scholarly journals EFFECT OF DROP-PHASE OXIDATION ON ACIDIFICATION OF GROWING CLOUD DROPLET DUE TO ABSORPTION OF SO2 (g)

2000 ◽  
Vol 8 ◽  
pp. 271-276
Author(s):  
Sadataka SHIBA ◽  
Yushi HIRATA ◽  
Shunsaku YAGI
Keyword(s):  
Cloud Droplet ◽  
Phase Oxidation ◽  
Drop Phase

scholarly journals Effect of Drop-Phase Oxidation on Acid Rain Formation

1997 ◽  
Vol 41 ◽  
pp. 581-586
Author(s):  
Sadataka SHIBA ◽  
Yushi HIRATA ◽  
Shunsaku YAGI
Keyword(s):  
Acid Rain ◽  
Phase Oxidation ◽  
Rain Formation ◽  
Drop Phase

scholarly journals Modeling microphysical effects of entrainment in clouds observed during EUCAARI-IMPACT field campaign

2013 ◽  
Vol 13 (16) ◽  
pp. 8489-8503 ◽  
Author(s):  
D. Jarecka ◽  
H. Pawlowska ◽  
W. W. Grabowski ◽  
A. A. Wyszogrodzki
Keyword(s):  
Boundary Layer ◽  
Turbulent Mixing ◽  
Marine Boundary Layer ◽  
Cloud Droplet ◽  
Droplet Radius ◽  
Subgrid Scale ◽  
Microphysics Scheme ◽  
Local Conditions ◽  
Field Campaign ◽  
Les Model

Abstract. This paper discusses aircraft observations and large-eddy simulation (LES) modeling of 15 May 2008, North Sea boundary-layer clouds from the EUCAARI-IMPACT field campaign. These clouds are advected from the northeast by the prevailing lower-tropospheric winds and featured stratocumulus-over-cumulus cloud formations. An almost-solid stratocumulus deck in the upper part of the relatively deep, weakly decoupled marine boundary layer overlays a field of small cumuli. The two cloud formations have distinct microphysical characteristics that are in general agreement with numerous past observations of strongly diluted shallow cumuli on one hand and solid marine stratocumulus on the other. Based on the available observations, a LES model setup is developed and applied in simulations using a novel LES model. The model features a double-moment warm-rain bulk microphysics scheme combined with a sophisticated subgrid-scale scheme allowing local prediction of the homogeneity of the subgrid-scale turbulent mixing. The homogeneity depends on the characteristic time scales for the droplet evaporation and for the turbulent homogenization. In the model, these scales are derived locally based on the subgrid-scale turbulent kinetic energy, spatial scale of cloudy filaments, mean cloud droplet radius, and humidity of the cloud-free air entrained into a cloud, all predicted by the LES model. The model reproduces contrasting macrophysical and microphysical characteristics of the cumulus and stratocumulus cloud layers. Simulated subgrid-scale turbulent mixing within the cumulus layer and near the stratocumulus top is on average quite inhomogeneous, but varies significantly depending on the local conditions.

scholarly journals Simulation study on the indirect effect of sulfate on the summer climate over the eastern China monsoon region

2021 ◽  
Vol 11 (1) ◽  
Author(s):  
Dongdong Wang ◽  
Bin Zhu ◽  
Hongbo Wang ◽  
Li Sun
Keyword(s):  
Radiative Forcing ◽  
Asian Summer Monsoon ◽  
Cloud Condensation Nuclei ◽  
Eastern China ◽  
Summer Precipitation ◽  
Cloud Droplet ◽  
Monsoon Region ◽  
Liquid Water Path ◽  
Surface Cooling ◽  
Community Atmosphere Model

AbstractIn this study, we designed a sensitivity test using the half number concentration of sulfate in the nucleation calculation process to study the aerosol-cloud interaction (ACI) of sulfate on clouds, precipitation, and monsoon intensity in the summer over the eastern China monsoon region (ECMR) with the National Center for Atmospheric Research Community Atmosphere Model version 5. Numerical experiments show that the ACI of sulfate led to an approximately 30% and 34% increase in the cloud condensation nuclei and cloud droplet number concentrations, respectively. Cloud droplet effective radius below 850 hPa decreased by approximately 4% in the southern ECMR, while the total liquid water path increased by 11%. The change in the indirect radiative forcing due to sulfate at the top of the atmosphere in the ECMR during summer was − 3.74 W·m−2. The decreased radiative forcing caused a surface cooling of 0.32 K and atmospheric cooling of approximately 0.3 K, as well as a 0.17 hPa increase in sea level pressure. These changes decreased the thermal difference between the land and sea and the gradient of the sea-land pressure, leading to a weakening in the East Asian summer monsoon (EASM) and a decrease in the total precipitation rate in the southern ECMR. The cloud lifetime effect has a relatively weaker contribution to summer precipitation, which is dominated by convection. The results show that the ACI of sulfate was one possible reason for the weakening of the EASM in the late 1970s.

The variability of warm cloud droplet radius induced by aerosols and water vapor in Shanghai from MODIS observations

2021 ◽  
Vol 253 ◽  
pp. 105470
Author(s):  
Qiong Liu ◽  
Shengyang Duan ◽  
Qianshan He ◽  
Yonghang Chen ◽  
Hua Zhang ◽  
...  
Keyword(s):  
Water Vapor ◽  
Cloud Droplet ◽  
Droplet Radius ◽  
Warm Cloud

scholarly journals Recommendations for HCHO and SO2 Retrieval Settings from MAX-DOAS Observations under Different Meteorological Conditions

2021 ◽  
Vol 13 (12) ◽  
pp. 2244
Author(s):  
Zeeshan Javed ◽  
Aimon Tanvir ◽  
Muhammad Bilal ◽  
Wenjing Su ◽  
Congzi Xia ◽  
...  
Keyword(s):  
Column Density ◽  
Trace Gases ◽  
Meteorological Conditions ◽  
Optical Absorption Spectroscopy ◽  
Chemical Production ◽  
Vertical Column ◽  
Phase Oxidation ◽  
Fog Days ◽  
Rms Errors ◽  
Optimal Settings

Recently, the occurrence of fog and haze over China has increased. The retrieval of trace gases from the multi-axis differential optical absorption spectroscopy (MAX-DOAS) is challenging under these conditions. In this study, various reported retrieval settings for formaldehyde (HCHO) and sulfur dioxide (SO2) are compared to evaluate the performance of these settings under different meteorological conditions (clear day, haze, and fog). The dataset from 1st December 2019 to 31st March 2020 over Nanjing, China, is used in this study. The results indicated that for HCHO, the optimal settings were in the 324.5–359 nm wavelength window with a polynomial order of five. At these settings, the fitting and root mean squared (RMS) errors for column density were considerably improved for haze and fog conditions, and the differential slant column densities (DSCDs) showed more accurate values compared to the DSCDs between 336.5 and 359 nm. For SO2, the optimal settings for retrieval were found to be at 307–328 nm with a polynomial order of five. Here, root mean square (RMS) and fitting errors were significantly lower under all conditions. The observed HCHO and SO2 vertical column densities were significantly lower on fog days compared to clear days, reflecting a decreased chemical production of HCHO and aqueous phase oxidation of SO2 in fog droplets.

Sign in / Sign up

Export Citation Format

Share Document