scholarly journals Efficiency of the 3-phase system to provide energy under low frequency induction heating of CWRs

2009 ◽  
Vol 22 (2) ◽  
pp. 175-182
Author(s):  
Bogdan Miedzinski ◽  
Marcin Habrych ◽  
Zenon Okraszewski ◽  
Xin Wang ◽  
Lj Xu
Keyword(s):  
Induction Heating ◽  
Low Frequency ◽  
Phase Shifts ◽  
Phase System ◽  
Proper Selection ◽  
Voltage Phase ◽  
Selection Of

In this paper the efficiency of heating of continuous welded rails (CWRs) under track laying when 3-phase low frequency supplying system is applied has been carefully considered. On the basis of computations confirmed by the investigated results, for different heaters location as well as different voltage phase shifts, the conclusions concerning proper selection of the structure of the energy supplying systems are formulated. .

Inlet Fogging for a 655 MW Combined Cycle Power Plant: Design, Implementation and Operating Experience

2003 ◽  
Author(s):  
Hemant Gajjar ◽  
Mustapha Chaker ◽  
Ajay Dighe ◽  
Cyrus B. Meher-Homji
Keyword(s):  
High Temperature ◽  
Power Plant ◽  
Low Frequency ◽  
Operating Experience ◽  
Combined Cycle ◽  
Plant Design ◽  
Proper Selection ◽  
Combined Cycle Power Plant ◽  
Technical Details ◽  
Selection Of

The design, installation, commissioning and operation of a fogging system for a large 655 MW combined cycle power plant is described. Technical details and practical installation issues are discussed. Special considerations as to how the fogging system could help in the augmentation of power during high temperature and low frequency operation of the gas turbine is discussed. Finally a discussion is made regarding the importance of inlet filtration and the proper selection of blade coatings.

Meriel Talbot and the Society for the Overseas Settlement of British Women, 1919–1937

2017 ◽  
Vol 10 (1) ◽  
pp. 32-52
Author(s):  
Bonnie White
Keyword(s):  
Domestic Service ◽  
Agricultural Workers ◽  
British Government ◽  
Early Failure ◽  
Proper Selection ◽  
Domestic Servants ◽  
Female Workers ◽  
Female Migrants ◽  
Post War ◽  
Selection Of

In 1917 the British government began making plans for post-war adjustments to the economy, which included the migration of surplus women to the dominions. The Society for the Overseas Settlement of British Women was established in 1920 to facilitate the migration of female workers to the dominions. Earlier studies have argued that overseas emigration efforts purposefully directed women into domestic service as surplus commodities, thus alleviating the female ‘surplus’ and easing economic hardships of the post-war period. This article argues that as Publicity Officer for the SOSBW, Meriel Talbot targeted women she believed would be ideal candidates for emigration, including former members of the Women's Land Army and affiliated groups. With the proper selection of female migrants, Talbot sought to expand work opportunities for women in the dominions beyond domestic service, while reducing the female surplus at home and servicing the connection between state and empire. Dominion authorities, whose demands for migrant labour vacillated between agricultural workers during the war years and domestic servants after 1920, disapproved of Talbot's efforts to migrate women for work in agriculture. Divergent policies led to the early failure of the SOSBW in 1923.

Development of a Stress-Relied Annealing Device by using a Low Frequency Induction Heating Technique

2014 ◽  
Vol 134 (4) ◽  
pp. 217-222 ◽  
Author(s):  
Shogo Yoshida ◽  
Yuichiro Kai ◽  
Takashi Todaka ◽  
Masato Enokizono ◽  
Takeo Imagawa ◽  
...  
Keyword(s):  
Induction Heating ◽  
Low Frequency

scholarly journals Design Concepts for NiTiNOL Wires to Function as a Sensor

2021 ◽  
Author(s):  
D. Josephine Selvarani Ruth
Keyword(s):  
Shape Memory Alloy ◽  
Electrical Resistance ◽  
Nickel Titanium ◽  
The Other ◽  
Sensing Element ◽  
Proper Selection ◽  
Design Concepts ◽  
Mechanical Element ◽  
Selection Of ◽  
Inverse Hysteresis

AbstractNickel Titanium Naval Ordinance Laboratory (NiTiNOL) is widely called as a shape memory alloy (SMA), a class of nonlinear smart material inherited with the functionally programmed property of varying electrical resistance during the transformation enabling to be positioned as a sensing element. The major challenge to instrument the SMA wires is to suppress the wires’ nonlinearity by proper selection of two important factors. The first factor is influenced by the mechanical biasing element and the other is to identify the sensing current for the sensing device (SMA wires + biasing). This paper focuses on developing SMA wires for sensing in different orientation types and configurations by removing the non-linearity in the system’s output by introducing inverse hysteresis to the wires through the passive mechanical element.

A Non-Normality Measure of the Condition Number for Monitoring and Control

1997 ◽  
Vol 119 (2) ◽  
pp. 217-222 ◽  
Author(s):  
Kunsoo Huh ◽  
Jeffrey L. Stein
Keyword(s):  
Optimal Control ◽  
Condition Number ◽  
Minimization Problem ◽  
Monitoring And Control ◽  
Proper Selection ◽  
Modal Structure ◽  
L2 Norm ◽  
And Control ◽  
Normality Measure ◽  
Selection Of

Because the behavior of the condition number can have highly steep and multi-modal structure, optimal control and monitoring problems based on the condition number cannot be easily solved. In this paper, a minimization problem is formulated for κ2(P), the condition number of an eigensystem (P) of a matrix in terms of the L2 norm. A new non-normality measure is shown to exist that guarantees small values for the condition number. In addition, this measure can be minimized by proper selection of controller and observer gains. Application to the design of well-conditioned controller and observer-based monitors is illustrated.

scholarly journals Influence of the Chemical Composition on Electrical Conductivity and Mechanical Properties of the Hypoeutectic Al-Si-Mg Alloys

2016 ◽  
Vol 61 (1) ◽  
pp. 353-360 ◽  
Author(s):  
B. Dybowski ◽  
J. Szymszal ◽  
Ł. Poloczek ◽  
A. Kiełbus
Keyword(s):  
Mechanical Properties ◽  
Electrical Conductivity ◽  
Chemical Composition ◽  
Aluminium Alloys ◽  
Mg Alloys ◽  
High Electrical Conductivity ◽  
Transportation Industry ◽  
Proper Selection ◽  
Ti Addition ◽  
Selection Of

Due to low density and good mechanical properties, aluminium alloys are widely applied in transportation industry. Moreover, they are characterized by the specific physical properties, such as high electrical conductivity. This led to application of the hypoeutectic Al-Si-Mg alloys in the power generation industry. Proper selection of the alloys chemical composition is an important stage in achievement of the demanded properties. The following paper presents results of the research on the influence of alloys chemical composition on their properties. It has been revealed that Si and Ti addition decreases electrical conductivity of the Al-Si-Mg alloys, while Na addition increases it. The mechanical properties of the investigated alloys are decreased by both silicon and iron presence. Sodium addition increases ductility of the Al-Si-Mg alloys.

scholarly journals Hydrogen Gas Sensors Fabricated on Atomically Flat 4H-SiC Webbed Cantilevers

2008 ◽  
Vol 600-603 ◽  
pp. 1199-1202 ◽  
Author(s):  
Philip G. Neudeck ◽  
David J. Spry ◽  
Andrew J. Trunek ◽  
Laura J. Evans ◽  
Liang Yu Chen ◽  
...  
Keyword(s):  
Gas Sensors ◽  
Rapid Detection ◽  
Hydrogen Gas ◽  
Current Gain ◽  
Proper Selection ◽  
Hydrogen Gas Sensors ◽  
Sensor Current ◽  
Atomically Flat ◽  
Initial Results ◽  
Selection Of

This paper reports on initial results from the first device tested of a “second generation” Pt-SiC Schottky diode hydrogen gas sensor that: 1) resides on the top of atomically flat 4H-SiC webbed cantilevers, 2) has integrated heater resistor, and 3) is bonded and packaged. With proper selection of heater resistor and sensor diode biases, rapid detection of H2 down to concentrations of 20 ppm was achieved. A stable sensor current gain of 125 ± 11 standard deviation was demonstrated during 250 hours of cyclic test exposures to 0.5% H2 and N2/air.

Available Energy: I. Gibbs Revisited; II. Gibbs Extended

1999 ◽  
Author(s):  
Richard A. Gaggioli ◽  
David H. Richardson ◽  
Anthony J. Bowman ◽  
David M. Paulus
Keyword(s):  
The Body ◽  
Nonequilibrium Condition ◽  
Balance Equations ◽  
Proper Selection ◽  
Additive Property ◽  
Property Relations ◽  
Available Energy ◽  
Dead State ◽  
Energy Equilibrium ◽  
Selection Of

Abstract The concept of available energy, as defined by Gibbs (1873b) is revisited. He gave representations of available energy for two circumstances. The first was the available energy of a “body,” for the case when a body, alone, is in a nonequilibrium condition and therefore has energy available. In turn, he presented the available energy of “the body and medium,” for the energy which is available because a body is not in equilibrium with some arbitrarily specified medium. Gibbs’ representations were graphical. Since Gibbs, representations with formulas have been developed and are common, for the “available energy of body and medium.” Gaggioli (1998a, b) has developed formulas which are more general, to represent “the available energy of the body (alone)” and to assign an exergy to subsystems of the body as a measure of each sub-system’s contribution to the available energy. In contrast to the available energy, exergy is an additive property, so that balance equations can be written. And the formulas are independent from any “medium,” which is important both theoretically and practically — because of its relevance to proper selection of “the dead state.” These issues are discussed and extended, after reviewing Gibbs development of available energy and additional concepts which he introduced, such as “available vacuum” and “capacity for entropy.” It is argued that these “availabililty” and “capacity” concepts are all equivalent to one another. In turn, because of interconvertability, it is seen that available energy is something more fundamental than “maximum useful work.” Furthermore, it is illustrated that available energy, equilibrium and stability, and thermostatic property relations are relative, to “constraints.”

Sign in / Sign up

Export Citation Format

Share Document