The Morphology and Spatial Distribution of Late Quaternary Periglacial Landforms, Snake Range, Nevada: A Gis-Based Approach to Prioritizing Field Sites

2011 ◽  
Vol 43 (1) ◽  
pp. 48-60 ◽  
Author(s):  
John G. Van Hoesen ◽  
Richard L. Orndorff
Keyword(s):  
Spatial Distribution ◽  
Late Quaternary ◽  
Snake Range

The development process of the Korean coastal mountain range: Examination from spatial distribution of knickzones

2020 ◽  
pp. 030913332097565
Author(s):  
Jongmin Byun ◽  
Kyungrock Paik
Keyword(s):  
Spatial Distribution ◽  
Drainage Basin ◽  
Late Quaternary ◽  
Mountain Range ◽  
Quasi Equilibrium ◽  
Current Form ◽  
Progressive Development ◽  
Tectonic History ◽  
Digital Elevation ◽  
Coastal Mountain

Along the eastern margin of the Korean Peninsula, a coastal mountain range spanning over 800 km with summits above 1500 m faces the East Sea (or Sea of Japan), the back-arc sea behind the Japanese Islands. Two contrasting hypotheses exist regarding the tectonic history of this coastal mountain range: long-lasting and progressive uplifts from the Early Tertiary to the Late Quaternary, and a short and intensive uplift during the Early Miocene. However, to date, no consensus has been reached. Here, we studied the spatial distribution of knickzones to understand the formation period and development pattern of this coastal mountain range. We extracted the knickzones in a drainage basin from digital elevation models, and investigated whether or not they are transient knickzones induced by the development of the coastal mountain range. We found that all identified knickzones were stationary, which was verified by slope-area and chi-elevation analyses. This implies that sufficient time has passed for all transient knickzones relevant to the growth of the mountain range to migrate up to the catchment boundary and disappear. We then calculated the time spent for the migration of transient knickzones from the outlet to their stream heads to be at least 5.1 to 10.6 Myr. Therefore, our results suggest that the current form of the coastal mountain range had been built at least before 5.1 Myr ago and has reached a quasi-equilibrium state up to the present, thus invalidating the prevailing hypothesis of the long-lasting and progressive development until the Late Quaternary.

Lithography below 100 nm

1983 ◽  
Vol 41 ◽  
pp. 96-99
Author(s):  
L. D. Jackel
Keyword(s):  
Spatial Distribution ◽  
Electron Beam ◽  
Electron Scattering ◽  
Electron Beam Lithography ◽  
Substrate Material ◽  
Local Electron ◽  
Electron Dose ◽  
Positive Resist ◽  
Exposure Process

Most production electron beam lithography systems can pattern minimum features a few tenths of a micron across. Linewidth in these systems is usually limited by the quality of the exposing beam and by electron scattering in the resist and substrate. By using a smaller spot along with exposure techniques that minimize scattering and its effects, laboratory e-beam lithography systems can now make features hundredths of a micron wide on standard substrate material. This talk will outline sane of these high- resolution e-beam lithography techniques.We first consider parameters of the exposure process that limit resolution in organic resists. For concreteness suppose that we have a “positive” resist in which exposing electrons break bonds in the resist molecules thus increasing the exposed resist's solubility in a developer. Ihe attainable resolution is obviously limited by the overall width of the exposing beam, but the spatial distribution of the beam intensity, the beam “profile” , also contributes to the resolution. Depending on the local electron dose, more or less resist bonds are broken resulting in slower or faster dissolution in the developer.

SEM evaluation of the TEM cold-stage double-film specimen

1984 ◽  
Vol 42 ◽  
pp. 272-273
Author(s):  
Jayesh Bellare
Keyword(s):  
Spatial Distribution ◽  
Sample Preparation ◽  
Sample Thickness ◽  
Specimen Preparation ◽  
Preparation Technique ◽  
Liquid Sample ◽  
Thin Specimen ◽  
Sample Preparation Technique ◽  
Cold Stage ◽  
Film Specimen

Seeing is believing, but only after the sample preparation technique has received a systematic study and a full record is made of the treatment the sample gets.For microstructured liquids and suspensions, fast-freeze thermal fixation and cold-stage microscopy is perhaps the least artifact-laden technique. In the double-film specimen preparation technique, a layer of liquid sample is trapped between 100- and 400-mesh polymer (polyimide, PI) coated grids. Blotting against filter paper drains excess liquid and provides a thin specimen, which is fast-frozen by plunging into liquid nitrogen. This frozen sandwich (Fig. 1) is mounted in a cooling holder and viewed in TEM.Though extremely promising for visualization of liquid microstructures, this double-film technique suffers from a) ireproducibility and nonuniformity of sample thickness, b) low yield of imageable grid squares and c) nonuniform spatial distribution of particulates, which results in fewer being imaged.

Macroprobe Mode for the Study of Segregation in Steels

1990 ◽  
Vol 48 (2) ◽  
pp. 260-261
Author(s):  
Auclair Gilles ◽  
Benoit Danièle
Keyword(s):  
Mechanical Properties ◽  
Spatial Distribution ◽  
High Performance ◽  
Volume Fraction ◽  
Sheet Steel ◽  
Acquisition Time ◽  
Chemical Information ◽  
X Ray ◽  
Accurate Quantitative Analysis ◽  
Optical Micrographs

During these last 10 years, high performance correction procedures have been developed for classical EPMA, and it is nowadays possible to obtain accurate quantitative analysis even for soft X-ray radiations. It is also possible to perform EPMA by adapting this accurate quantitative procedures to unusual applications such as the measurement of the segregation on wide areas in as-cast and sheet steel products.The main objection for analysis of segregation in steel by means of a line-scan mode is that it requires a very heavy sampling plan to make sure that the most significant points are analyzed. Moreover only local chemical information is obtained whereas mechanical properties are also dependant on the volume fraction and the spatial distribution of highly segregated zones. For these reasons we have chosen to systematically acquire X-ray calibrated mappings which give pictures similar to optical micrographs. Although mapping requires lengthy acquisition time there is a corresponding increase in the information given by image anlysis.

Ultrastructural analysis of the spatial distribution of MRNA

1992 ◽  
Vol 50 (1) ◽  
pp. 552-553
Author(s):  
Gary Bassell ◽  
Robert H. Singer
Keyword(s):  
Electron Microscopy ◽  
Spatial Distribution ◽  
In Situ Hybridization ◽  
High Resolution ◽  
Nucleic Acids ◽  
Colloidal Gold ◽  
Dna Probe ◽  
Nucleotide Analogs ◽  
Gold Particles

We have been investigating the spatial distribution of nucleic acids intracellularly using in situ hybridization. The use of non-isotopic nucleotide analogs incorporated into the DNA probe allows the detection of the probe at its site of hybridization within the cell. This approach therefore is compatible with the high resolution available by electron microscopy. Biotinated or digoxigenated probe can be detected by antibodies conjugated to colloidal gold. Because mRNA serves as a template for the probe fragments, the colloidal gold particles are detected as arrays which allow it to be unequivocally distinguished from background.

Membrane microdomains: lessons from microscopy

1995 ◽  
Vol 53 ◽  
pp. 776-777
Author(s):  
J.M. Robinson ◽  
J.M Oliver
Keyword(s):  
Spatial Distribution ◽  
Plasma Membrane ◽  
Epithelial Cells ◽  
Plasma Membranes ◽  
Cell Types ◽  
Imaging Modalities ◽  
Membrane Microdomains ◽  
Membrane Domains ◽  
Lateral Heterogeneity ◽  
Functional Importance

Specialized regions of plasma membranes displaying lateral heterogeneity are the focus of this Symposium. Specialized membrane domains are known for certain cell types such as differentiated epithelial cells where lateral heterogeneity in lipids and proteins exists between the apical and basolateral portions of the plasma membrane. Lateral heterogeneity and the presence of microdomains in membranes that are uniform in appearance have been more difficult to establish. Nonetheless a number of studies have provided evidence for membrane microdomains and indicated a functional importance for these structures.This symposium will focus on the use of various imaging modalities and related approaches to define membrane microdomains in a number of cell types. The importance of existing as well as emerging imaging technologies for use in the elucidation of membrane microdomains will be highlighted. The organization of membrane microdomains in terms of dimensions and spatial distribution is of considerable interest and will be addressed in this Symposium.

An analytical microscopic study of metals in fluidized catalytic cracking catalyst

1986 ◽  
Vol 44 ◽  
pp. 854-855
Author(s):  
Clifford S. Rainey
Keyword(s):  
Electron Microscopy ◽  
Spatial Distribution ◽  
Catalytic Cracking ◽  
Catalyst Deactivation ◽  
Coke Formation ◽  
Acid Sites ◽  
Y Zeolite ◽  
Fcc Catalyst ◽  
Fluidized Catalytic Cracking ◽  
High Regeneration

The spatial distribution of V and Ni deposited within fluidized catalytic cracking (FCC) catalyst is studied because these metals contribute to catalyst deactivation. Y zeolite in FCC microspheres are high SiO2 aluminosilicates with molecular-sized channels that contain a mixture of lanthanoids. They must withstand high regeneration temperatures and retain acid sites needed for cracking of hydrocarbons, a process essential for efficient gasoline production. Zeolite in combination with V to form vanadates, or less diffusion in the channels due to coke formation, may deactivate catalyst. Other factors such as metal "skins", microsphere sintering, and attrition may also be involved. SEM of FCC fracture surfaces, AEM of Y zeolite, and electron microscopy of this work are developed to better understand and minimize catalyst deactivation.

Sign in / Sign up

Export Citation Format

Share Document