scholarly journals Downhole Measurements of Shear- and Compression-Wave Velocities in Boreholes C4993, C4996, C4997 and C4998 at the Waste Treatment Plant DOE Hanford Site.

2007 ◽  
Author(s):  
Bruce B. Redpath
Keyword(s):  
Compression Wave ◽  
Waste Treatment ◽  
Treatment Plant ◽  
Hanford Site ◽  
Wave Velocities ◽  
Waste Treatment Plant ◽  
Downhole Measurements

Application of Optical and Imaging Techniques to Inspection of Off-Line Joule-Heated Melter at the West Valley Demonstration Project

2003 ◽  
Author(s):  
M. John Plodinec ◽  
Ping-Rey Jang ◽  
Zhiling Long ◽  
David L. Monts ◽  
Walter P. Okhuysen ◽  
...  
Keyword(s):  
Waste Treatment ◽  
Imaging Techniques ◽  
Treatment Plant ◽  
Quantitative Information ◽  
Demonstration Project ◽  
Hanford Site ◽  
The West ◽  
Refractory Wear ◽  
Waste Treatment Plant ◽  
Crucial Information

The West Valley melter has been taken out of service. Its design is the direct ancestor of the current melter design for the Hanford Waste Treatment Plant. Over its eight years of service, the West Valley melter has endured many of the same challenges that the Hanford melters will encounter with feeds that are similar to many of the Hanford double shell tank wastes. Thus, inspection of the West Valley melter prior to its disposal could provide valuable — even crucial — information to the designers of the melters to be used at the Hanford Site, particularly if quantitative information can be obtained. The objective of Mississippi State University’s Diagnostic Instrumentation and Analysis Laboratory’s (DIAL) efforts is to develop, fabricate, and deploy inspection tools for the West Valley melter that will (i.) be remotely operable in the West Valley process cell; (ii.) provide quantitative information on melter refractory wear and deposits on the refractory; and (iii.) indicate areas of heterogeneity of deposits, requiring more detailed characterization. A collaborative arrangement has been established with the West Valley Demonstration Project (WVDP) to inspect their melter.

Evaluating Risk After a Hazardous Waste Treatment Plant Released Persistent Organic Pollutants: Part 3, Aboriginal Health Risk and Impact

2018 ◽  
Vol 2 (1) ◽  
pp. 1-7 ◽  
Author(s):  
Tee L. Guidotti
Keyword(s):  
Health Risk ◽  
Organic Pollutants ◽  
Persistent Organic Pollutants ◽  
Waste Treatment ◽  
Treatment Plant ◽  
Aboriginal Health ◽  
Treatment Center ◽  
Hazardous Waste Treatment ◽  
Waste Treatment Plant ◽  
Health Canada

On 16 October 1996, a malfunction at the Swan Hills Special Waste Treatment Center (SHSWTC) in Alberta, Canada, released an undetermined quantity of persistent organic pollutants (POPs) into the atmosphere, including polychlorinated biphenyls, dioxins, and furans. The circumstances of exposure are detailed in Part 1, Background and Policy Issues. An ecologically based, staged health risk assessment was conducted in two parts with two levels of government as sponsors. The first, called the Swan Hills Study, is described in Part 2. A subsequent evaluation, described here in Part 3, was undertaken by Health Canada and focused exclusively on Aboriginal residents in three communities living near the lake, downwind, and downstream of the SHSWTC of the area. It was designed to isolate effects on members living a more traditional Aboriginal lifestyle. Aboriginal communities place great cultural emphasis on access to traditional lands and derive both cultural and health benefits from “country foods” such as venison (deer meat) and local fish. The suspicion of contamination of traditional lands and the food supply made risk management exceptionally difficult in this situation. The conclusion of both the Swan Hills and Lesser Slave Lake studies was that although POPs had entered the ecosystem, no effect could be demonstrated on human exposure or health outcome attributable to the incident. However, the value of this case study is in the detail of the process, not the ultimate dimensions of risk. The findings of the Lesser Slave Lake Study have not been published previously and are incomplete.

The Impact of a Chemostat Discharge Containing Oil Degrading Bacteria on the Biological Kinetics of a Refinery Activated Sludge Process

1988 ◽  
Vol 20 (11-12) ◽  
pp. 131-136 ◽  
Author(s):  
A. D. Wong ◽  
C. D. Goldsmith
Keyword(s):  
Activated Sludge ◽  
Retention Time ◽  
Waste Treatment ◽  
Treatment Plant ◽  
Utilization Rate ◽  
Activated Sludge Process ◽  
Kinetic Evaluation ◽  
Degrading Bacteria ◽  
Waste Treatment Plant ◽  
The Impact

The effect of discharging specific oil degrading bacteria from a chemostat to a refinery activated sludge process was determined biokinetically. Plant data for the kinetic evaluation of the waste treatment plant was collected before and during treatment. During treatment, the 500 gallon chemostatic growth chamber was operated on an eight hour hydraulic retention time, at a neutral pH, and was fed a mixture of refinery wastewater and simple sugars. The biokinetic constants k (days−1), Ks (mg/L), and K (L/mg-day) were determined before and after treatment by Monod and Lineweaver-Burk plots. Solids discharged and effluent organic concentrations were also evaluated against the mean cell retention time (MCRT). The maximum utilization rate, k, was found to increase from 0.47 to 0.95 days−1 during the operation of the chemostat. Subsequently, Ks increased from 141 to 556 mg/L. Effluent solids were shown to increase slightly with treatment. However, this was acceptable due to the polishing pond and the benefit of increased ability to accept shock loads of oily wastewater. The reason for the increased suspended solids in the effluent was most likely due to the continual addition of bacteria in exponential growth that were capable of responding to excess substrate. The effect of the chemostatic addition of specific microbial inocula to the refinery waste treatment plant has been to improve the overall organic removal capacity along with subsequent gains in plant stability.

A Centralized Hazardous Waste Treatment Plant: The Facilities of the Zvsmm at Schwabach as an Example

1994 ◽  
Vol 29 (8) ◽  
pp. 235-250 ◽  
Author(s):  
Norbert Amsoneit
Keyword(s):  
Hazardous Waste ◽  
Waste Treatment ◽  
Treatment Plant ◽  
Waste Incinerator ◽  
Physical Plant ◽  
Treatment Centre ◽  
Hazardous Waste Treatment ◽  
Waste Treatment Plant ◽  
Pre Treatment ◽  
Inorganic Waste

As a rule, hazardous waste needs a pre-treatment, either a thermal or a chemical-physical one, before it can be disposed of at a landfill. The concentration of different kinds of treatment facilities at a Centralized Hazardous Waste Treatment Plant is advantageous. The facility of the ZVSMM at Schwabach is presented as an outstanding example of this kind of Treatment Centre. The infrastructure, the chemical-physical plant with separate lines for the treatment of organic and inorganic waste and the hazardous waste incinerator are described. Their functions are discussed in detail. Emphasis is laid on handling the residues produced by the different treatment processes and the final disposal.

Sign in / Sign up

Export Citation Format

Share Document