injection of Methyl Ester of Thevetia Peruviana (METP) for Diesel Engine Maintenance Application

Energies ◽  
2020 ◽  
Vol 13 (21) ◽  
pp. 5663 ◽  
Author(s):  
Mahantesh Marikatti ◽  
N. R. Banapurmath ◽  
V. S. Yaliwal ◽  
Y.H. Basavarajappa ◽  
Manzoore Elahi M Soudagar ◽  
...  
Keyword(s):  
Diesel Engine ◽  
Methyl Ester ◽  
Gas Flow ◽  
Engine Performance ◽  
Gaseous Fuel ◽  
Dual Fuel ◽  
Injection Timing ◽  
Thevetia Peruviana ◽  
Oil Source ◽  
Engine Maintenance

The present work is mapped to scrutinize the consequence of biodiesel and gaseous fuel properties, and their impact on compression-ignition (CI) engine combustion and emission characteristics in single and dual fuel operation. Biodiesel prepared from non-edible oil source derived from Thevetia peruviana belonging to the plant family of Apocynaceaeis. The fuel has been referred as methyl ester of Thevetia peruviana (METP) and adopted as pilot fuel for the effective combustion of compressed gaseous fuel of hydrogen. This investigation is an effort to augment the engine performance of a biodiesel-gaseous fueled diesel engine operated under varied engine parameters. Subsequently, consequences of gas flow rate, injection timing, gas entry type, and manifold gas injection on the modified dual-fuel engine using conventional mechanical fuel injections (CMFIS) for optimum engine performance were investigated. Fuel consumption, CO, UHC, and smoke formations are spotted to be less besides higher NOx emissions compared to CMFIS operation. The fuel burning features such as ignition delay, burning interval, and variation of pressure and heat release rates with crank angle are scrutinized and compared with base fuel. Sustained research in this direction can convey practical engine technology, concerning fuel combinations in the dual fuel mode, paving the way to alternatives which counter the continued fossil fuel utilization that has detrimental impacts on the climate.

Optimization of High Pressure Direct Injection Micro-Pilot As a Retrofit Technology for Conventional Dual Fuel Engines

2019 ◽  
Author(s):  
Greg Beshouri ◽  
Gerry Fischer
Keyword(s):  
High Pressure ◽  
Performance Optimization ◽  
Experimental Testing ◽  
Direct Injection ◽  
Dual Fuel ◽  
Injection Timing ◽  
Test Results ◽  
Fuel Gas ◽  
Single Cylinder ◽  
Dual Fuel Engines

Abstract In the late 1980’s Enterprise Engine Company performed a single cylinder test of micro-pilot high pressure direct injection as a retrofit technology for conventional dual fuel engines. While that testing demonstrated a number of benefits for this technology, non-technical considerations led to the use of low pressure Pre-Combustion Chamber (PCC) micro-pilot technology as the retrofit technology instead. Thirty years later, when the automotive components of the PCC micro-pilot system were no longer available, the opportunity again arose to test the capabilities of an off the shelf high pressure direct injection micro-pilot system as a retrofit technology for a conventional dual fuel engine. Single cylinder and full engine testing of the high pressure direct injection micro-pilot injection confirmed the results of the 1980’s testing. The test results also corroborated modern analytical and experimental testing of high pressure pilot technology. In particular, the interaction between the diesel pilot and primary fuel gas charge is very complex and sometimes counterintuitive. Likewise performance optimization requires careful balance of injection timing, injection quantity and fuel gas air/fuel ratio. Even then, exhaust gas methane emissions remain counterintuitive. This paper reviews modern single cylinder and full engine test results focusing on optimization parameters for high pressure direct injection micro-pilot for retrofit and new engine applications.

scholarly journals Evaluation Dual Fuel Engine Fuelled With Hydrogen and Biogas as Secondary Fuel

2019 ◽  
Vol 8 (2) ◽  
pp. 1902-1905
Keyword(s):  
Diesel Engine ◽  
Thermal Efficiency ◽  
Dominant Role ◽  
Single Mode ◽  
Dual Fuel ◽  
Nox Emissions ◽  
Brake Thermal Efficiency ◽  
Pilot Fuel ◽  
Present Context ◽  
Inlet Manifold

The present energy scenario hydrogen fuel plays a dominant role in the power generation. Due to its unique characteristics of an extensive range of flammability, high flame speed, and diffusivity. In this present investigation, the diesel engine is converted into dual-fuel mode devoid of major conversions of the engine. The tests are performed on a dual-fuel mode and investigated the efficiency, emissions, and combustion features of the diesel engine. In the present context, hydrogen and biogas are injected from the inlet manifold as subsidiary fuel and diesel are injected as pilot fuel. The gaseous fuel injected in two different flow rates they are, 3 litres per minute (lpm), and 4lpm. The results from the experimentation revealed that the diesel with 4 lpm of hydrogen shows the 31.11 % enhancement of brake thermal efficiency but it shows 4.14% higher NOX emissions when compared with the pure diesel. But it shows. At the same time diesel with 4 lpm of Biogas exhibits 15.90% enhancement of brake thermal efficiency and 8.96% decrease in the NOX emissions in contrast to that of the single-mode of fuel with diesel.

Sign in / Sign up

Export Citation Format

Share Document