scholarly journals Spatially-Dependent Measurements of Surface and Near-Surface Radioactive Material Using In situ Gamma Ray Spectrometry (ISGRS) For Final Status Surveys

2006 ◽  
Author(s):  
J. A. Chapman, A. J. Boerner, E. W. Abelquist
2019 ◽  
Vol 21 ◽  
pp. 29
Author(s):  
E. G. Androulakaki ◽  
C. Tsabaris ◽  
M. Kokkoris ◽  
G. Eleftheriou ◽  
D. L. Patiris ◽  
...  

The in-situ gamma-ray spectrometry is a well suited method for seabed mapping applications, since it provides rapid results in a cost effective manner. Moreover, the in-situ method is preferable to the commonly applied laboratory measurements, due to its beneficial characteristics. Therefore, the development of in-situ systems for seabed measurements continuously grows. However, an efficiency calibration of the detection system is necessary for obtaining quantitative results in the full spectral range. In the present work, an approach for calculating the full-energy peak efficiency of an underwater insitu spectrometer for measure- ments on the seabed is presented. The experimental work was performed at the coastal site of Vasilikos (Cyprus). The experimental full-energy peak efficiency of the in-situ was determined in the energy range 1400–2600 keV, by combining the in-situ and laboratory reference measurements. The experimental effi- ciency results were theoretically reproduced by means of Monte Carlo (MC) simulations, using the MCNP5 code.


2020 ◽  
Vol 13 ◽  
pp. 262
Author(s):  
K. L. Karfopoulos ◽  
G. N. Papadakos ◽  
D. J. Karangelos ◽  
P. K. Rouni ◽  
N. P. Petropoulos ◽  
...  

It is estimated that until 1978 about 200000 lightning conductor rods with -a emitting sources attached to their end were installed worldwide. The sources were supposed to increase the lighting collection efficiency of these rods through the ionization of the surrounding air. Nevertheless, this improvement has never been established conclusively. Such devices are, in most cases, not accessible by the pub- lic; therefore, the dose to the population is considered insignificant. However, the possibility of radioactive material leakage, due to the source attachment failure, and the subsequent contamination of the surroundings that could lead to possible health risk of the public cannot be excluded. In this work, the case of 241Am contamination due to a lightning rod conductor failure is investigated. This contamination was accidentally detected on the surface soil around a laboratory building in the National Technical University of Athens Campus, during a routine in-situ gamma-ray measurement campaign that took place in 2003. A detailed survey revealed that this 241Am contamination was due to the leakage from two lightning rods on the building roof. Consequently the rods were removed from the building and the contamination pattern on the roof and on the surface soil around the building was examined in detail. From the results obtained so far it may be concluded that there exists well localized contamination on the roof and also around the building. It was established that the pathway through which contamination reached the ground was  the rainwater drainage system of the building. The gamma ray dose rate due to 241Am contamination found on the roof and on the surface soil is low compared to that due to its natural radioactivity and does not seem to pose any health risk to the people working in the building or to the public.


2020 ◽  
Author(s):  
Jan Kisiel ◽  
Kinga Polaczek-Grelik ◽  
Katarzyna Szkliniarz ◽  
Agata Walencik-Łata ◽  
Jari Joutsenvaara ◽  
...  

<p>The BSUIN (Baltic Sea Underground Innovation Network) aims to enhance the accessibility of the underground laboratories in the Baltic Sea region for innovation, business and science. One of the BSUIN project activities is characterization of natural background radiation (NBR) in underground facilities. In this talk results from NBR measurements performed in Callio Lab, Pyhäsalmi, Finland, at the depth of 4100 m w.e. will be presented. The in-situ gamma spectra were collected with the use of  HPGe semiconductor spectrometer, whereas the  concentration of radon were measured with RAD7 electronic detector. In addition, the water and rock samples were taken for laboratory analysis in Institute of Physics, University of Silesia, Poland. The concentration radioisotopes in water samples were performed by using a liquid scintillation α/β counter (LSC) and α-particle spectrometry, while the concentration of radioisotopes in rock samples were performed by using laboratory gamma ray spectrometry and also α-particle spectrometry.</p>


2017 ◽  
Vol 429 ◽  
pp. 108-118 ◽  
Author(s):  
Mohsen Hosseinalizadeh ◽  
Hassan Ahmadi ◽  
Sadat Feiznia ◽  
Firoozeh Rivaz ◽  
Sadegh Naseri

Sign in / Sign up

Export Citation Format

Share Document