scholarly journals Review of scenario selection approaches for performance assessment of high-level waste repositories and related issues.

10.2172/97163 ◽  
1995 ◽  
Author(s):  
E.J. Banano ◽  
R.G. Baca
Keyword(s):  
Performance Assessment ◽  
High Level Waste ◽  
High Level ◽  
Waste Repositories

scholarly journals Spent Fuel as a Waste Form - Data Needs to Allow Long Term Performance Assessment Under Repository Disposal Conditions.

1986 ◽  
Vol 84 ◽  
Author(s):  
V. M. Oversby
Keyword(s):  
Performance Assessment ◽  
Waste Form ◽  
High Level Waste ◽  
Detailed Knowledge ◽  
Spent Fuel ◽  
Expected Performance ◽  
High Level ◽  
Term Performance ◽  
Physical And Chemical ◽  
Waste Repositories

AbstractPerformance assessment calculations are required for high level waste repositories for a period of 10,000 years under NRC and EPA regulations. In addition, the Siting Guidelines (IOCFR960) require a comparison of sites following site characterization and prior to final site selection to be made over a 100,000 year period. In order to perform the required calculations, a detailed knowledge of the physical and chemical processes that affect waste form performance will be needed for each site. While bounding calculations might be sufficient to show compliance with the requirements of IOCFR60 and 40CFRI91, the site comparison for 100,000 years will need to be based on expected performance under site specific conditions. The only case where detailed knowledge of waste form characteristics in the repository would not be needed would be where radionuclide travel times to the accessible environment can be shown to exceed 100,000 years. This paper will review the factors that affect the release of radionuclides from spemt fuel under repository conditions, summarize our present state of knowledge, and suggest areas where more work is needed in order to support the performance assessment calculations.

Performance assessment of the disposal of vitrified high-level waste in a clay layer

2001 ◽  
Vol 298 (1-2) ◽  
pp. 125-135 ◽  
Author(s):  
Dirk Mallants ◽  
Jan Marivoet ◽  
Xavier Sillen
Keyword(s):  
Performance Assessment ◽  
High Level Waste ◽  
Clay Layer ◽  
High Level

Performance Assessment of a High-Level-Waste Repository in Clay

1988 ◽  
Vol 127 ◽  
Author(s):  
Jan L. Marivoet ◽  
Geert Volckaert ◽  
Arnold A. Bonne
Keyword(s):  
Performance Assessment ◽  
Maximum Dose ◽  
High Level Waste ◽  
Clay Layer ◽  
Geological Disposal ◽  
Dose Rates ◽  
Consequence Analysis ◽  
Calculated Dose ◽  
Order Of Magnitude ◽  
High Level

ABSTRACTPerformance assessment studies have been undertaken on the geological disposal of high-level waste in a clay layer in the framework of the CEC project PAGIS. The methodology applied consists of two consecutive steps : a scenario and a consequence analysis. The scenario analysis has indicated that scenarios of normal evolution, of human intrusion, of climatic change, of secondary glaciation effects and of faulting should be evaluated. For the consequence analysis as well deterministic “best estimate” as stochastic calculations, including uncertainty, risk and sensitivity analyses, have been elaborated.The calculations performed show that most radionuclides decay to negligible levels within the first fewjneters of the clay barrier. Just a few radionuclides, 99Tc, 135Cs and 237Np with its daughter nuclides 233U and 229Th can eventually reach the biosphere. The maximum dose rates arising from the geological disposal of HLW, as evaluated by the “best-estimate” approach are about 10−11 Sv/y for river pathways. If the sinking of a water well into the 150 m deep aquifer layer in the vicinity of the repository is considered together with a climatic change, the maximum calculated dose rate rises to a value of 3×10−7 Sv/y. The maximum dose rates evaluated by stochastic calculations are about one order of magnitude higher due to the considerable uncertainties in the model parameters. In the case of the Boom clay the estimated consequences of a fault scenario are of the same order of magnitude as the results obtained for the normal evolution scenario. The maximum risk is estimated from the results obtained through stochastic calculations to be about 5×10−8 per year. The sensitivity analysis has shown that the effective thickness of the clay layer, the retention factors of Tc, Cs and Np, and the Darcy velocity in the aquifer are parameters which strongly influence the calculated dose rates.

Assessment of Redox Conditions in the Near Field of Nuclear Waste Repositories: Application to the Swiss high-level and intermediate level waste disposal concept

2003 ◽  
Vol 807 ◽  
Author(s):  
Paul Wersin ◽  
Lawrence H. Johnson ◽  
Bernhard Schwyn
Keyword(s):  
Solid Phase ◽  
Near Field ◽  
Intermediate Level ◽  
Redox Conditions ◽  
High Level Waste ◽  
Redox Potentials ◽  
Spent Fuel ◽  
Reducing Conditions ◽  
High Level ◽  
Waste Repositories

ABSTRACTRedox conditions were assessed for a spent fuel and high-level waste (SF/HLW) and an intermediate-level waste (ILW) repository. For both cases our analysis indicates permanently reducing conditions after a relatively short oxic period. The canister-bentonite near field in the HLW case displays a high redox buffering capacity because of expected high activity of dissolved and surface-bound Fe(II). This is contrary to the cementitious near field in the ILW case where concentrations of dissolved reduced species are low and redox reactions occur primarily via solid phase transformation processes.For the bentonite-canister near field, redox potentials of about -100 to -300 mV (SHE) are estimated, which is supported by recent kinetic data on U, Tc and Se interaction with reduced iron systems. For the cementitious near field, redox potentials of about -200 to -800 mV are estimated, which reflects the large uncertainties related to this alkaline environment.

Near Field Radionuclide Concentrations: Sorption or Solubility Constrained?

2001 ◽  
Author(s):  
Bernhard Kienzler ◽  
Peter Vejmelka ◽  
Volker Metz
Keyword(s):  
Portland Cement ◽  
Performance Assessment ◽  
Geochemical Modeling ◽  
Coal Fly Ash ◽  
Near Field ◽  
High Level Waste ◽  
Sorption Behavior ◽  
Geochemical Environment ◽  
Backfill Materials ◽  
High Level

Abstract The amount of mobile radionuclides is controlled by the geochemical isolation potential of the repository. Many investigations are available in order to determine the maximal radionuclide concentrations released from different waste forms of specific disposal strategies for disposal in rock salt formations. These investigations result in reaction (dissolution) rates, maximum concentrations, and sorption coefficients. The experimental data have to be applied to various disposal strategies. The case studies presented in this communication cover the selection, the volumes, and the composition of backfill materials used as sorbents for radionuclides. As an example, for brown coal fly ash (BFA) - Q-brine systems, sorption coefficients were measured as well as solublilities of several actinides and other long-lived radionuclides. Dissolved CO32− was buffered to negligible concentration by the presence of high amount of Mg in solution. In the sorption experiments Pu, Th, Np, and U concentrations close or below detection limit were obtained. Concentrations in the same ranges are computed by means of geochemical modeling, if precipitation of “simple” tetravalent hydroxides (An(OH)4(am) phases) is assumed. In the case of U in a Portland cement dominated geochemical environment, measured U(VI) concentration corresponds to the solubility of hexavalent solids, such as Na2U2O7. A similar behavior of U was observed in high-level waste glass experiments. Experiments investigating sorption behavior of corroded cement showed that in the case of application of a sufficient large inventory of actinides, measured concentrations were found to be independent of the inventory. In this case, measured concentrations were controlled by solid phases. If smaller actinide inventories were applied, resulting concentrations were found to be below concentrations constrained by well-known solids. Here, a more or less pronounced sorption of the radioactive elements was observed. The radionuclide concentrations determined in the BFA “sorption” experiments are found to be close to the detection limits. For this reason, it is not possible to extrapolate the radionuclide behavior to lower concentrations. We cannot distinguish, if sorption or precipitation controls measured radionuclide concentrations. However, in the presence of reducing materials such as BFA, solubilities of tetravalent actinides and of Tc(IV) represent a realistic estimation of the maximal element concentrations needed in performance assessment studies. The concentrations of these redox sensitive elements are controlled by precipitation of An(OH)4(am) phases for disposal concepts considered in German salt formations. Under this assumption, quantities such as solid-solution ratios used in (sorption) experiments do not affect the mobilization of the radionuclides. Additional conclusions can be drawn from comparison of the findings for the redox sensitive elements in the BFA / portland cement brine systems: We can assume that expected actinide and technetium concentrations in the near-field of radioactive wastes are affected by the total inventory of radionuclides in the disposal room. Sorption will be relevant, if the total dissolved radionuclide concentration remains below the maximal solubility defined by the solid radionuclide phase which is stable in the geochemical environment. In contrast to the portland cement system, the relevant radionuclide phase are most probably tetravalent hydroxides in the BFA systems. These conclusions are of high importance to performance assessment for the radioactive waste repository systems, because they restrict the applicability of sorption models in the near field of the waste.

Optimal mixing scheme for graphite–bentonite mixtures used as buffer materials in high-level waste repositories

2021 ◽  
Vol 80 (17) ◽  
Author(s):  
Yun-zhi Tan ◽  
Zi-yang Xie ◽  
Fan Peng ◽  
Fang-hong Qian ◽  
Hua-jun Ming
Keyword(s):  
High Level Waste ◽  
High Level ◽  
Waste Repositories ◽  
Optimal Mixing

scholarly journals Is it Possible to Demonstrate Compliance with the Regulations for High-Level-Waste Repositories?

1992 ◽  
Vol 294 ◽  
Author(s):  
Felton W. Bingham
Keyword(s):  
Numerical Modeling ◽  
Data Collection ◽  
Performance Assessments ◽  
High Level Waste ◽  
Spent Fuel ◽  
Distant Future ◽  
Site Investigations ◽  
High Level ◽  
Waste Repositories ◽  
Shed Light

ABSTRACTThe regulations that currently govern repositories for spent fuel and high-level waste require demonstrations that are sometimes described as impossible to make. To make them will require an understanding of the current and the future phenomena at repository sites; it will also require credible estimates of the probabilities that the phenomena will occur in the distant future. Experts in many fields—earth sciences, statistics, numerical modeling, and the law—have questioned whether any amount of data collection can allow modelers to meet these requirements with enough confidence to satisfy the regulators. In recent years some performance assessments have begun to shed light on this question because they use results of actual site investigations. Although these studies do not settle the question definitively, a review of a recent totalsystem assessment suggests that compliance may be possible to demonstrate. The review also suggests, however, that the demonstration can be only at the “reasonable” levels of assurance mentioned, but not defined, in the regulations.

scholarly journals Site suitability criteria for solidified high level waste repositories

1979 ◽  
Author(s):  
R.A. Heckman ◽  
T. Holdsworth ◽  
D. Isherwood ◽  
D.F. Towse ◽  
N.L. Dayem
Keyword(s):  
High Level Waste ◽  
Site Suitability ◽  
High Level ◽  
Waste Repositories
Sign in / Sign up

Export Citation Format

Share Document