scholarly journals Adler function and hadronic vacuum polarization from lattice vector correlators in the time-momentum representation

2014 ◽  
Author(s):  
Anthony Francis ◽  
Benjamin Jaeger ◽  
Harvey Meyer ◽  
Hartmut Wittig
Keyword(s):  
Vacuum Polarization ◽  
Momentum Representation ◽  
Lattice Vector ◽  
Adler Function

scholarly journals Computing the Adler function from vacuum polarization

2014 ◽  
Author(s):  
Hanno Horch ◽  
Gregorio Herdoiza ◽  
Benjamin Jaeger ◽  
Hartmut Wittig ◽  
Michele Della Morte ◽  
...  
Keyword(s):  
Vacuum Polarization ◽  
Adler Function

Observation of faint contrast at planar faults in alloys

1978 ◽  
Vol 36 (1) ◽  
pp. 340-341
Author(s):  
K. Kuroda ◽  
Y. Tomokiyo ◽  
T. Kumano ◽  
T. Eguchi
Keyword(s):  
Reciprocal Lattice ◽  
Beam Theory ◽  
Al Alloys ◽  
Small Displacement ◽  
Electron Microscopic ◽  
Lattice Vector ◽  
Fringe Contrast ◽  
Planar Fault ◽  
Lattice Displacement ◽  
The Many

The contrast in electron microscopic images of planar faults in a crystal is characterized by a phase factor , where is the reciprocal lattice vector of the operating reflection, and the lattice displacement due to the fault under consideration. Within the two-beam theory a planar fault with an integer value of is invisible, but a detectable contrast is expected when the many-beam dynamical effect is not negligibly small. A weak fringe contrast is also expected when differs slightly from an integer owing to an additional small displacement of the lattice across the fault. These faint contrasts are termed as many-beam contrasts in the former case, and as ε fringe contrasts in the latter. In the present work stacking faults in Cu-Al alloys and antiphase boundaries (APB) in CuZn, FeCo and Fe-Al alloys were observed under such conditions as mentioned above, and the results were compared with the image profiles of the faults calculated in the systematic ten-beam approximation.

Kinematical and Dynamical CBED Pattern Models: Increasing the Accuracy of the Unit-Cell Parameter Measurements Based on CBED Patterns

1990 ◽  
Vol 48 (2) ◽  
pp. 540-541
Author(s):  
I.N. Yadhikov ◽  
S.K. Maksimov
Keyword(s):  
Reciprocal Lattice ◽  
Unit Cell ◽  
Reciprocal Lattice Vector ◽  
Unit Cell Parameters ◽  
Lattice Vector ◽  
Cell Parameters ◽  
Accuracy Of Measurements ◽  
The Difference ◽  
Image Position ◽  
Convergent Beam

Convergent beam electron diffraction (CBED) is widely used as a microanalysis tool. By the relative position of HOLZ-lines (Higher Order Laue Zone) in CBED-patterns one can determine the unit cell parameters with a high accuracy up to 0.1%. For this purpose, maps of HOLZ-lines are simulated with the help of a computer so that the best matching of maps with experimental CBED-pattern should be reached. In maps, HOLZ-lines are approximated, as a rule, by straight lines. The actual HOLZ-lines, however, are different from the straights. If we decrease accelerating voltage, the difference is increased and, thus, the accuracy of the unit cell parameters determination by the method becomes lower.To improve the accuracy of measurements it is necessary to give up the HOLZ-lines substitution by the straights. According to the kinematical theory a HOLZ-line is merely a fragment of ellipse arc described by the parametric equationwith arc corresponding to change of β parameter from -90° to +90°, wherevector, h - the distance between Laue zones, g - the value of the reciprocal lattice vector, g‖ - the value of the reciprocal lattice vector projection on zero Laue zone.

Effects of Higher-Order Laue Zone reflections on structure images

1993 ◽  
Vol 51 ◽  
pp. 450-451
Author(s):  
H. S. Kim ◽  
S. S. Sheinin
Keyword(s):  
Wave Vector ◽  
Theoretical Calculations ◽  
Reciprocal Lattice ◽  
Image Plane ◽  
Bloch Wave ◽  
Dynamical Theory ◽  
Higher Order ◽  
Lattice Image ◽  
Lattice Vector ◽  
Image Position

The importance of image simulation in interpreting experimental lattice images is well established. Normally, in carrying out the required theoretical calculations, only zero order Laue zone reflections are taken into account. In this paper we assess the conditions for which this procedure is valid and indicate circumstances in which higher order Laue zone reflections may be important. Our work is based on an analysis of the requirements for obtaining structure images i.e. images directly related to the projected potential. In the considerations to follow, the Bloch wave formulation of the dynamical theory has been used.The intensity in a lattice image can be obtained from the total wave function at the image plane is given by: where ϕg(z) is the diffracted beam amplitide given by In these equations,the z direction is perpendicular to the entrance surface, g is a reciprocal lattice vector, the Cg(i) are Fourier coefficients in the expression for a Bloch wave, b(i), X(i) is the Bloch wave excitation coefficient, ϒ(i)=k(i)-K, k(i) is a Bloch wave vector, K is the electron wave vector after correction for the mean inner potential of the crystal, T(q) and D(q) are the transfer function and damping function respectively, q is a scattering vector and the summation is over i=l,N where N is the number of beams taken into account.

scholarly journals Self-dual DeepBKZ for finding short lattice vectors

2020 ◽  
Vol 14 (1) ◽  
pp. 84-94 ◽  
Author(s):  
Masaya Yasuda
Keyword(s):  
Experimental Results ◽  
Lattice Vector

AbstractIn recent years, the block Korkine-Zolotarev (BKZ) and its variants such as BKZ 2.0 have been used as de facto algorithms to estimate the security of a lattice-based cryptosystem. In 2017, DeepBKZ was proposed as a mathematical improvement of BKZ, which calls LLL with deep insertions (DeepLLL) as a subroutine alternative to LLL. DeepBKZ can find a short lattice vector by smaller blocksizes than BKZ. In this paper, we develop a self-dual variant of DeepBKZ, as in the work of Micciancio and Walter for self-dual BKZ. Like DeepBKZ, our self-dual DeepBKZ calls both DeepLLL and its dual variant as main subroutines in order to accelerate to find a very short lattice vector. We also report experimental results of DeepBKZ and our self-dual DeepBKZ for random bases on the Darmstadt SVP challenge.

scholarly journals Vacuum polarization near boundaries

2021 ◽  
Vol 103 (1) ◽  
Author(s):  
Jonathan Wernersson ◽  
Jochen Zahn
Keyword(s):  
Vacuum Polarization

scholarly journals Two and three pseudoscalar production in e+e− annihilation and their contributions to (g − 2)μ

2021 ◽  
Vol 2021 (3) ◽  
Author(s):  
Wen Qin ◽  
Ling-Yun Dai ◽  
Jorge Portolés
Keyword(s):  
Experimental Data ◽  
Theoretical Prediction ◽  
Pseudoscalar Meson ◽  
Magnetic Moment ◽  
Anomalous Magnetic Moment ◽  
Vacuum Polarization ◽  
Meson Production ◽  
The Other ◽  
Joint Analysis ◽  
The Standard Model

Abstract A coherent study of e+e− annihilation into two (π+π−, K+K−) and three (π+π−π0, π+π−η) pseudoscalar meson production is carried out within the framework of resonance chiral theory in energy region E ≲ 2 GeV. The work of [L.Y. Dai, J. Portolés, and O. Shekhovtsova, Phys. Rev. D88 (2013) 056001] is revisited with the latest experimental data and a joint analysis of two pseudoscalar meson production. Hence, we evaluate the lowest order hadronic vacuum polarization contributions of those two and three pseudoscalar processes to the anomalous magnetic moment of the muon. We also estimate some higher-order additions led by the same hadronic vacuum polarization. Combined with the other contributions from the standard model, the theoretical prediction differs still by (21.6 ± 7.4) × 10−10 (2.9σ) from the experimental value.

scholarly journals Vacuum Polarization in a Zero-Width Potential: Self-Adjoint Extension

Universe ◽  
2021 ◽  
Vol 7 (5) ◽  
pp. 127
Author(s):  
Yuri V. Grats ◽  
Pavel Spirin
Keyword(s):  
Scalar Field ◽  
Vacuum Polarization ◽  
Dimensional Regularization ◽  
Vacuum Expectation ◽  
Vacuum Expectation Value ◽  
Field Approximation ◽  
Dimensional Euclidean Space ◽  
Massless Scalar ◽  
Massless Scalar Field ◽  
Adjoint Extension

The effects of vacuum polarization associated with a massless scalar field near pointlike source with a zero-range potential in three spatial dimensions are analyzed. The “physical” approach consists in the usage of direct delta-potential as a model of pointlike interaction. We use the Perturbation theory in the Fourier space with dimensional regularization of the momentum integrals. In the weak-field approximation, we compute the effects of interest. The “mathematical” approach implies the self-adjoint extension technique. In the Quantum-Field-Theory framework we consider the massless scalar field in a 3-dimensional Euclidean space with an extracted point. With appropriate boundary conditions it is considered an adequate mathematical model for the description of a pointlike source. We compute the renormalized vacuum expectation value ⟨ϕ2(x)⟩ren of the field square and the renormalized vacuum averaged of the scalar-field’s energy-momentum tensor ⟨Tμν(x)⟩ren. For the physical interpretation of the extension parameter we compare these results with those of perturbative computations. In addition, we present some general formulae for vacuum polarization effects at large distances in the presence of an abstract weak potential with finite-sized compact support.

Effect of massive quarks on the vacuum polarization of chiral currents

1981 ◽  
Vol 24 (10) ◽  
pp. 2724-2729 ◽  
Author(s):  
Werner Wetzel ◽  
Werner Bernreuther
Keyword(s):  
Vacuum Polarization
Sign in / Sign up

Export Citation Format

Share Document